Description Operation mode and max sensing range: : Dependent on amplifier (up to 7m) proximity: Dependent on amplifier (up to 5m) Optional sensor monitor Wide variety of housings High tolerance to hostile environments Cable or plug connections Available with optional ATE approval The remote sensor series, which consists of a transmitter LT and receiver LR, is made to operate in conjunction with a Telco photoelectric amplifier from the PA, MPA or PAB programmes. The series is available with optional power-(lr) and output-(lt) monitor s for use with any Telco photoelectric amplifier which has the sensor drive feature incorporated. The remote sensors are available in a wide range of housings, with either cable or plug connection, and may be used in thru-beam or diffuse proximity mode. Technical Data LT LR Transmitter diode Ga Al As, (88 nm) Photo transistor Silicon NPN Housing material Sensor housing Refer to Available Types Front lens Cable, PVC, mm 2 x, mm 2 1 x, mm 2 + shield Min. cable bending radius 5 mm Environmental Data Vibration 1 55 Hz,,5 mm Shock g 11 Series > 5 lux Light immunity, @ 2 incidence 1 Series > 8 lux 11/12 Series > 1 lux Temperature, operation to +5 C Temperature, storage to +8 C Sealing class IP 7 Approvals a REMOTE PHOTOELECTRIC SSTEMS I 1
Available Types Series Optical Connection 5 m cable m cable pin, M8 plug pin, M12 plug Angle Housing Material Housing Type Order Reference 11 +/ 1 +/ Ø1 LT 11 AP 5 LT 11 AP LT 11 AP T LT 11 TP 5 LT 11 TP LT 11 TP T Nickel Plated Brass M12 x 1 LT 11 TB 5 LT 11 TB LT 11 TB T Stainless Steel (VA) LT 11 TS 5 LT 11 TS LT 11 TS T Polyester x 11,5 LT 11 SG 5 2 LT 11 SG 2 LT 11 SG T ABS Ø12,7 Snap LT 11 S22 5 2 LT 11 S22 2 Ø1 LR 11 AP 5 LR 11 AP LR 11 AP T LR 11 TP 5 LR 11 TP LR 11 TP T Nickel Plated Brass M12 x 1 LR 11 TB 5 LR 11 TB LR 11 TB T Stainless Steel (VA) LR 11 TS 5 LR 11 TS LR 11 TS T Polyester x 11,5 LR 11 SG 5 2 LR 11 SG 5 2 LR 11 SG T ABS Ø12,7 Snap LR 11 S22 5 2 LR 11 S22 5 2 Ø1 LT 1H AP 5 LT 1H AP LT 1H AP T LT 1H TP 5 LT 1H TP LT 1H TP T +/ 12 Nickel Plated Brass M12 x 1 LT 1H TB 5 LT 1H TB LT 1H TB T LT 1H TB58 J (High Power) Stainless Steel (VA) LT 1H TS 5 LT 1H TS LT 1H TS T LT 1H TS58 J 1 +/ +/ 7 Polyester x 11,5 LT 1H SG 5 2 LT 1H SG 2 LT 1H SG T Ø12,7 Snap LT 1H S 5 2 LT 1H S 2 Ø1 LT 1 AP 5 LT 1 AP LT 1 AP T LT 1 TP 5 LT 1 TP LT 1 TP T Nickel Plated Brass M12 x 1 LT 1 TB 5 LT 1 TB LT 1 TB T LT 1 TB58 J Stainless Steel (VA) LT 1 TS 5 LT 1 TS LT 1 TS T LT 1 TS58 J Polyester x 11,5 LT 1 SG 5 2 LT 1 SG 2 LT 1 SG T Ø12,7 Snap LT 1 S 5 2 LT 1 S 2 Ø1 LR 1 AP 5 LR 1 AP LR 1 AP T LR 1 TP 5 LR 1 TP LR 1 TP T Nickel Plated Brass M12 x 1 LR 1 TB 5 LR 1 TB LR 1 TB T LR 1 TB58 J Stainless Steel (VA) LR 1 TS 5 LR 1 TS LR 1 TS T LR 1 TS58 J Polyester x 11,5 LR 1 SG 5 2 LR 1 SG 2 LR 1 SG T Ø12,7 Snap LR 1 S 5 2 LR 1 S 2 11 +/ 5 +/ Ø1 LT 11 AP 5 LT 11 AP LT 11 AP T LT 11 TP 5 LT 11 TP LT 11 TP T Nickel Plated Brass M12 x 1 LT 11 TB 5 LT 11 TB LT 11 TB T LT 11 TB58 J Stainless Steel (VA) LT 11 TS 5 LT 11 TS LT 11 TS T LT 11 TS58 J Ø1 LR 11 AP 5 LR 11 AP LR 11 AP T LR 11 TP 5 LR 11 TP LR 11 TP T Nickel Plated Brass M12 x 1 LR 11 TB 5 LR 11 TB LR 11 TB T LR 11 TB58 J Stainless Steel (VA) LR 11 TS 5 LR 11 TS LR 11 TS T LR 11 TS58 J +/ LT 12 TB5 5 LT 12 TB5 12 Nickel Plated Brass M18 x 1 +/ 2,5 LR 12 TB5 5 LR 12 TB5 Note: 1. Photo amplifiers to be ordered separately. 