Form No. 0495 SPX Corporation 55 th Street Rockford, IL 09-399 USA Internet Address: http://www.hytec.com Tech. Services: (00) 4-3 Fax: (00) 5-3 Order Entry: (00) 54-4 Fax: (00) -03 Parts List for: 009 009-30 MODEL B ELECTRIC HYDRAULIC PUMP TOP VIEW Pressure Regulator Assembly See back pg. of 5 3 Motor Control Assembly See pgs. 4 of 5 & 5 of 5 RUN JOG 0 9 5 3, 4 Sheet No. of 5 Litho in USA Rev. 3 Date: 0 April 00
Parts List, Form No. 0495, Back sheet of 5 Item Part No. No. No. Req'd Description *30450 Warning Decal 0999 0 Self Tapping Screw (Torque to 50/0 in. lbs.) 3 093 Filler/Vent Plug 4 0045 O-ring (Square Section) 5 404 Cover Plate 5 Cap Screw (/4-0 x 5/ Lg.; Torque to 0/0 in. lbs.) 045 Lockwasher 099 Hex Nut (/4-0) 9 449 Handle 0 0030 Cap Screw (/4-0 x / Lg.; Torque to 0/40 in. lbs.) 94 Gauge 039 Decal (CSA approval) 3 4009 Manifold Body Part numbers marked with an asterisk (*) are contained in Repair Kit No. 300430. PRESSURE REGULATOR ASSEMBLY 3 4 5 Item Part No. No. No. Req'd Description 3 Adjusting Screw 03 Locknut (3/-4) 3 305 Valve Cap 4 30 Spring Guide 5 0 O-ring (/ x 3/ x /) 0495 Compression Spring 3 Pressure Regulator Body 04 Poppet Refer to any operating instructions included with this product for detailed information about operation, testing, disassembly, reassembly, and preventive maintenance. Items found in this parts list have been carefully tested and selected. Therefore: Use only genuine Hytec replacement parts! Additional questions can be directed to our Technical Services Department.
< < Parts List Form No. 0495 SIDE VIEW 35 3 33 34 35 3 5 4 3 30 9 0 3 3 4 9 0 3 4 5 9.00.00 CLEARANCE REQUIRED Sheet No. of 5 Rev. 3 Date: 0 April 00
Parts List, Form No. 0495, Back sheet of 5 Item Part No. No. No. Req'd Description 59WH Electric Motor *404 Gasket 3 099 Retaining Ring 4 0905 Bearing 059 Set Screw (/4-0 x 3/ Lg.; Torque to 0/0 in. lbs.) 03 Set Screw (/4-0 x /4 Lg.; Torque to 0/0 in. lbs.) 093 Slotted Spring Pin (3/ O.D. x -/4 Lg.) NOTE: Locate slot as shown in detail. 9 4559 Eccentric 0 595 Washer *30430 Oil Seal 099 Hex Nut (/4-0) 3 0 Upper Gerotor Housing 4 9 Lower Gerotor Housing 5 *09 O-ring (-/ x -5/ x 3/3) 304 Gerotor Set 0994 Pin 4 Filter Support 9 30435 Drive Shaft 0 0009 Drain Tube 5 Reservoir 00 4 Cap Screw (/4-0 x -/ Lg.; Torque to 0/00 in. lbs.) 3-50 Relief Valve (Set at 5,00/5,00 PSI) 4 *0 O-ring (3/ x /4 x /) 5 0995 Outlet Ball Stop *0 O-ring (/ x 3/ x /) *3 Backup Washer *3049 Gasket 9 0505 Bushing 30 09945 Soc. Hd. Cap Screw (5/- UNC x -/ Lg.; Torque to 0/40 in. lbs.) 3 0 Tee Fitting 3 04 Pipe Plug (/ NPTF) 33 943 Tee Fitting (Brass) 34 3049 Hose Assembly 35 00 Warning Decal 3 3500 Gasket PARTS INCLUDED BUT NOT SHOWN 30933 Trade Name Decal 00909 Quick Coupler Set Part numbers marked with an asterisk (*) are contained in Repair Kit No. 300430.
