Xpress 1000 Ultra Fast Charger

Transcription

1 Page : 1 / 5 Product Technical Specification for : Brand PN Bulk PN Finish Good Description UNIROSS AAB RC Charger X-PRESS 1000mA P-KO + 4xAA Ni-MH 2000mAh + CC ASIE UNIROSS AAB RC Charger X-PRESS 1000mA P-AUS + 4xAA Ni-MH 2000mAh + CC ASIE UNIROSS AAB RC Charger X-PRESS 1000mA P-US/ xAA Ni-MH 2000mAh + CC ASIE UNIROSS AAB RC Charger X-PRESS 1000mA P-US + 4xAA Ni-MH 2000mAh + CC ASIE UNIROSS AAB RC Charger X-PRESS 1000mA P-EU + 4xAA Ni-MH 2000mAh + CC ASIE UNIROSS AAB RC Charger X-PRESS 1000mA P-UK + 4xAA Ni-MH 2000mAh + CC ASIE UNIROSS AAB RC Charger X-PRESS 1000mA P-CH + 4xAA Ni-MH 2000mAh + CC CHINE UNIROSS AAB RC Charger X-PRESS 1000mA P-US + 4xAA Ni-MH 2000mAh + CC US UNIROSS AAB RC Charger X-PRESS 1000mA P-UK + 4xAA Ni-MH 2000mAh + CC UNIROSS AAB RC Charger X-PRESS 1000mA P-EU + 4xAA Ni-MH 2000mAh + CC UNIROSS AAB Charger FAMILY PACK X-PRESS 1000mA P-EU+4xAA RC mAh+4convertersC+4convertersD UNIROSS AAB Charger FAMILY PACK X-PRESS 1000mA P-UK+4xAA RC mAh+4convertersC+4convertersD Issue : First Release Written and reviewed by Approved by Name ALLEIL Philippe Technical & Quality Director ROBERT M. C. Product Manager Date 21 October October 2003 Signature

2 Page : 2 / 5 1 Scope This Ultra Fast Charger is designed for charging 2 or 4 AA, or 2 AAA Ni-Cd or Ni-MH batteries. The maximum capacity chargeable for AA is 200mAh. The charge is controlled by a microprocessor 2 Electrical specification ITEM SPECIFICATION NOTES Input Rating Voltage 12Vdc Current 800mA Maximum Plug 5.5 x 2 mm + polarity at the centre Output Rating 1x(6V/1000mA) 6VA AA 1x(6V/600mA) 3.6VA AAA Charging Time AAA / AA Ni-Cd batteries AAA / AA Ni-MH batteries Charging Current AAA Ni-Cd/Ni-MH AA Ni-Cd/Ni-MH Trickle Current AAA Ni-Cd/Ni-MH AA Ni-Cd/Ni-MH Less than 1 hour Around 2.5 hours mA mA 30 50mA mA Depending on the state of charge of cells Depending on the state of charge of cells End of Charge Detection - Delta V 6 12mV for 2 cells Only 2 cells used in case of AAA 10 24mV for 4 cells Max voltage 3.4V for 2 cells Only 2 cells used in case of AAA 6.8V for 4 cells Safety timer 2h30mn Thermal cut off C 1 thermal sensor per two cells Protection Input Protection Reversed connection Short-Circuit No charge and without any consequence. Limitation of the output current No contact between the battery and the charger contact Dimension L x W x H (mm) 107x 65 x 27

3 Page : 3 / 5 Charging Time table Size Technology Rated Capacity Approximate (mah) charging Time AAA Ni-Cd mn AAA Ni-Cd mn AAA Ni-MH 550 1h18mn AAA Ni-MH 600 1h27mn AAA Ni-MH 650 1h31mn AAA Ni-MH 700 1h38mn AAA Ni-MH 750 1h49mn AA Ni-Cd min AA Ni-Cd min AA Ni-MH h45mn AA Ni-MH h53mn AA Ni-MH h05mn AA Ni-MH h20mm AA Ni-MH h30mn 3 AC / DC adapter Specification Input plug EU UK US Input AC voltage AC230V, 50Hz AC120V, 60Hz Power work mode Linear Linear Output voltage DC12V 800mA DC12V 800mA Wire length 1.5m 1.5m

4 Page : 4 / 5 4 Operating 4.1 Before plugging the charger into the mains power The batteries should be inserted (take care to observe polarity). Select the correct number of cells with the switch (if there is only 2 cells place them in the 2 left-hand positions). Do not mix battery sizes and technology : only charging AA or AAA at a time. 4.2 Charge and end of charge for AA and AAA As the charger is plugged with the adapter, the charge begins and the charging LED indicator illuminates in red. The end of charge is automatic, thanks to a detection of V, max voltage and thermal control. For safety reason, the charger is also equipped with a safety timer adjusted at 2,5 hours. When the end of charge is detected, the red indicator light goes out. 4.3 Protection against reversed connection By the design of the charger, when a battery (AA or AAA) is inserted on the wrong way, there is no contact between the charger and the battery. That is why the charge does not begin and the Charging Led indicator does not illuminate..

5 Page : 5 / 5 5 Identification 5.1 Unit Base