MAC12D, MAC12M, MAC12N. Triacs. Silicon Bidirectional Thyristors. TRIACS 12 AMPERES RMS 400 thru 800 VOLTS

Transcription

1 MAC2D, MAC2M, MAC2N Triacs Silicon Bidirectional Thyristors Designed for high performance fullwave ac control applications where high noise immunity and commutating di/dt are required. Features Blocking Voltage to 8 Volts OnState Current Rating of 2 Amperes RMS at 7 C Uniform Gate Trigger Currents in Three Quadrants, Q, Q2, and Q3 High Immunity to dv/dt 25 V/ s Minimum at 25 C High Commutating di/dt 6.5 A/ms Minimum at 25 C Industry Standard TO22 Package High Surge Current Capability Amperes These Devices are PbFree and are RoHS Compliant* MAXIMUM RATINGS (T J = 25 C unless otherwise noted) Rating Symbol Value Unit Peak Repetitive OffState Voltage (Note ) (T J = 4 to 25 C, Sine Wave, 5 to 6 Hz, Gate Open) MAC2D MAC2M MAC2N On-State RMS Current (All Conduction Angles; T C = 7 C) Peak Non-Repetitive Surge Current (One Full Cycle, 6 Hz, T J = 25 C) V DRM, V RRM V I T(RMS) 2 A I TSM A Circuit Fusing Consideration (t = 8.33 ms) I 2 t 4 A 2 sec Peak Gate Power (Pulse Width. s, T C = 8 C) Average Gate Power (t = 8.3 ms, T C = 8 C) P GM 6 W P G(AV).35 W Operating Junction Temperature Range T J 4 to +25 C Storage Temperature Range T stg 4 to +5 C Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed, damage may occur and reliability may be affected.. V DRM and V RRM for all types can be applied on a continuous basis. Blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded. 2 3 TRIACS 2 AMPERES RMS 4 thru 8 VOLTS MT2 x A Y WW G Littelfuse.com TO22 CASE 22A STYLE 4 G = D, M, or N = Assembly Location = Year = Work Week = PbFree Package MT MARKING DIAGRAM MAC2xG AYWW PIN ASSIGNMENT Main Terminal 2 Main Terminal 2 3 Gate 4 Main Terminal 2 ORDERING INFORMATION Device Package Shipping MAC2DG TO22 5 Units / Rail (PbFree) MAC2MG MAC2NG TO22 (PbFree) TO22 (PbFree) 5 Units / Rail 5 Units / Rail Specifications subject to change without notice. 26 Littelfuse, Inc. September 9, 26 Rev. 5 Publication Order Number: MAC2/D

2 MAC2D, MAC2M, MAC2N THERMAL CHARACTERISTICS Thermal Resistance, Characteristic Symbol Value Unit JunctiontoCase JunctiontoAmbient R JC 2.2 R JA 62.5 Maximum Lead Temperature for Soldering Purposes /8 from Case for Seconds T L 26 C C/W ELECTRICAL CHARACTERISTICS (T J = 25 C unless otherwise noted; Electricals apply in both directions) OFF CHARACTERISTICS Characteristic Symbol Min Typ Max Unit Peak Repetitive Blocking Current T J = 25 C (V D = Rated V DRM, V RRM, Gate Open) T J = 25 C I DRM, I RRM. 2. ma ON CHARACTERISTICS Peak OnState Voltage (Note 2) (I TM = ±7 A) V TM.85 V Gate Trigger Current (Continuous dc) (V D = 2 V, R L = ) MT2(+), G(+) MT2(+), G() MT2(), G() I GT ma Hold Current (V D = 2 V, Gate Open, Initiating Current = ±5 ma) I H 2 4 ma Latch Current (V D = 24 V, I G = 35 ma) MT2(+), G(+) MT2(+), G() MT2(), G() I L ma Gate Trigger Voltage (Continuous dc) (V D = 2 V, R L = ) MT2(+), G(+) MT2(+), G() MT2(), G() V GT V DYNAMIC CHARACTERISTICS Rate of Change of Commutating Current (V D = 4 V, ITM = 4.4A, Commutating dv/dt = 8 V/ s, Gate Open, T J = 25 C, f = 25 Hz, No Snubber) Critical Rate of Rise of OffState Voltage (V D = Rated V DRM, Exponential Waveform, Gate Open, T J = 25 C) (di/dt)c 6.5 A/ms dv/dt 25 5 V/ s Repetitive Critical Rate of Rise of On-State Current IPK = 5 A; PW = 4 sec; dig/dt = 2 ma/ sec; f = 6 Hz di/dt A/ s Product parametric performance is indicated in the Electrical Characteristics for the listed test conditions, unless otherwise noted. Product performance may not be indicated by the Electrical Characteristics if operated under different conditions. 2. Pulse Test: Pulse Width 2. ms, Duty Cycle 2%. Specifications subject to change without notice. 26 Littelfuse, Inc. September 9, 26 Rev. 5 2 Publication Order Number: MAC2/D