2. Remote sensors are available with optional power (LR) and output (LT) monitor s for use with the applicable Telco photoelectric amplifier, which has the sensor drive. Add L after the series number for sensor monitor e.g. LT/LR 11L AP 5. Sensors marked 2 are not available with this optional feature.. Remote Sensor series with cable connection is available to comply with ATE II GD T EEx na II U. Add /E after the series number e.g. LT/LR 1/E TS 5. Sensors marked are not available to comply with ATE approval. 1 I REMOTE PHOTOELECTRIC SSTEMS
Applicable Photoelectric Amplifiers and Maximum Ranges Remote Sensor Series 11 1 11 12 Amplifier Series Proximity Proximity Proximity Proximity Photoelectric Amplifier Series PA 1 8 m, m 1 m,7 m 2 m 1, m 5 m,5 m PA 9 5 m, m PA 1 A 11 m,9 m B m 1,1 m 5 m 2 m m m PA 11 18 m 1,1 m m 2 m 7 m 5 m Multiplexed Amplifier Series MPA 21 1 m,7 m m 1, m 5 m,5 m MPA 1 A/B 8 m, m 18 m 1, m 5 m 2 m C/D m, m 9 m,7 m 18 m 1, m MPA 81 A/B 8 m, m 18 m 1, m 5 m 2 m C/D m, m 9 m,7 m 18 m 1, m Photoelectric Amplifier Bus Series PAB 1 18 m 1, m m 2 m 7 m 5 m PAB 2 12 m,8 m 27 m 1,7 m 7 m, m PAB 12 m,8 m 27 m 1,7 m 7 m, m Note: Sensing ranges using glass fibre optics, please refer to page 19. Connections Cable M8 Plug / Cable M12 Plug / Cable Transmitter Signal Red Pin 1 / Brown Pin 1 / Brown Transmitter Ground Black Pin / Blue Pin / Blue Receiver Signal ellow Pin / Black Pin / Black Receiver Ground Shield Pin / Blue Pin / Blue pin, M8 pin, M12 Sensor Plug (Male) Cable Plug (Female) Black Sensor Plug (Male) Cable Plug (Female) Brown 1 1 Brown 1 2 1 2 White Blue Blue Black Wiring Diagrams Red 1 Signal ellow Signal Black Ground Shield Ground LT LR REMOTE PHOTOELECTRIC SSTEMS I
Dimensions and Descriptions Series 11 Ø 1 28,5 M12 x 1 28,5 1,5,5 AP 5/ TP/TB/TS 5/ 1 1 Ø,5 1 Ø,5 Ø 1 M8 x 1 M12 x 1 M8 x 1 7 AP T TP/TB/TS T M8 x 1 22 Ø,5 Ø 12,7 SG 5/ SG T S22 5/,5 Series 1 Ø 1 1,5 M12 x 1 1,5,5,5 AP 5/ TP/TB/TS 5/ 9 9 1 Ø,5 1 Ø,5 Ø 1 M8 x 1 M12 x 1 M8 x 1 7 M8 x 1 AP T TP/TB/TS T 2 58 SG 5/ SG T Ø,9 Ø 12,7 M12 x 1 M12 x 1 S 5/ TB/TS58 J I REMOTE PHOTOELECTRIC SSTEMS
Series 11 Ø 1 1,5 M12 x 1 1,5 58 M12 x 1 M12 x 1 AP 5/ TP/TB/TS 5/ TB/TS58 J 9 9 Ø 1 M8 x 1 M12 x 1 M8 x 1 AP T TP/TB/TS T Series 12 28 55 5 M18 x 1 2 TB5 5/ Sensing Characteristics Parallel () 1 8 2 2 8 1 1 2 5 7 8 9 1 12 9 9 12 LT 1H LT 1 1 2 5 7 8 9 1 Series 11 Series 1 8 2 2 8 1 2 5 7 8 9 1 8 2 2 8 1 2 5 7 8 9 1 Series 11 Series 12 REMOTE PHOTOELECTRIC SSTEMS I
Sensing Characteristics Angular () 1 5 2 1 5 5 1 2 LT 11 Sensitivity 1 5 2 1 5 5 1 2 LR 11 1 1 5 2 LT 1H LT 1 1 5 5 1 2 LT 1 Sensitivity 1 5 2 1 5 5 1 2 LR 1 1 5 2 1 5 5 1 2 LT 11 Sensitivity 1 5 2 1 5 5 1 2 LR 11 1 5 2 1 5 5 1 2 LT 12 Sensitivity 1 5 2 1 5 5 1 2 LR 12 Telco reserves the right to change specifications without notice. 18 I REMOTE PHOTOELECTRIC SSTEMS