Temperature Sesors Normally Ope (losed o temperature rise) otact Ratig 6 MPS T 120 V 4 MPS T 240 V Voltage 0.1 to 240 volts or 12 VD 8 MPS, 24 VD 4 MPS Pressure 1,000 PSI operatig Material 303 Stailess Steel Housig *Switchig temperature rages from oe (1) to six (6) F. Other temperature settigs are available. osult factory for optios. For D applicatios, do NOT wire directly to motor. (Relay eeded.) Set Temperature ( F) 65769 140 65769 120 1.10 1.60 2.09 24" Leads 3/8" NPT 11/16" HEX How to Order osult factory for pricig ad lead time Temperature Sesor Set Temperature 140 120 ll shipmets FO Racie, WI US
Thermal ypass ssembly This thermal bypass valve is ideally suited for hydrostatic drive circuits which require fast warm-up, cotrolled fluid temperature, ad low retur lie back pressure. Whe istalled i the retur lie of a hydraulic circuit that employs a oil cooler, this device will modulate fluid temperature by either shiftig retur lie flow through the cooler, or bypassig directly to the reservoir. I additio, a builti pressure relief fuctio automatically relieves excess pressure to the reservoir should the cooler become restricted ad resultat pressure drop become too high for the cooler circuit. Stadard Shift Temperatures 100 F (38 ) 120 F (49 ) 140 F (60 ) 160 F (71 ) Full Shift (ooler Port Ope) Temperatures Shift temperature plus 25 F (14 ) #16 SE 3 PLES OOLER 5.44 (138.2) Relief Valve Settig 65 PSI (4.5 R) osult factory for other pressure settigs. Maximum Operatig Pressure 250 PSI (17 R) TNK Proof Pressure 300 PSI (21 R) Miimum urst Pressure Up to the full shift temperature: 325 PSI (22 R). bove the full shift temperature: 600 PSI (41 R). Miimum Operatig Temperature -30 F (-34 ).42 DI MOUNTING HOLE 2 PLES Maximum Operatig Temperature Shift temperature plus 75 F (24 ) Maximum Flow Ratig 60 GPM (227 l/m) I N L E T 1.88 (47.8) Leakage @ 250 PSI (17 R) ad 60 GPM (227 l/m) Ilet Flow ooler Port: b 0.5 GPM (2 l/m) maximum up to 5 F (3 ) before shift temp. b 1.0 GPM (4 l/m) maximum from 5 F (3 ) before shift to shift. Tak Port: 0.10 GPM (0.4 l/m) maximum Operatig Fluid Mieral base hydraulic fluids ostructio lumium die-cast housig 3.51 (89) Operatig haracteristics Mode 1: t temperatures below the shift temperature oil flows from ilet to tak port. Mode 2: t temperatures betwee the start of shift ad full shift the flow from the ilet port is divided betwee the cooler ad tak ports. 2.62 (67) T N K Mode 3: t temperatures above the full shift temperature ilet flow is through the cooler port. Mode 4: t temperatures above the full shift temperature the excess pressure is relieved through the tak port. For 120 F Shift Temperature MODE #1 OLD STRT-UP Up to 120 F MODE #2 WRM-UP SHIFTING 120 F to 145 F MODE #3 FULLY SHIFTED bove 145 & elow 65 PSI MODE #4 HIGH PRESSURE bove 145 & bove 65 PSI Graphic Symbol RESERVOIR OOLER LR LR LR LR Ilet Ilet Ilet Ilet INLET Tak Tak Tak Tak KEY Oil Flow Excess pressurized oil NOTE: If the temperature drops below 145 F the valve will shift back to modes 2 or 1.
