Thompson Consulting, Inc. Overview

Similar documents
Dr. Thompson has 8 U.S. patents and is a Firefighter with the Harvard, Massachusetts Fire Department.

MAGNETIC LEVITATION TRAIN TECHNOLOGY II

MAGNETIC LEVITATION TRAIN TECHNOLOGY II

General Atomics Urban Maglev: Moving Towards Demonstration

MAGLEV TRAINS. Under the guidance of Dr. U.K.Singh. Submittted by Saurabh Singhal

Semi-Linear Induction Motor

Linear Motor Powered Transportation

HOW MAGLEV TRAINS OPERATE

Clement A. Skalski, Ph.D., P.E.

Design, Engineering, and Manufacturing of Motors for Electric Vehicle Applications

Redesign of Rotary Inductrack for Magnetic Train Levitation

LINEAR INDUCTION MOTOR

Electromagnetic actuation. technologies. Prof Phil Mellor

Why Not A Wire? The case for wireless power. Kalyan Siddabattula System Architect bqtesla Wireless Power Solutions TEXAS INSTRUMENTS

2007 International Future Energy Challenge Team Members

Transient Analysis of Offset Stator Double Sided Short Rotor Linear Induction Motor Accelerator

DESIGN OF A MICROCONTROLLER BASED ECONOMIC MAGLEV GUIDEWAY SYSTEM

6.UAP Thesis Proposal: Design of an Inductively-Coupled. AUV Recharging System

Its Faculties. from which numerous degree programs in these fields of study are offered.

Note 8. Electric Actuators

Power Electronics & Drives [Simulink, Hardware-Open & Closed Loop]

Hybrid Energy Powered Water Pumping System

EXPERIMENTAL VERIFICATION OF INDUCED VOLTAGE SELF- EXCITATION OF A SWITCHED RELUCTANCE GENERATOR

Inductive Power Supply (IPS ) for the Transrapid

DOWNLOAD OR READ : THE INDUCTION MACHINES DESIGN HANDBOOK SECOND EDITION ELECTRIC POWER ENGINEERING SERIES PDF EBOOK EPUB MOBI

GraspIT AQA GCSE Magnetism and Electromagnetism - Questions

Design and Operation Characteristics of Novel 2-Phase 6/5 Switched Reluctance Motor

Development and Analysis of Bidirectional Converter for Electric Vehicle Application

DESIGN & DEVELOPMENT OF A REGENERATIVE SHOCK ABSORBER

Conclusions. Fall 2010

Design of Inverter Driven Induction Machines. Daniel M. Saban, PE PhD

Linear Induction Motor

Fig Electromagnetic Actuator

Development of High-Efficiency Permanent Magnet Synchronous Generator for Motorcycle Application

A Comparative Analysis of Speed Control Techniques of Dc Motor Based on Thyristors

Comparison of IPM and SPM motors using ferrite magnets for low-voltage traction systems

The Advantages of Linear Direct Drives

Volume II, Issue VII, July 2013 IJLTEMAS ISSN

International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering. (An ISO 3297: 2007 Certified Organization)

Comprehensive Technical Training

Abstract- A system designed for use as an integrated starter- alternator unit in an automobile is presented in this paper. The

Using energy storage for modeling a stand-alone wind turbine system

STUDY ON MAXIMUM POWER EXTRACTION CONTROL FOR PMSG BASED WIND ENERGY CONVERSION SYSTEM

Modeling and Control of Direct Drive Variable Speed Stand-Alone Wind Energy Conversion Systems

Performance Analysis of 3-Ø Self-Excited Induction Generator with Rectifier Load

Reduction of Harmonic Distortion and Power Factor Improvement of BLDC Motor using Boost Converter

Curriculum Vitae/Resume

Energy 142 NABCEP (North American Board of Certified Energy Practitioners) Entry Level Test Review. System Components

An Integrated Starter-Alternator System Using Induction Machine Winding Reconfiguration

Design Considerations for Low Voltage Claw Pole Type Integrated Starter Generator (ISG) Systems

Power electronic grid connection of PM synchronous generator for wind turbines

EE 742 Chap. 7: Wind Power Generation. Y. Baghzouz Fall 2011

Aspects of Permanent Magnet Machine Design

Comparison of different 600 kw designs of a new permanent magnet generator for wind power applications

VENSYS. Vensys 62 The next Generation of Gearless Wind Turbines goes into Production

EPE 18 ECCE Europe: LIST OF KEYWORDS

Electric Machines CHARLES A. GROSS. Aubum University Auburn, Alabama, U.S.A. LßP) CRC Press Vv* / Taylor & Francis Croup. Boca Raton London New York