Parts List Form No. 0495 BOTTOM VIEW 5 4 3 0 3 4 5 9 3 4 5 9 0 34 0 35 33 3 3 3 30 9 Sheet No. 3 of 5 Rev. 3 Date: 0 April 00
Parts List, Form No. 0495, Back sheet 3 of 5 Item Part No. Item Part No. No. No. Req'd Description No. No. Req'd Description 4440 90 Elbow Fitting 05 4 Washer (3/ x 3/ x /) 3 33 4 Flange Hd. Screw (3/- x " Lg.; Torque to 30/50 in. lbs.) 4 4 Clamp Ring 5 054 Cap Screw (Torque to 0/0 in. lbs.) 0 Filter 54 Bracket 30 Tube Assembly 9 303 Cap Screw (/4-0 x " Lg.; Torque to 40/50 in. lbs.) 0 00 Dowel Pin (/4 O.D. x / Lg.) * Compression Spring 99 Tee Fitting 3 03 Hex Locknut (3/-4) 4 *9 Adjusting Screw (Unloading Relief Valve) 5 90 Elbow Fitting Check Body *044 Copper Washer (3/ x /4 x /3) *3 4 Ball (3/ dia.) 9 *09 Replaceable Seat 0 099 Hollow Lock Screw (/-0; Torque to 0/00 in. lbs.) *03 O-ring (3/ x 5/ x 3/3) *43 O-ring 3 *05 O-ring (5/ x 3/ x /) 4 45559 High Pressure Check Block 5 *0445 Compression Spring 4549 Valve Guide 45 High Pressure Piston Block 3055 High Pressure Piston 9 43 Dowel Pin (3/ O.D. x " Lg.) NOTE: Install with radius end out.. 30 403 Automatic Valve Piston 3 5 Automatic Valve Block 3 *34 Compression Spring 33 *03 O-ring (" x -5/ x 3/) 34 49 Dowel Pin (/ O.D. x 3/4 Lg.) 35 *05 Compression Spring 3 530 Pipe Plug (/ NPTF) Part numbers marked with an asterisk (*) are contained in Repair Kit No. 300430. HYDRAULIC SCHEMATIC
Parts List Form No. 0495 MOTOR CONTROL ASSEMBLY FOR 009 5 V., 0 Hz. For proper motor voltage connection and rotation, see connection information supplied with motor. MTR This view rotated 0 to show wire connections. Power Cord Ground (Must be isolated between nuts and can be at top or bottom of stack.) GRD- 4 5, 4 PB (START) GRD- PB (STOP) TGS 5 NOTE: Serrated lockwasher must be adjacent to metal box. More washers can be used if desired., 3 FU 9 T X X H H H3 H4 0, GROUND 9, 0 GRD- 4 3 ON OFF 5 CONTROL BOX HEX. NUT (METAL SWITCH GUARD) RUN JOG ANTI-ROTATION KEYED WASHER INTERNAL TOOTH LOCK WASHER 3 HEX. NUT Sheet No. 4 of 5 Rev. 3 Date: 0 April 00
Parts List, Form No. 0495, Back sheet 4 of 5 Item Part No. Item Part No. No. No. Req'd Description No. No. Req'd Description 30909 Push Button Switch 30 Toggle Switch 3 350 Decal (RUN - JOG) 4 09 Hex. Nut (#0-4) 5 5 Rd. Hd. Machine Screw (#0-4 x " Lg.) 0 3 Washer (#0 External Tooth) 43WH Motor Control Box Cover 4 4 Pan Hd. Tapping Screw 9 5WH Motor Control Box 0 40-4 Contactor 539 4 Rd. Hd. Machine Screw (#0-4 x /4 Lg.) 059 Decal (Ground) 3 50 Hand Switch (See Form No. 044) 4 5993 Strain Relief Bushing 5 59 Cord Set (4/3 SJT0) 0 Strain Relief 503 Pressure Switch Assembly 55 Strain Relief Bushing 9 353 Pan Hd. Tapping Screw (#-3 x 3/ Lg.) 0 05 Washer 3055 Transformer Fuse Holder 3 09 Fuse (3A) 4 5050 Decal (Fuse warning) 5 0 Conduit Nipple 434 Washer 350 Metal Switch Guard PARTS INCLUDED BUT NOT SHOWN 00 Warning Decal 395 Decal (Intermittent Duty) ELECTRICAL SCHEMATIC FOR 009 5 V., 0 Hz WARNING To help avoid personal injury, all electrical work must be done by a qualified electrician. North American & International Color Codes Conductors North American International Line...Black...Brown Neutral...White...Blue Ground...Green...Green/Yellow L P L M P T4 J9 MTR L3 H H3 H H4 T 4V FU 3A PB STOP X PB START X M JOG M RUN (TGS) SW REMOTE CONTROL PS (N.O. HELD CLOSED) Note: Shaded areas reflect last revision(s) made to this form.