Thermal ypass ssembly Pressure Drop (Mobile DTE 26 OIL) Ilet Port Thru Tak Port @ 100 F (38 ) (300 SUS) 100 90 80 70 INLET THRU TNK @ 100 DEG F (38 DEG ) (300 SUS) Ilet Port Over Itegral Relief Valve @ 170 F (77 ) (78 SUS) 140 120 100 *INLET OVER INTEGRL RELIEF VLVE @ 170 DEG F (77 DEG ) (78SUS) PSID 60 50 40 PSID 80 60 30 20 10 0 0 10 20 30 40 50 60 Flow (GPM) 40 20 0 0 10 20 30 40 50 60 Flow (GPM) Ilet Port Thru ooler Port @ 145 F (63 ) (110 SUS) 18 16 NOTE: Pressure drop show is added to relief valve crack pressure for total pressure drop. 14 12 PSID 10 8 6 4 2 0 0 10 20 30 40 50 60 Flow (GPM) Shift Temperature 65654 100 F (38 ) 65655 120 F (49 ) 65656 140 F (60 ) 65657 160 F (71 ) How to Order osult factory for pricig ad lead time Thermal ypass ssembly Pressure Settig 65 = Stadard, 65 PSI Optioal pressure settigs available i 5 PSI icremets, up to 85 PSI.
Thermostatic Temperature otroller (D) This cotroller was desiged to mout o the cooler without requirig extesive wirig or plumbig. It provides accurate temperature cotrol by cyclig the coolig fa(s) to maitai desired oil temperature. 12 or 24 Volt operatio djustable temperature settigs rage from 100 F thru 210 F For use with oe or two fa models (Relay eeded for 2 fa models ot offered by TTP) Temperature sesor provided Wirig provided for remote maual override Moutig hardware icluded Wirig Diagrams 2.00 4.50 ±.5 LK P2 (TTERY NEGTIVE) LUE P1 (FN) P3 LK (OVERRIDE) P4 RED (12 OR 24 VD) P5 YELLOW (12 VD) P6 ORNGE (24 VD) P7 GREEN (OVERRIDE) 3.50 4.00 6.50 ±.5 SWITH SETTINGS* 1-100F 4-160F 2-120F 5-180F 3-140F 6-210F 8.00 MIN LK (SENSOR GROUND) WHITE (SENSOR) #10 STUD 2X Ø.188 ±.010 otrol Dimesios ONTROL MOUNTING RKET -67367 MOTOR MOUNTING RKET M5-.8 X 20MM LG MOTOR MTG SREW M5 LOKWSHER RING TERMINL #10 STR WSHER MOTOR SENSOR WIRE WHITE INSTLL IN THIS ORDER: HEX NUT LOKWSHER FLTWSHER RING TERMINL INSULTING WSHER Sesor Dimesios 1.0 TEMPERTURE SENSOR -67699 3/8 NPT NOTE: This switch should be fused to prevet damage if groud is lost. 30 mp Fuse is required i the power supply. If maual override switch is ot used, isulate P3 lack ad P7 Gree idividually. Electrical Schematic oectio ssembly.90 ±.2 TEMPERTURE SELET SWITH FN ONTROL.12 1.12 How to Order 96171 Electroic Fa otrol Kit 68790 Replacemet otrol Oly 67699 Replacemet Sesor Oly
Three-Way Thermostatic Valves ½", ¾", 1", 1½" & 2" NPT Ports* Self-cotaied Wide rage of temperatures Rugged costructio No-adjustable Heavy duty Operate i ay positio Tamper-proof Replaceable elemet ompact Materials Housig Grey iro (steel or broze optioal) 125 PSI maximum operatig pressure O-Rig Seals Vito (ua N optioal) *3", 4" ad 6" Flage Models also available. Operatio TTP thermostatic valves use the priciple of expadig wax. self-cotaied power elemet activates a stailess steel slidig valve that provides a positive three-way valve actio. ll temperature settigs are factory set. Elemets are field replaceable to obtai the same, or a ew bypass temperature settig. O startig, total flow is i the bypass mode. s the fluid temperature rises, some fluid is diverted to the coolig system. s fluid temperature cotiues to rise, more flow is diverted util the valve is fully stroked. t this