In-Use Evaluation of Transit Buses Operated on Biodiesel Blends (B2) by St Louis Metro Robb Barnitt Mike Lammert, Robert McCormick National Renewable Energy Laboratory (NREL) NBB Biodiesel Conference Orlando, FL February 5, 28
Agenda Project Objectives / Approach Implementation and usage On-road fuel economy Reliability Maintenance costs Fuel system durability Fuel analysis Lube oil analysis Conclusions
MPG B2 Fleet Evaluation Objectives Compare vehicles operating in the field on B2 and ULSD over 12 months: Engine performance Fuel economy Vehicle maintenance cost Fuel-induced variations in operation and maintenance Lube oil performance Fuel Economy Comparison Exhibit high degree of experimental ULSD Group B2 Group control in vehicle selection and duty cycle Aid engine OEMs in exploring affects of B2 on engine durability Aid potential B2 users in understanding costs, benefits, and Oct-6 Dec-6 Feb-7 Apr-7 Jun-7 Aug-7 differences in operation 5. 4. 3. 2. 1..
B2 Fleet Evaluation Approach 15 mechanically identical Metro transit buses: 22 Gillig Phantom 22 Cummins ISM (24 cert with EGR) 8 operated on B2, 7 on ULSD B2 and ULSD buses housed in different garages, but have been assigned to similar routes for duty cycle parity 13.75 and 14.57 mph average speeds Metro submits data electronically from their internal database Fuel, Labor, Parts Fuel sample collection and analysis - partnership with HWRT (B2 supplier) Lube oil sampling and analysis program with Cummins Oil sampled at ~2,-mile intervals
Implementation and Usage Metro reports fairly seamless transition to biodiesel/ulsd B2 blend UST fuel storage, B2 added to residual fuel until B à B2 Instituted a 2 mile fuel filter replacement schedule during transition (normally 6 mile) First experience with ULSD, phased in simultaneously with B2 (1/6) Based upon 12 months (1/6 9/7) of operational data 394,116 miles driven by B2 buses (49,267 per bus average) 9,983 gallons B2 consumed
On-road Fuel Economy Fuel Economy Comparison ULSD Group B2 Group 5. 4. MPG 3. 2. 1.. Oct-6 Dec-6 Feb-7 Apr-7 Jun-7 Aug-7 3.58 mpg ULSD, 3.52 mpg B2 (-1.71%) Difference not statistically significant
Road Calls Running Miles Between Road Calls (MBRC) 1, 8, ULSD Group B2 Group Miles 6, 4, 2, Oct-6 Dec-6 Feb-7 Apr-7 Jun-7 Aug-7 Average Total MBRCs comparable 2,375 ULSD, 2,627 B2
Engine, Fuel System Road Calls Running Engine and Fuel System MBRCs ULSD Group B2 Group 3, 25, 2, Miles 15, 1, 5, Oct-6 Dec-6 Feb-7 Apr-7 Jun-7 Aug-7 Average engine/fuel system MBRCs comparable 6,924 ULSD, 8,211 B2
Maintenance Costs - Total Total Maintenance Cost per Mile 1.2 1..8 ULSD Group B2 Group $/mile.6.4.2. Oct-6 Dec-6 Feb-7 Apr-7 Jun-7 Aug-7 June and August 27 spikes driven by scheduled (brakes and radiator) maintenance, and other nonengine or fuel system repairs
Maintenance Costs - Total Running Total Maintenance Cost per Mile ULSD Group B2 Group.8.6 $/mile.4.2. Oct-6 Dec-6 Feb-7 Apr-7 Jun-7 Aug-7 12-month average maintenance costs: $.566/mile ULSD, $.568/mile B2 Merged after 9 months Not a statistically significant difference
Maintenance Costs Engine, Fuel System Running Total Engine and Fuel System Maintenance Cost per Mile.1 ULSD Group B2 Group.8 $/mile.5.3. Oct-6 Dec-6 Feb-7 Apr-7 Jun-7 Aug-7 12-month average engine and fuel system maintenance costs: $.53/mile ULSD, $.72/mile B2
