3/2-way Rocker Solenoid Valve for pneumatic systems

Transcription

1 3/-way Rocker Solenoid Valve for pneumatic systems EEx ia versions Direct-acting High cycling rate Reduced power consumption Type 6104 can be combined with... Sub-base connection Approvals: Type 654 Servo-assisted pneumatic valve Type 6104 Multiple manifolds (e.g. 6 valves) Type 6104 is a 3/-way rocker solenoid valve with polyamide body. A tilting armature, similar to a rocker, moves in the body. The small tilting motion of the rocker is hard-wearing; basic lubrication is not required. The modular valve can be supplied with various flange connections depending on usage and can be used both individually and in blocks. An intrinsically safe version (EEx ia) is available in addition to the standard model. Circuit function C Circuit function D 3/-way valve, direct acting, de-energized port exhausted 3/-way valve, direct acting, de-energized port pressurized Technical data Body material Seal material Media Media temperature Ambient temperature Electrical connection Type of protection Standard version EEx ia version Operating voltage PA (polyamide) FKM Voltage tolerance ±10% Standard EEx ia version Duty cycle Installation Compressed lubricated, oil-free or dry, neutral gases (5µm filtering) technical vacuum 14 F to 131 F (-10 C to +55 C) 14 F to 131 F (-10 C to +55 C) Bürkert flange Lateral flange Rectangular plug as standard on request: Circular plug M8x1 Flying lead 0. mm, 300 mm Connector with raster 5.08 mm Insulation class 3 acc. VDE 0580 Protection class IP 40 Cycling rate ca. 1000/min Electrical control with SPS possible Response times Open (Pressure rise 0 to 90%) Close (Pressure rise 100 to 10%) none II G EEx ia IIC T5 T6 PTB01 ATEX V/DC 1 V/DC on request 1 W 0.4 W 100% continuous rating As required, preferably with actuator upright Measurement at the valve outlet, at 68 F (0 C) and 87 PSI ca. 14 ms (Standard) ca. 30 ms (EEx ia version) ca. 18 ms (Standard) ca. 4 ms (EEx ia version) usa.com p. 1/5

2 Materials Spring Stainless steel Seat seal FKM 3. Rocker PA (polyamide) 4. Core Stainless steel Coil body PA (polyamide) 6. Manual override PA (polyamide) 7. Mounting screws Stainless steel Fluid body PA (polyamide) 9. Flange seal FKM 10. Holder Stainless steel Ordering chart standard version All valves with rectangular plug, mounting screws and flange seal; without plug connection (see Accessories) Circuit function Orifice [mm] QNn value 1- [l/min] 1) QNn value -3 [l/min] 1) Pressure range ) [PSI] Manual override Voltage [V] [W] Item no. C yes Bürkert flange no lateral flange yes lateral flange /-way valve NC D yes Bürkert flange no lateral flange yes lateral flange /-way valve NO 1) QNn value [l/min]: measurement with 68 F (+0 C), 87 PSI pressure on the valve input and 14.5 PSI pressure differential ) Pressure values [PSI]: measured as overpressure to the atmospheric pressure Mounting screws for Bürkert flange: M1.6x5; for lateral flange: M1.6x0 Circuit function A and B on request p. /5

3 Ordering chart Ex ia version Approval acc. II G EEx ia IIC T5 T6 PTB01 ATEX 173 All valves with rectangular plug, mounting screws and flange seal; without plug connection (see Accessories) Circuit function Orifice [mm] QNn value 1- [l/min] QNn value -3 [l/min] Pressure range [PSI] Manual override Voltage [V] [W] Item no. C with Bürkert flange /-way valve NC Mounting screws for Bürkert flange: M1.6x5 Electrical datas: PLC 4 V/DC barrier/ isolating component + _ I min U min + Functional values for valves switching function with 68 F to 131 F (+0 C to +55 C) Minimum holding current: 9mA Nominal resistant of the coil: 31Ω ±6% Permitted maximum values/value ps after operating instruction (TS) Ui 35V Ii 0.9A Pi 0.7W (with block assembly, max. 104 F (+40 C)) 0.7W (with single valve, max. 131 F (+55 C)) 0.8W (with single valve, max. 1 F (+50 C)) Dimensions [mm] Type 6104 with Bürkert flange Type 6104 with lateral flange and diagonally opposite manual override (variable code MD07) p. 3/5

4 Dimensions manifolds [mm] Single manifold for lateral flange sidewards Multiple manifolds for lateral flange No. of valve modules A B valves 4 valves 44 6 valves Single manifolds for Bürkert flange p. 4/5

5 Ordering chart for accessories Accessory Characteristics Item no. Manifold single for Bürkert flange under, M Manifold single for lateral flange, M Manifold valves for lateral flange, M Manifold 4 valves for lateral flange, M Manifold 6 valves for lateral flange, M Blanking plate set for multiple manifolds angle flange Threaded tube spigot straight, M3, for 4/ mm tube Rectangular cable plug with 3 m cable Rectangular cable plug with 300 mm flying leads Rectangular cable plug with single contacts Options for the electrical connection, rectangular plug as standard, other connections on request Rectangular plug (standard) Raster 5.08 mm Flying leads 0. mm, 300 mm long Circular connector M8x1, 3-pins Connector Raster 5.08 mm (e.g. for printed board mounting) In case of special application conditions, please consult for advice. We reserve the right to make technical changes without notice. Christian Bürkert GmbH & Co. KG 0803/_US-en_ p. 5/5