FEATURES: Click on Series name for product info on aimtec.com 1 Watt - Converter I/O Isolation of 1500 and 3000V Operating temperature - to + o C Very low no load consumption Continuous Short circuit protection Remote On/Off Control Wide 2:1 input range pin SIP package High efficiency up to 1% Models Single output Model Input Voltage (V) Voltage (V) Current max (ma) Isolation (V) Capacitor Load (μf) Efficiency (%) AM1G-0503S-NZ 4.5-9 3.3 303 1500 2700 72 AM1G-0505S-NZ 4.5-9 5 200 1500 2200 72 AM1G-05S-NZ 4.5-9 3 1500 0 7 AM1G-0515S-NZ 4.5-9 15 7 1500 0 75 AM1G-0524S-NZ 4.5-9 24 42 1500 470 74 AM1G-03S-NZ 9-1 3.3 303 1500 2700 75 AM1G-05S-NZ 9-1 5 200 1500 2200 77 AM1G-09S-NZ 9-1 9 111 1500 79 AM1G-S-NZ 9-1 3 1500 0 0 AM1G-15S-NZ 9-1 15 7 1500 0 0 AM1G-24S-NZ 9-1 24 42 1500 470 79 AM1G-1505S-NZ -24 5 200 1500 2200 77 AM1G-23S-NZ 1-3 3.3 303 1500 2700 75 AM1G-25S-NZ 1-3 5 200 1500 2200 77 AM1G-24S-NZ 1-3 3 1500 0 1 AM1G-2415S-NZ 1-3 15 7 1500 0 79 AM1G-2424S-NZ 1-3 24 42 1500 470 77 AM1G-3S-NZ 3-75 3.3 303 1500 2700 75 AM1G-5S-NZ 3-75 5 200 1500 2200 7 AM1G-4S-NZ 3-75 3 1500 0 1 AM1G-415S-NZ 3-75 15 7 1500 0 0 AM1G-0503SH30-NZ 4.5-9 3.3 303 3000 2700 72 AM1G-0505SH30-NZ 4.5-9 5 200 3000 2200 72 AM1G-05SH30-NZ 4.5-9 3 3000 0 7 AM1G-0515SH30-NZ 4.5-9 15 7 3000 0 75 AM1G-03SH30-NZ 9-1 3.3 303 3000 2700 75 AM1G-05SH30-NZ 9-1 5 200 3000 2200 77 AM1G-09SH30-NZ 9-1 9 111 3000 79 AM1G-SH30-NZ 9-1 3 3000 0 0 AM1G-15SH30-NZ 9-1 15 7 3000 0 0 AM1G-23SH30-NZ 1-3 3.3 303 3000 2700 75 AM1G-25SH30-NZ 1-3 5 200 3000 2200 77 AM1G-24SH30-NZ 1-3 3 3000 0 1 AM1G-2415SH30-NZ 1-3 15 7 3000 0 79 AM1G-2424SH30-NZ 1-3 24 42 3000 470 77 AM1G-3SH30-NZ 3-75 3.3 303 3000 2700 75 AM1G-5SH30-NZ 3-75 5 200 3000 2200 7 AM1G-4SH30-NZ 3-75 3 3000 0 1 AM1G-415SH30-NZ 3-75 15 7 3000 0 0 F 051e R.B 1 of 5 North America only
Models Dual output Model Input Voltage (V) Voltage(V) Current max (ma) Isolation (V) 1 Watt - Converter Capacitor Load (μf) Efficiency (%) AM1G-0505D-NZ 4.5-9 ±5 ± 1500 ±0 73 AM1G-05D-NZ 4.5-9 ± ±42 1500 ±470 7 AM1G-0515D-NZ 4.5-9 ±15 ±33 1500 ±330 75 AM1G-05D-NZ 9-1 ±5 ± 1500 ±0 7 AM1G-D-NZ 9-1 ± ±42 1500 ±470 1 AM1G-15D-NZ 9-1 ±15 ±33 1500 ±330 0 AM1G-25D-NZ 1-3 ±5 ± 1500 ±0 0 AM1G-29D-NZ 1-3 ±9 ±5 1500 ±0 0 AM1G-24D-NZ 1-3 ± ±42 1500 ±470 0 AM1G-2415D-NZ 1-3 ±15 ±33 1500 ±330 0 AM1G-5D-NZ 3-75 ±5 ± 1500 ±0 7 AM1G-4D-NZ 3-75 ± ±42 1500 ±470 0 AM1G-415D-NZ 3-75 ±15 ±33 1500 ±330 0 AM1G-0505DH30-NZ 4.5-9 ±5 ± 3000 ±0 73 AM1G-05DH30-NZ 4.5-9 ± ±42 3000 ±470 7 AM1G-0515DH30-NZ 4.5-9 ±15 ±33 3000 ±330 75 AM1G-05DH30-NZ 9-1 ±5 ± 3000 ±0 7 AM1G-DH30-NZ 9-1 ± ±42 3000 ±470 1 AM1G-15DH30-NZ 9-1 ±15 ±33 3000 ±330 0 AM1G-25DH30-NZ 1-3 ±5 ± 3000 ±0 0 AM1G-24DH30-NZ 1-3 ± ±42 3000 ±470 0 AM1G-2415DH30-NZ 1-3 ±15 ±33 3000 ±330 0 AM1G-5DH30-NZ 3-75 ±5 ± 3000 ±0 7 AM1G-4DH30-NZ 3-75 ± ±42 3000 ±470 0 AM1G-415DH30-NZ 3-75 ±15 ±33 3000 ±330 0 Input Specifications Parameters Nominal Typical Maximum Units 5 4.5-9 V Voltage range 15 24 4 9-1 -24 1-3 3-75 Peak Input Voltage time 1 sec Filter Maximum Rating No load input current Input Reflected Ripple Current 1 1 1 50 4 30 55 70 Capacitor On/Off Control* ON open or Isolated; OFF high voltage level (current 5-10mA) *Note: Exceeding 20mA of control current will permanently damage the converter. V ma ma F 051e R.B 2 of 5 North America only