Development and Test of a High Force Tubular Linear Drive Concept with Discrete Wound Coils for Industrial Applications

ELECTRIC MACHINES EUROLAB 0.3 kw

THE advancement in the manufacturing of permanent magnets

Renewable Energy Systems 13

English for Electrical Engineers

CHAPTER 4 MODELING OF PERMANENT MAGNET SYNCHRONOUS GENERATOR BASED WIND ENERGY CONVERSION SYSTEM

26 poles and 24 slots

Control Scheme for Grid Connected WECS Using SEIG

Design of disk type PM synchronous generator based on halbach

Transient analysis of a new outer-rotor permanent-magnet brushless DC drive using circuit-field-torque coupled timestepping finite-element method

Effect of Permanent Magnet Rotor Design on PMSM Properties

Frameless Torque Motor Series

Studies regarding the modeling of a wind turbine with energy storage

The 2019 International. Future Energy Challenge (IFEC 19)

Mathematical Modeling and Simulation of Switched Reluctance Motor

SEMA Technology Redundancy Advantages

Analysis and measurement of damping characteristics of linear generator

Review and update on MAGLEV

Unified Power Quality Conditioner with Electric Double Layer Capacitor

International Research Journal of Power and Energy Engineering Vol. 3(2), pp , November, ISSN: x

Evaluation of the Fatigue Life of Aluminum Bogie Structures for the Urban Maglev

Advanced Soft Switching for High Temperature Inverters

FTA Low Speed Magnetic Levitation Program

Real And Reactive Power Saving In Three Phase Induction Machine Using Star-Delta Switching Schemes

The Grainger Center for Electric Machinery and Electromechanics Update, May 2002

Group #26 Andrea Solano-EE Juan Valera-EE Manuel Keesee-EE Randall Lay-EE

LIMITED ANGLE TORQUE MOTORS

PERFORMANCE AND ENHANCEMENT OF Z-SOURCE INVERTER FED BLDC MOTOR USING SLIDING MODE OBSERVER

FLAT LINEAR INDUCTION PUMPS

Analysis and Design of Improved Isolated Bidirectional Fullbridge DC-DC Converter for Hybrid Electric Vehicle

Conference on, Article number 64020

Control of PMS Machine in Small Electric Karting to Improve the output Power Didi Istardi 1,a, Prasaja Wikanta 2,b

SQA Advanced Unit specification: general information

Question Number: 1. (a)

Mens et Manus. Brushless Motor Design

GREE Photovoltaic DC Inverter Centrifugal Chiller

ENERGY STORAGE FOR A STAND-ALONE WIND ENERGY CONVERSION SYSTEM

The distinguishing features of the ServoRam and its performance advantages

Multi-Port DC-DC Converter for Grid Integration of Photo Voltaic Systems through Storage Systems with High Step-Up Ratio

Design of Three Input Buck-Boost DC-DC Converter with Constant input voltage and Variable duty ratio using MATLAB/Simulink

.INTRODUCTION FIGURE[1] BASIC PRINCIPLE OF MAGLEV TRAIN

Motor Drives Training System (Stand-Alone, 120 V Version) (8036-C0)

DESIGN AND ANALYSIS OF CONVERTER FED BRUSHLESS DC (BLDC) MOTOR

Transcription:

Thompson Consulting, Inc. Overview 9 Jacob Gates Road Harvard, MA 01451 Phone: (978) 456-7722 Fax: (240) 414-2655 www.thompsonrd.com info@thompsonrd.com

Background of Principal BSEE ( 85), MS ( 92), and PhD ( 97) from MIT Full-time Polaroid 1987-1993; Polaroid consultant to 2002 Doctoral work done in the Laboratory for Electromagnetic and Electronic Systems (L.E.E.S.) at MIT in electrodynamic Maglev Consultant in analog, magnetics, power electronics, electromagnetics, magnetic braking and failure analysis Adjunct Professor at Worcester Polytechnic Institute, Worcester MA since 1998 teaching ggraduate courses in analog design, power electronics, electromechanics and power distribution. Also have taught electric motors for University of Wisconsin Industry design seminars Thompson Consulting, Inc. Overview 2

Core Technology Areas Advanced analog circuit design Custom power electronics Custom electromagnetic, electrodynamic and permanent magnet systems Magnetic suspensions and Maglev Thompson Consulting, Inc. Overview 3

Capabilities Capabilities: Analog design and simulation (Multisim, PSPICE) Power electronics design and simulation (PSIM) Custom magnetics design and simulation (FEMM, Infolytica) Prototyping EMI design and testing Thompson Consulting, Inc. Overview 4

Lens Actuator z r Iron Coil Back iron Lens Permanent Nd-Fe-Bo Magnet Air gap Thompson Consulting, Inc. Overview 5

