TITLE CERTIFICATION REQUIREMENTS - FOREIGN CERTIFICATION PLACARD INSTALLATION EFFECTIVITY MODEL UNIT NUMBERS 550-1040 NOTE: This Service Bulletin may only be accomplished at a Cessna-owned or an authorized Citation Service Center. REASON To comply with foreign certification requirements. DESCRIPTION This service bulletin provides parts and instructions to install Czechoslovakian placards. COMPLIANCE OPTIONAL. This service bulletin may be accomplished at the discretion of the owner. A service bulletin published by Cessna Aircraft Company may be recorded as completed in an aircraft log only when the following requirements are satisfied: 1) The mechanic must complete all of the instructions in the service bulletin, including the intent therein. 2) The mechanic must correctly use and install all applicable parts supplied with the service bulletin kit. Only with written authorization from Cessna Aircraft Company can substitute parts or rebuilt parts be used to replace new parts. 3) The mechanic or airplane owner must use the technical data in the service bulletin only as approved and published. 4) The mechanic or airplane owner must apply the information in the service bulletin only to aircraft serial numbers identified in the Effectivity section of the bulletin. 5) The mechanic or airplane owner must use maintenance practices that are identified as acceptable standard practices in the aviation industry and governmental regulations. No individual or corporate organization other than Cessna Aircraft Company is authorized to make or apply any changes to a Cessna-issued service bulletin, service letter, or flight manual supplement without prior written consent from Cessna Aircraft Company. Cessna Aircraft Company is not responsible for the quality of maintenance performed to comply with this document, unless the maintenance is accomplished at a Cessna-owned Citation Service Center. FLIGHT CREW OPERATIONS No Change. Page 1 of 4 Cessna Aircraft Company, Citation Marketing Division, P.O. Box 7706, Wichita, KS 67277, U.S.A. 1-316-517-6000, Fax 1-316-517-8500 COPYRIGHT 2004
APPROVAL FAA approval has been obtained on technical data in this publication that affects airplane type design. This information shall be considered an amendment to the Cessna Manufacturer s Maintenance Manual. MANPOWER MATERIAL - Cost and Availability WORK PHASE MAN-HOURS Modification * PART NUMBER AVAILABILITY COST * * * Refer to the attached Service Bulletin Supplemental Data sheet for man-hours, material cost and availability, and warranty information. CONSUMABLE MATERIAL In addition to the above kit(s), the following materials, or equivalent, are required for the accomplishment of this service bulletin. NAME NUMBER MANUFACTURER USE Clear Polyurethane Top Coat 830080 Sherwin Williams 630 East 13th Street Andover, KS 67002 To edge seal the exterior placards. CHANGE IN WEIGHT AND BALANCE Negligible REFERENCES The engineering drawing that follows must obtained to complete this service bulletin. The latest revision and all applicable DCN s for each document must be used. DOCUMENT NUMBER TITLE 4811151 Informational Markings Instl. - Czech Rep. 550-1040 PUBLICATIONS AFFECTED Cessna Model 550 Citation Bravo Illustrated Parts Catalog ACCOMPLISHMENT INSTRUCTIONS 1. Prepare the airplane for maintenance. A. Make sure that all switches are in the OFF/NORM position. B. Disconnect electrical power from the airplane. (1) Disconnect the airplane battery. (2) Disconnect external electrical power. C. Attach maintenance warning tags to the battery and external power receptacle that have "DO NOT CONNECT ELECTRICAL POWER - MAINTENANCE IN PROGRESS" written on them. Page 2
