HONDA VTX 1800C HONDA VTX 1800R INSTALLATION INSTRUCTIONS

Transcription

1 HONDA VTX 1800C HONDA VTX 1800R INSTALLATION INSTRUCTIONS PARTS LIST quantity description 1 power commander EX 1 USB cable 1 cd-rom 1 installation guide 1 power adapter 2 1 power wire 2 power commander EX decal 2 dynojet decal 2 velcro strip 1 alcohol swab expansion port USB port PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION DOWNLOAD THE POWER COMMANDER SOFTWARE AND LATEST MAPS FROM OUR WEBSITE: Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV (800) i ex Honda VTX

2 The ignition must be turned OFF before installation. Figure A For Honda VTX 1800R and N models, use EX. For 2005 Honda VTX 1800F and C models, use EX. 1 Remove the seat. Remove both side covers. 2 Disconnect the black from the ECU as shown in Figure A. ECU unplug this stock 3 Attach the s from the to the stock and to the ECU as shown in Figure B. Note: Verify the is plugged into the BLACK side of the ECU. Figure B s ground wire from 4 Remove the ground bolt. This bolt is located in front of the ECU next to the linked braking proportional valve as shown in Figure C. 5 Reinstall this bolt through the eyebolt end of the ground wire from the as shown in Figure C. Figure C i ex Honda VTX

3 Figure D red wire with yellow tracer location: top of ECU third pin from the right 6 Locate the red wire with a yellow tracer on the grey side of the ECU. 7 Attach the supplied to this wire as shown in Figure D. Verify the tap is completely closed. Note: It is recommended to use silicone inside this. grey wire from 8 Connect the gray lead from the to the as shown in Figure E. grease on this connection. Figure E wire cluster 9 Locate the cluster of wires in the clear cover under the right hand side cover as shown in Figure F. Figure F i ex Honda VTX

4 red wire and s from 10 Locate the brown wire which connects to a brown wire with a black tracer (this is the power for the tail light). Unplug these s. Attach the red wires from the to the stock s as shown in Figure G. Figure G stock stock Figure H 11 Route the between the tray and the left hand frame rail. 12 Mount the to the left hand side of the battery box using the supplied velcro as shown in Figure H. 13 Reinstall the side covers. 14 Reinstall the seat. i ex Honda VTX

5 EUROPEAN MODELS ONLY supplied power lead red wire from Power for the is supplied from the tail light circuit. On European specification bikes, it is possible to switch the light circuit off (via the handlebar switch). This will shut off the power to the causing the bike to stall. It is necessary to use the power lead adapter and on European bikes to maintain constant power to the. It is not necessary to use these parts on a U.S specification bike as there is no performance advantage. Use the following instructions for European models only. 1 Attach the supplied power lead to the red wire from the as shown in Figure I. Figure I Figure J location: top of ECU second pin from the left black wire with white tracer power lead 2 Locate the black wire with a white tracer on the grey side of the ECU as shown in Figure J. 3 Attach the supplied to this wire as shown in Figure J. Verify the tap is completely closed. grease inside this. 4 Connect the other end of the power lead to the as shown in Figure J. grease on this connection. i ex Honda VTX