High Power Laser Diode Driver Based on Power Converter Technology Overdrive duration set Array Driver O.D. current set OVERDRIVE Switching Array I od Laser Diode THRESH. current set TTL INPUT Array Driver -12V Drive Drive* PEAK Switching Array I th -12 I s -12 PEAK current set Power Converter R sense Diff. Amp. V sense D PWM P.W.M. See: 1. B. Santarelli and M. Thompson, U.S. Patent #5,123,023, "Laser Driver with Plural Feedback Loops," issued June 16, 1992 2. M. Thompson, U.S. Patent #5,444,728, "Laser Driver Circuit," issued August 22, 1995 3. W. T. Plummer, M. Thompson, D. S. Goodman and P. P. Clark, U.S. Patent #6,061,372, Two-Level Semiconductor Laser Driver, issued May 9, 2000 4. Marc T. Thompson and Martin F. Schlecht, Laser Diode Driver Based on Power Converter Technology, IEEE Transactions on Power Electronics, vol. 12, no. 1, Jan. 1997, pp. 46-52 Thompson Consulting, Inc. Overview 6 V c Loop Filter

Magnetically-Levitated Flywheel Energy Storage System For NASA; P = 100W, energy storage = 100 W-hrs Guidance and Suspension S N N S Flywheel (Rotating) N S S N Stator Winding N S N S S N S N z N S S N S N N S r Thompson Consulting, Inc. Overview 7

Maglev Work Contract monitor for U.S. Department of Transportation since 2001 on Urban Maglev projects Have done comparative study of worldwide Maglev systems for a major U.S. company Thompson Consulting, Inc. Overview 8

MIT Maglev Suspension Magnet M. T. Thompson, R. D. Thornton and A. Kondoleon, Flux-canceling electrodynamic maglev suspension: Part I. Test fixture design and modeling, IEEE Transactions on Magnetics, vol. 35, no. 3, May 1999 pp. 1956-1963 Thompson Consulting, Inc. Overview 9

MIT Maglev Test Fixture M. T. Thompson, R. D. Thornton and A. Kondoleon, Flux-canceling electrodynamic maglev suspension: Part I. Test fixture design and modeling, IEEE Transactions on Magnetics, vol. 35, no. 3, May 1999 pp. 1956-1963 Thompson Consulting, Inc. Overview 10

For roller coasters Permanent Magnet Brakes Braking force > 10,000000 Newtons per meter of brake Reference: http://www.magnetarcorp.com Thompson Consulting, Inc. Overview 11

Halbach Permanent Magnet Array Special PM arrangement allows strong side (bottom) and weak side (top) fields Applicable to magnetic suspensions (Maglev), linear motors, and induction brakes Thompson Consulting, Inc. Overview 12

Halbach Permanent Magnet Array Thompson Consulting, Inc. Overview 13

Variac Failure Analysis Thompson Consulting, Inc. Overview 14

Photovoltaics S. Druyea, S. Islam and W. Lawrance, A battery management system for stand-alone photovoltaic energy systems, IEEE Industry Applications Magazine, vol. 7, no. 3, May-June 2001, pp. 67-72 Thompson Consulting, Inc. Overview 15

Offline Flyback Power Supply P. Maige, A universal power supply integrated circuit for TV and monitor applications, IEEE Transactions on Consumer Electronics, vol. 36, no. 1, Feb. 1990, pp. 10-17 Thompson Consulting, Inc. Overview 16

Transcutaneous Energy Transmission H. Matsuki, Y. Yamakata, N. Chubachi, S.-I. Nitta and H. Hashimoto, Transcutaneous DC-DC converter for totally implantable artificial heart using synchronous rectifier, IEEE Transactions on Magnetics, vol. 32, no. 5, Sept. 1996, pp. 5118-5120 Thompson Consulting, Inc. Overview 17

50 KW Inverter Switch Thompson Consulting, Inc. Overview 18

Non-Contact Battery Charger Thompson Consulting, Inc. Overview 19

High Voltage RF Supply Thompson Consulting, Inc. Overview 20

60 Hz Transformer Shielding Study Thompson Consulting, Inc. Overview 21

Intuitive Analog Circuit Design Thompson Consulting, Inc. Overview 22

Power Quality in Electrical Systems Thompson Consulting, Inc. Overview 23

Contributions to Other Texts Thompson Consulting, Inc. Overview 24

Patents Details available at: http://www.thompsonrd.com/patents.htm Thompson Consulting, Inc. Overview 25

Office/Lab Facility Harvard, Massachusetts (30 miles NW of Boston/Cambridge) Thompson Consulting, Inc. Overview 26