poit, all the flow is diverted to the cooler. With respect to temperature rages, the omial temperature represets the operatig temperature. Valves are acceptable for oil or water service. Heat Source Pump TTP Thermostat Mixig pplicatio TTP Thermostat TTP Heat Exchager pplicatios Three Way Thermostatic Valves may be istalled for either mixig or divertig modes of operatio at the preferece of the user. They may be mouted i ay plae. Whe istalled as a mixig valve, it is o the cold side of the applicatio, ad mixes hot liquid with cooled liquid to discharge the proper temperature fluid to the process. Whe istalled as a divertig valve, it is o the hot side of the applicatio, ad bypasses the cold liquid allowig the system to warm up, the directs the hot liquid to the cooler. Temperature settigs are omial. 110 F ad 140 F are stadard. Other settigs are available upo request. The valves begi to shift (ope) about 10 F below the omial temperature settig ad are fully shifted about 10 F above. Heat Source Pump TTP Heat Exchager Typical Istallatio Hydraulic Power Uits Divertig mode 110 F ir ompressors Mixig mode 140 F Divertig pplicatio Mobile Oil oolers Divertig mode 110 F Radiators Divertig mode 190 F
Three-Way Thermostatic Valves Pressure Drop urves ½" - ¾" - 1" 1½" SE 40 @ 140 F SE 30@ 140 F SE 40 @ 180 F SE 30 @ 180 F Pressure Drop OiL @ 150 SSU Pressure Drop Water Pressure DrOP (PSI) WTER Flow (US GPM) Not To Exceed 7 PSI Pressure Drop Flow (US GPM) Water/oil Not to Exceed 7 PSI Pressure Drop 2" SE 40 @ 140 F SE 30@ 140 F Pressure DrOP (PSI) SE 40 @ 180 F SE 30 @ 180 F WTER Flow (US GPM) Not To Exceed 7 PSI Pressure Drop Dimesios ad s HET EXHNGER 6" 3-5/8" 2" YPSS 4-1/4" HET SOURE YPSS 5-1/4" 3-3/4" 3-1/16" 6-1/8" HET EXHNGER HET SOURE 9-3/4" 3-13/16" YPSS 3-9/16" 2-7/8" HET EXHNGER HET SOURE Port Size ½" NPT 66037-110 F ½" NPT 66037-140 F ¾" NPT 66038-110 F ¾" NPT 66038-140 F 1" NPT 66039-110 F 1" NPT 66039-140 F #16 SE 67365-110 F #16 SE 67365-140 F Port Size 1½" NPT 66040-110 F 1½" NPT 66040-140 F #24 SE 67760-110 F Port Size 2" NPT 66041-105 F 2" NPT 66041-140 F NOTE: ll three ports o ay oe valve have the same thread size.
Three-Way Thermostatic Valves Special Temperature Rages ½" - ¾" - 1" NPT s 1½" NPT s 2" NPT s 65974 65977 65978 65975 66040 66041 65976 67760 66037 (#24 SE) 66038 66039 67365 (#16 SE) ½" - ¾" - 1" NPT 1½" NPT 2" NPT Nomial Temperature Rage ( F) Nomial Temperature Rage ( F) Nomial Temperature Rage ( F) 80 77-88 80 70-88 75 70-85 90 80-100 90 80-100 90 85-105 110 100-120 110 100-120 105 100-116 120 110-130 120 110-130 120 110-130 130 120-140 130 120-140 130 124-140 140 130-150 140 130-150 140 135-150 150 140-160 150 140-160 150 145-160 160 150-170 160 150-170 155 150-165 170 163-180 170 163-180 160 155-172 185 175-190 175 170-185 165 160-175 195 185-200 180 175-190 170 165-180 200 190-210 190 185-200 180 175-190 200 190-210 195 188-208 210 200-215 EXMPLE: 1 NPT, 66039-90 idicates the 1 NPT valve with a omial shift temperature of 90 F. The actual operatig temperature rage i this example is 80-100 F. The valve begis to ope at 80 F, ad is fully ope at 100 F. How to Order osult factory for pricig ad lead time F Valve Nomial Temperature Settig