FOR AGES 8 AND UP. 2.4GHz 3.5CH REMOTE CONTROL HELICOPTER ITEM NO

Size: px

Start display at page:

Download "FOR AGES 8 AND UP. 2.4GHz 3.5CH REMOTE CONTROL HELICOPTER ITEM NO"

Cornelius Carter
6 years ago
Views:

1 8+ FOR AGES 8 AND UP 2.4GHz 3.5CH REMOTE CONTROL HELICOPTER ITEM NO

2 INTRODUCTION Thank you for purchasing this World Tech Toys product. Please make sure you carefully read the entire manual before operating this RC helicopter. This helicopter is recommended for ages 8 and up. FEATURES World s Only Unbreakable Helicopter Super Strong Polymer Body Helicopter Body Can Take Up To 200 Pounds Of Force Full Size Joystick Transmitter 2.4GHz Radio Technology 3.5 Channel Radio Control Built In Gyro LED Lights Turbo Button Sound FX And Vibration USB CHARGER SPECIFICATIONS Body Length: 15.5 Inches Body Width: 2.75 Inches Body Height: 7.75 Inches Main Rotor Diameter: 13 Inches Weight: 0.5 Pounds Flight Time: Approx. 10 Minutes Charging Time: Minutes HELICOPTER STABILIZER COAXIAL ROTOR CONNECTING SHAFT DURABLE PLASTIC BODY SUPER STRONG POLYMER FRAME LED LIGHT LANDING SKIDS TAIL ROTOR

3 TRANSMITTER TURBO BUTTON LEFT TRIM LIGHT BUTTON RIGHT TRIM DEMO MODE VOLUME BUTTON THROTTLE MACHINE GUN SOUND FX LEFT TURN/RIGHT TURN/ FORWARD/BACKWARD JOYSTICK POWER BUTTON USB CHARGING PORT BATTERY INSTALLATION Remove the battery cover and install 4 AA Batteries as shown. Replace the battery cover. Please note polarity and orientation of batteries. BOTTOM OF JOYSTICK TRANSMITTER 1: SILENT MODE 2: SOUND FX ON 3: MUSIC MODE

4 CHARGING THE HELICOPTER The Nano Hercules Helipilot comes with a USB Charger to charge the helicopter. You can use the USB charge port on the Joystick transmitter or use a USB port on a computer or USB wall charger that you already own to charge the helicopter. CHARGING OFF THE JOYSTICK TRANSMITTER: 1. Make sure both the Joystick Transmitter and the Helicopter s power is OFF. 2. Open the USB Charging Port on the Joystick Transmitter. 3. Plug the USB Charger into the bottom of the Helicopter and the USB Charging Port on the Transmitter. 4. The RED light on the USB Charger will turn on when the helicopter is done charging. Full charge will take approximately minutes. 5. Once the Helicopter is charged, remove the USB Charger from the Joystick Transmitter and the Helicopter. The Joystick Transmitter s power does not need to be ON to charge the Helicopter. CHARGING OFF USB PORT (Computer / Wall Charger): 1. Make sure the Helicopter s power is OFF. 2. Plug the USB Charger into the bottom of the Helicopter and the USB Port. 3. The RED light on the USB Charger will turn on when the helicopter is done charging. Full charge will take approximately minutes. 4. Once the Helicopter is charged, remove the USB Charger from the USB Port and the Helicopter. FULL CHARGE WILL TAKE APPROXIMATELY MINUTES WARNING: Do not charge the helicopter battery unsupervised. Do not overcharge the helicopter battery. Overcharging the battery will damage the battery causing it to not hold as long as a charge. Only charge the helicopter battery with the included wall charger.

