BrightGuy.com is an authorized Fenix Distributor Fenix TK65R Fashight 1. Cataput action bet cip 2. Quick-reease button Technica Parameters ANSI/PLATO Genera Mode Fash Mode FL1 Turbo High Med Low Eco Strobe SOS Output 3,200 1,000 400 150 30 3,200 400 Runtime 1h 45min 4h 55min 13h 10min 35h 45min 113h / /
Distance 375m 218m 138m 83m 37m / / Intensity 35,155 11,880 4,760 1,720 340 / / Impact Resistance 1m Waterproof IP68, underwater 2m Note: The abovementioned parameters (ab-tested by Fenix using 7.2V/5000mAh Li-ion battery pack) may vary between fashights, batteries and environments. Cree XHP70 LED with a ifespan of 50,000 hours Buit-in 7.2V/5000mAh Li-ion battery pack Micro USB fast charging with fast charging adaptor Micro USB charging port with inner waterproofing design 270.5mm Length x 61.5mm Head diameter x 36.5mm Body diameter 418g (excuding battery and bet cip) Dedicated cataput action bet cip Digitay reguated output maintains constant brightness Featuring battery eve indication and ow-votage warning function Inteigent overheat protection protects from high surface temperature Made of durabe aircraft-grade auminum; stainess stee strike beze Premium type III hard-anodized anti-abrasive finish Toughened utra-cear gass ens with an anti-refective coating Accessories: 7.2V/5000mAh Li-ion battery pack Spare O-ring
Micro USB charging cabe USB adaptor Cataput action bet cip Operation Switches 1 Master switch: contros on/off and output seection in Genera mode 2 Auxiiary switch: contros on/off and output seection in Fash mode ON: With the ight switched off, press and hod the Master switch for 0.5 seconds to enter Genera mode, press and hod the auxiiary switch for 0.5 seconds to enter Fash mode. OFF: With the ight switched on, press and hod either the master or auxiiary switch to turn off the ight. Mode Seection In Genera mode, singe cick the auxiiary switch to change to Fash mode. In Fash mode, singe cick the master switch to change to Genera mode. Output seection In Genera mode, singe cick the master switch to cyce through Eco Low Med High Turbo. In Fash mode, singe cick the auxiiary switch to cyce through Strobe SOS. 3Lock-out Function Lock: with the ight unocked, simutaneousy press and hod the two switches for over 3 seconds. Light wi switch off and 2 one-second binks wi indicate ocked status. Unock: with the ight ocked, simutaneousy press and hod the two switches for over 3 seconds. The ight wi be unocked and activated on ast used brightness. In ocked status, pressing any switch wi activate 2 one-second binks to indicate ocked status.
Inteigent Memory Circuit The ight memorizes the ast seected brightness eve on Genera mode. When turned on again the previousy used brightness eve wi be recaed. Inteigent Overheat Protection The ight wi accumuate a ot of heat when used on Turbo output eve for extended periods. When a temperature of 65 C or above is reached, the ight wi automaticay step down by a few umens to reduce temperature. When the temperature is reduced, the output wi graduay return to Turbo output eve. 4Battery Leve Indication There are four LED s in the ight tai. Singe cicking the round switch on the tai wi indicate remaining battery eve for 3 seconds: The more LED s ight up, the higher the battery eve. Four LED s on: more than 80%; Ony one LED on: more than 20% One LED fashing: ess than 20% Low-votage Warning When the votage eve drops beow the preset eve, the fashight is programmed to downshift to a ower brightness eve unti Eco output is reached. When this happens in Eco output mode, the fashight binks three times every five minutes to remind you to repace the battery. To ensure norma use, the fashight wi ony turn off once the battery over-discharging protection activates. 5Charging First pug the USB termina of the charging cabe into an eectrica outet, then connect the Micro USB termina of the charging cabe to the ight. The LED indicators wi fash in sequence whie charging, and wi turn to constant on when fuy charged. The norma charging time is approximatey 4 hours. Note:
1. Once charging is competed, be sure to cose the anti-dust cover. 2. Recharge a stored ight every four months to maintain optimum performance of the battery. 6Battery Repacement Unscrew the tai cap to insert the battery (no need to check the poarity), then screw the tai cap back on. Remove the insuation sheet before first use. Usage and Maintenance Disassembing the seaed head can cause damage to the ight and wi void the warranty. Long-term use can resut in O-ring wear. To maintain a proper water sea, repace the ring with an approved spare. Periodic ceaning of the battery contacts improves the amp's performance as dirty contacts may cause the amp to ficker, shine intermittenty or even fai to iuminate for the foowing reasons: A: The batteries need repacing. Soution: Repace batteries (Ensure batteries are inserted according to the manufacturer s specifications). B: The threads, PCB board contact or other contacts are dirty. Soution: Cean the contact points with a cotton swab soaked in rubbing acoho. If the above methods don't work, pease contact your authorized distributor. Warning This fashight is a high-intensity ighting device capabe of causing eye damage to the user or others. Avoid shining the fashight directy into anyone s eyes.