Fuel System Part Replacements Fuel filters (28 to 13) Weighted in first 2 months (2 mile change interval to account for the solvent effect) Feb-7 likely due to unseasonably cold temps dropping below the cloud point of the fuel Cloud Point stable Fuel injector replacement higher with B2 than ULSD (15 to 3) Evidence of operability issues led to injector replacement
Fuel Injector Replacements Failures on bus order group as early as 1k miles B2 buses had higher mileage at start of evaluation No pattern in B2 miles before failure No red flags with fuel quality (free/total glycerin) Cummins warranting injectors on bus order group
Fuel Analysis 15 B1, 3 B2 samples collected and analyzed Focused analytical approach led by NREL with assistance from SwRI Covered Feb-July 27 (6 of 12 months) B1 Results Free/total glycerin within spec Na+K, Ca+Mg, P within spec Flashpoint 14/15 met spec Bottom line - B1 met specs tested for
B2 Results Fuel Analysis Cloud Points ranged -1C to -15C No seasonal variation, within Metro spec B2 samples analyzed for blend content The blend level of the samples was determined using ASTM D7371 with an accuracy of +/- 2% 47% Nominal B2 (B17-23); 14/3 samples Frequency 7 6 5 4 3 2 1 1 Metro Blend Level Histogram 1 5 1 3 1 1 2 6 Nominal B2: 47% B17 - B23 2 3 2 1 1 5-6 6-7 7-8 8-9 9-1 1-11 11-12 12-13 13-14 14-15 15-16 16-17 17-18 18-19 19-2 2-21 21-22 22-23 23-24 24-25 25+ Biodiesel Blend Percentage
Lube Oil Analysis 64 oil samples analyzed by Cummins 833 6477 oil miles 6 miles change interval Despite apparent scatter, tight dataset for lube oil data Soot ULSD B2 Linear (ULSD) Linear (B2) % by Weight 1.9.8.7.6.5.4.3.2.1 1, 2, 3, 4, 5, 6, 7, Lube Oil Mileage Soot loading lower with B2 than ULSD, but both quite low
Lube Oil Analysis Viscosity as indicator of fuel dilution Viscosity appears lower with B2, but B2 and ULSD samples in-grade throughout drain period cst 15 14.5 14 13.5 13 1C Viscosity ULSD B2 Linear (ULSD) Linear (B2) TBN 12.5 1, 2, 3, 4, 5, 6, 7, Lube Oil Mileage ULSD B2 Expon. (ULSD) Expon. (B2) mg KOH/g 9 8 7 6 5 4 3 2 1 1, 2, 3, 4, 5, 6, 7, Lube Oil Mileage TBN slightly lower with B2, but both B2 and ULSD show sufficient TBN retention at end of drain
Lube Oil Analysis Iron as indicator of wear Slightly Lower with B2, especially with high mileage 3 25 2 Iron ULSD B2 Linear (ULSD) Linear (B2) ppm 15 1 5 Lead 1, 2, 3, 4, 5, 6, 7, Lube Oil Mileage ULSD B2 Linear (ULSD) Linear (B2) ppm 12 1 8 6 4 2 Lead as indicator of corrosion Slightly Higher with B2, especially with high mileage 1, 2, 3, 4, 5, 6, 7, Lube Oil Mileage
Conclusions No statistically significant difference between buses running on B2 and ULSD On-road fuel economy Reliability (Road Calls) Total maintenance costs Difference in Fuel System and Engine maint. costs driven by fuel injector replacements Skewed toward B2 buses; failure mode unknown No other observed fuel system durability issues Biodiesel blend variability (<B2) Lube oil data suggests no harm with B2 use TBN decrease, fuel dilution increase (but still in-grade ) Some potential benefits (soot, wear metals)
Special Thanks US DOE Kevin Stork NBB Steve Howell, Tom Verry, Jill Hamilton Metro Lyle Howard, Jill Coffin Cummins Shawn Whitacre HWRT Matt Schrimpf