3 MAC2D, MAC2M, MAC2N Voltage Current Characteristic of Triacs (Bidirectional Device) + Current Symbol V DRM I DRM V RRM I RRM Parameter Peak Repetitive Forward Off State Voltage Peak Forward Blocking Current Peak Repetitive Reverse Off State Voltage Peak Reverse Blocking Current I RRM at V RRM on state I H V TM Quadrant MainTerminal 2 + V TM I H Maximum On State Voltage Holding Current I H off state I DRM at V DRM + Voltage Quadrant 3 MainTerminal 2 V TM Quadrant Definitions for a Triac MT2 POSITIVE (Positive Half Cycle) + (+) MT2 (+) MT2 Quadrant II () I GT (+) I GT Quadrant I MT MT I GT + I GT () MT2 () MT2 Quadrant III () I GT (+) I GT Quadrant IV MT MT MT2 NEGATIVE (Negative Half Cycle) All polarities are referenced to MT. With inphase signals (using standard AC lines) quadrants I and III are used. Specifications subject to change without notice. 26 Littelfuse, Inc. September 9, 26 Rev. 5 3 Publication Order Number: MAC2/D

4 MAC2D, MAC2M, MAC2N. IGT, TRIGGER CURRENT (ma) Q3 Q2 Q VGT, TRIGGER VOLTAGE (VOLT) Q3 Q Q Figure. Typical Gate Trigger Current Figure 2. Typical Gate Trigger Voltage HOLDING CURRENT (ma) MT2 NEGATIVE MT2 POSITIVE LATCHING CURRENT (ma) Q2 Q Q Figure 3. Typical Holding Current Figure 4. Typical Latching Current T C, CASE TEMPERATURE ( C) , 9, 6, 3 8 DC I T(RMS), RMS ON STATE CURRENT (AMP) P(AV), AVERAGE POWER DISSIPATION (WATTS) DC I T(AV), AVERAGE ON STATE CURRENT (AMP) Figure 5. Typical RMS Current Derating Figure 6. On-State Power Dissipation Specifications subject to change without notice. 26 Littelfuse, Inc. September 9, 26 Rev. 5 4 Publication Order Number: MAC2/D

5 MAC2D, MAC2M, MAC2N I T, INSTANTANEOUS ON STATE CURRENT (AMP) T J = 25 C T J = 25 C T J = 25 C r(t), TRANSIENT THERMAL RESISTANCE (NORMALIZED)... t, TIME (ms) Figure 8. Typical Thermal Response V T, INSTANTANEOUS ON STATE VOLTAGE (VOLTS) Figure 7. Typical On-State Characteristics Specifications subject to change without notice. 26 Littelfuse, Inc. September 9, 26 Rev. 5 5 Publication Order Number: MAC2/D

6 MAC2D, MAC2M, MAC2N PACKAGE DIMENSIONS TO22 CASE 22A9 ISSUE AH H Q Z L V G B N D A K F T U R J S C T SEATING PLANE NOTES:. DIMENSIONING AND TOLERANCING PER ANSI Y4.5M, CONTROLLING DIMENSION: INCH. 3. DIMENSION Z DEFINES A ZONE WHERE ALL BODY AND LEAD IRREGULARITIES ARE ALLOWED. INCHES MILLIMETERS DIM MIN MAX MIN MAX A B C D F G H J K L N Q R S T U V Z STYLE 4: PIN. MAIN TERMINAL 2. MAIN TERMINAL MAIN TERMINAL 2 Littelfuse products are not designed for, and shall not be used for, any purpose (including, without limitation, automotive, military, aerospace, medical, life-saving, life-sustaining or nuclear facility applications, devices intended for surgical implant into the body, or any other application in which the failure or lack of desired operation of the product may result in personal injury, death, or property damage) other than those expressly set forth in applicable Littelfuse product documentation. Warranties granted by Littelfuse shall be deemed void for products used for any purpose not expressly set forth in applicable Littelfuse documentation. Littelfuse shall not be liable for any claims or damages arising out of products used in applications not expressly intended by Littelfuse as set forth in applicable Littelfuse documentation. The sale and use of Littelfuse products is subject to Littelfuse Terms and Conditions of Sale, unless otherwise agreed by Littelfuse. Littelfuse.com Specifications subject to change without notice. 26 Littelfuse, Inc. September 9, 26 Rev. 5 6 Publication Order Number: MAC2/D

7 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Littelfuse: MAC2DG MAC2MG MAC2NG