Parts List Form No. 0495 MOTOR CONTROL ASSEMBLY FOR 009-30 30 V., 0 Hz. For proper motor voltage connection and rotation, see connection information supplied with motor. MTR Power Cord Ground (Must be isolated between nuts and can be at top or bottom of stack.) GRD- 4, PB (START) GRD- PB (STOP) This view rotated 0 to show the connections. TGS 5 NOTE: Serrated lockwasher must be adjacent to metal box. More washers can be used if desired. FU 4, 5 9 3 T X X H H H3 H4 0, GROUND 0, 9 GRD- 4 ON OFF 3 CONTROL BOX HEX. NUT 9 (METAL SWITCH GUARD) RUN JOG 3 5 ANTI-ROTATION KEYED WASHER SWITCH DETAIL Sheet No. 5 of 5 INTERNAL TOOTH LOCK WASHER HEX. NUT Rev. 3 Date: 0 April 00
Parts List, Form No. 0495, Back sheet 5 of 5 Item Part No. Item Part No. No. No. Req'd Description No. No. Req'd Description 30909 Push Button Switch 30 Toggle Switch 3 350 Decal (RUN - JOG) 4 09 Hex. Nut (#0-4) 5 5 Rd. Hd. Machine Screw (#0-4 x " Lg.) 0 3 Washer (#0 External Tooth) 43WH Motor Control Box Cover 4 4 Pan Hd. Tapping Screw 9 5WH Motor Control Box 0 40-4 Contactor 0 Machine Screw 059 Decal (Ground) 3 50 Hand Switch (See Form No. 044) 4 5993 Strain Relief Bushing 5 09 Electrical Plug 305 ft. Electrical Cable (4/3 SJT0) 0 Strain Relief 503 Pressure Switch Assembly 9 55 Strain Relief Bushing 0 353 Pan Hd. Tapping Screw (#-3 x 3/ Lg.) 05 Washer 539 Rd. Hd. Machine Screw (#0-4 x /4 Lg.) 3 3055 Transformer 4 Fuse Holder 5 09 Fuse (3A) 5050 Decal (Fuse warning) 0 Conduit Nipple 434 Washer 9 350 Metal Switch Guard PARTS INCLUDED BUT NOT SHOWN 00 Warning Decal 395 Decal (Intermittent Duty) ELECTRICAL SCHEMATIC FOR 009-30 30 V., 0 Hz. WARNING To help avoid personal injury, all electrical work must be done by a qualified electrician. North American & International Color Codes Conductors North American International Line...Black...Brown Neutral...White...Blue Ground...Green...Green/Yellow L P P L M T4 J9 MTR L3 H H3 H H4 T 4V FU 3A PB STOP X PB START X M JOG M RUN (TGS) SW REMOTE CONTROL PS (N.O. HELD CLOSED) Note: Shaded areas reflect last revision(s) made to this form.