5 PREFLIGHT CONDITIONS Be sure that Helicopter Battery is fully charged and Remote Control Batteries are fresh. Helicopter will fly best in low wind conditions. Fly Helicopter in a wide open area with no people, pets, and other objects in the way. Do not fly in strong winds. This will make operation difficult and crash the Helicopter. 1: Parental Guidance is suggested for children operating Helicopter. 2: Multiple Helicopters operating simultaneously must be on different Frequency Bands. TAKING OFF 1. Turn on the Helicopter and place it on a flat surface. 2. Make sure throttle is pushed all the way back before turning on the joystick. 3. Turn on the joystick and push the throttle all the way forward then all the way back to sync the joystick to the helicopter. The power indicator light should stop flashing when they are synced. 4. Check surroundings to be sure that it is clear of people, animals, and obstructions. 5. Slowly push the Throttle Stick up to increase blade speed for lift. 6. Adjust throttle input to maintain a steady hover. FLIGHT CONTROLS The joystick and throttle will move the helicopter as follows: FLY UP FLY DOWN

6 FLIGHT CONTROLS CONTINUED FORWARD BACKWARD TURN LEFT TURN RIGHT ADJUSTING THE TRIM If the helicopter spins to the left or right when hovering without your input, you will need to adjust the trim. HELICOPTER SPINS LEFT LEFT TRIM HELICOPTER SPINS RIGHT RIGHT TRIM Click the Right Trim button until the helicopter stops spinning. Click the Left Trim button until the helicopter stops spinning.

7 TURBO MODE TURBO BUTTON Clicking the Turbo button will put the helicopter in TURBO MODE. The helicopter will now fly forward and backward faster. Press the Turbo button again to turn off TURBO MODE. DEMO MODE DEMO MODE Pressing this button will put the helicopter in DEMO MODE. The helicopter will automatically perform air maneuvers without your input. Press the button again to turn off DEMO MODE. TROUBLESHOOTING The Transmitter indicator LED does not work Helicopter does not take off. Batteries installed with the wrong polarity. Check the polarity of the batteries and install them Correctly. Batteries are drained. Install new batteries. Helicopter is not synced to the transmitter. Go through the proper take off procedures to sync the helicopter to the transmitter. No control Helicopter is not receiving signal from of the helicopter transmitter. Helicopter is not flying high enough Move closer to the helicopter. Fly the helicopter in an area with less radio interference. Windy Conditions. Fly helicopter in calm conditions. Helicopter is not receiving signal from transmitter correctly. Test the control functions of the helicopter in a hover by applying light throttle and testing left and right controls. Rotor speed is too slow. Push the throttle forward for more rotor speed. Batteries are drained. Fully charge helicopter before use.

8 BATTERY TIPS: Alkaline batteries are recommended to use in the transmitter. Only batteries of the same or equivalent type as recommended are to be used. Do not mix alkaline, standard or rechargeable batteries. Do not mix old and new batteries or different types of batteries. Do not recharge non rechargeable batteries. If rechargeable batteries are used, only charge them under adult supervision. Rechargeable batteries are to be removed from the helicopter before they are charged. Be sure to insert the batteries with the correct polarities and always follow the battery manufacturer s instructions. 9. Remove all batteries from the helicopter and transmitter when not in use. 10.Remove exhausted batteries from the product. 11.Do no short circuit the supply terminals. 12.Dispose of batteries properly. Do not dispose of batteries in fire - it may cause the battery to explode or leak causing injury or damage. 13.Battery change must be only made by adults. WARNING: 1. Do not disassemble the RC helicopter or transmitter. 2. Do not operate the helicopter with the same frequency with other RCs in the same location. The same frequency RC will cause interference and you will lose control of the helicopter. 3. Make sure the batteries are installed with the correct polarity (+/-) as shown inside the battery compartment. FCC Label Compliance Statement: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in a accordance with the instructions, may cause harmful interference with radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is needed. - Consult the dealer or an experienced radio/tv technician for help. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment. Website: customerserv@worldtechtoys.com Phone: (877) Monday - Friday / 9:00AM - 5:00PM / Pacific Time SPECIFICATIONS, COLORS AND CONTENT MAY VARY FROM ILLUSTRATIONS MADE IN CHINA

HERCULES ITEM NO UNBREAKABLE HELICOPTER AGES CHANNEL GYRO RC HELICOPTER FEATURES

HERCULES ITEM NO UNBREAKABLE HELICOPTER AGES CHANNEL GYRO RC HELICOPTER FEATURES HERCULES UNBREAKABLE HELICOPTER 3.5 CHANNEL GYRO RC HELICOPTER FEATURES AGES 14+ ITEM NO. 35850 World s First Unbreakable Helicopter Super Strong Polymer Body 3.5 Channel Radio Control Built In Gyro LED