2. Remove the placards, decals and photos as necessary. 3. Install the placards, decals and photos. (Refer to Cessna Engineering Drawing 4811151.) 4. Edge seal the exterior placards as necessary with clear polyurethane top coat. 5. Remove the warning tags and connect the battery. 6. Record that this service bulletin has been completed. A. Complete a Maintenance Transaction Report. B. Put a copy of the completed Maintenance Transaction Report in the airplane logbook. C. Send a copy of the completed Maintenance Transaction Report to: CESCOM, PO Box 7706, Wichita, KS 67277. MATERIAL INFORMATION NOTE: The parts included in this service bulletin cover installation for one airplane. NEW P/N QUAN- TITY KEY WORD OLD P/N INSTRUCTIONS/ DISPOSITION 1 Kit, consisting of the following parts: MS21069L04 3 Nutplate MS24693S26 5 Screw MS24693S27 6 Screw MS27130-S1K 12 Nut MS27130-S1K Discard MS35214-14 16 Screw MS35214-14 Discard NAS1832A06-3 1 Insert S1021A4-4 4 Screw S1022A4 Discard 4811557-24 6 Plate Assembly 6519695-1 1 Photo - Max Baggage 4811622-20 Discard 6519695-3 1 Decal - Cabin Door 5501001-72 Discard 6519695-6 1 Decal - Cabin Door 5501001-73 Discard 6519695-9 1 Decal - Cabin Door 5501001-74 Discard 6519695-11 1 Photo - Tail Max 6512002-67 Discard 6519695-12 1 Photo - Tail Max 6512002-68 Discard 6519695-13 1 Photo - Tail Max 6512002-69 Discard 6519695-14 1 Photo - Ski Tube 4819304-10 Discard 6519695-15 1 Decal - Emergency Exit 5501001-75 Discard 6519695-18 1 Decal - Emergency Exit 5501001-76 Discard 6519695-20 1 Placard - Curtain 4819328-11 Discard 6519695-23 2 Placard - Cabinet Instructions 4811478-14 Discard Page 3
NEW P/N QUAN- TITY KEY WORD OLD P/N INSTRUCTIONS/ DISPOSITION 6519695-27 1 Photo - Door Catch 4819328-8 Discard 6519695-28 1 Decal - Cabin Door 4819328-7 Discard 6519695-30 1 Decal - Cabin Door 6519695-33 2 Placard - Exit 6519695-37 1 Decal - Escape Hatch 4819328-3 Discard 6519695-39 1 Decal - Escape Hatch 4819328-2 Discard 6519695-48 1 Placard - Coat Rod 4811623-14 Discard 6519695-55 1 Placard - Aft Compartment 4819328-16 Discard 6519695-64 1 Mounting Plate 6519695-81 2 Mounting Plate 6519695-82 1 Mounting Plate 6519695-93 9 Placard - Seat Instructions Install over the 6519695-95 2 Placard - Seat Instructions Install over the 6519695-97 2 Placard - Trash Container Install over the 6519695-100 2 Placard - Seat Position Install over the 6519695-103 7 Placard - Life Vest Install over the 6519695-106 4 Placard - Executive Table Install over the 6519695-109 4 Placard - Sliding Door Install over the 6519695-112 1 Placard - Life Vest Only Install over the 6519695-115 4 Placard - No Smoking in Lavatory 1 Instructions Install over the Page 4
TITLE SUPPLEMENTAL DATA CERTIFICATION REQUIREMENTS - FOREIGN CERTIFICATION PLACARD INSTALLATION EFFECTIVITY MODEL UNIT NUMBERS 550-1040 MANPOWER WORK PHASE Modification MAN-HOURS As Required MATERIAL - Cost and Availability PART NUMBER AVAILABILITY COST * * * Please contact Citation Parts Distribution for current cost and availability of parts listed in this service bulletin. Phone at 1-800-835-4000 (Domestic) or 1-316-517-7542 (International). Send Email to: citationparts@cessna.textron.com or telefax at 1-316-517-7711. Based on availability and lead times, parts may require advanced scheduling. In cases where the required part(s) are available as exchange, order the exchange part and, upon completion, expedite the return of the removed core to avoid return penalties. Contact the Citation Parts Distribution Sales Desk for availability of exchange parts. Page 1 of 1 Cessna Aircraft Company, Citation Marketing Division, P.O. Box 7706, Wichita, KS 67277, U.S.A. 1-316-517-6000, Fax 1-316-517-8500 COPYRIGHT 2004