1 Watt - Converter Isolation Specifications Parameters Conditions Typical Rated Units Tested I/O voltage 0sec, <1mA 1500, 3000 V Resistance > 0 MOhm Capacitance 3000V Isolation,kHz, 0.1V 30 1500V Isolation,kHz, 0.1V 0 pf Specifications Parameters Conditions Typical Maximum Units Voltage accuracy 5 to % load ±2 % No Load Voltage accuracy ±5 Voltage balance Dual balanced load ±0.5 % Short Protection Continuous Short Restart Automatic restart Line voltage regulation LL~HL ±0.5 % Load voltage regulation load 5~% ±0. % Temperature coefficient ±0.02 %/ o C Transient Recovery Time % load step 2 msec Transient Response Deviation % load step ±5 % Ripple At 20MHz Bandwidth 50 mv p-p Noise At 20MHz Bandwidth 90 mv p-p General Specifications Parameters Conditions Typical Maximum Units Switching frequency % load 200 KHz Operating temperature With derating above 5 o C - to + o C Storage temperature -55 to +5 o C Case Temperature 105 o C 1.5mm from case for 10 Lead Temperature 300 Seconds o C Cooling Free air convection Humidity 95 % Case material Plastic (UL94V-0 rated) Weight 4.9 g Dimensions (L x Wx H) 0.7 x 0.37 x 0.47 inch, 22 x 9.5 x mm MTBF >1 000 000 hrs (MIL-HDBK -217F, Ground Benign, t=+ o C) NOTE: All specifications in this datasheet are measured at an ambient temperature of C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. Derating Free Air Convection 5 º C Power (%) 0 0 Safe Operating Area 20 0 - - 20 0 20 0 5 0 105 Ambient Temperature º C F 051e R.B 3 of 5 North America only
Pin Out Specifications Dimensions 1 Watt - Converter Pin Single Dual 1 - V Input - V Input 2 + V Input + V Input 3 On/Off Control On/Off Control 5 N.C. N.C. + V + V 7 - V Common CS - V.00 (0.47) 2.54 (0.10) 22.00 (0.7) PRINTED FACE 4.10 (0.1) 9.50 (0.37).00 (0.47) 2.50 (0.9) 1 2 3 5 7 2.10 (0.0) 0.300 (0.0) 9.50 (0.37) Recommended EMC 2 + Vin FUSE Optional Single MOV TVS C3 + C1 C2 Load Cd Optional Surge Optional Filter C4 Model C1 C2 C4 MOV TVS C3 2 Cd 0µF / 47nF RB10M µh - SMCJ13A - 50V 50V /3KV 1V /V -0/1A 0µF / 47nF RB10M µh - SMCJ2A - 50V 50V /3KV V /V -0/1A 330µF / 47nF RB10M µh S14K35 SMCJ4A 5µH V 50V /3KV 50V /V -0/1A 330µF / 47nF RB10M µh S14K0 SMCJ90A 5µH V V /3KV V /V -0/1A Note: Fuse is user selectable = ((Vcd Vd1 1.0) / Icntl)- 300 F 051e R.B 4 of 5 North America only
Recommended s + Vin C1 C2 2 3 Single 1 Watt - Converter Cs C3 1 7 Dual + Vin C1 C2 C3 2 3 1 7 1 1 GND Model C1 C2 C3 1 CS µf 47µF 4.7 - µh 47µF / V RB10M-0/1A 2.2-10 µh 10-22µF µf µf 47µF 4.7 - µh 47µF / V RB10M-0/1A 2.2-10 µh 10-22µF µf 10µF 1µF 4.7 - µh 47µF / V RB10M-0/1A 2.2 10 µh 10-22µF µf 10µF 1µF 4.7 - µh 47µF / V RB10M-0/1A 2.2-10 µh 10-22µF µf = ((Vcd Vd1 1.0) / Icntl)- 300 NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release.. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec s standard Terms of Sale available at www.aimtec.com. F 051e R.B 5 of 5 North America only