Product descripption SureFire Electrical Pump DESCRIPTION The SureFire centralised lubrication system is robust and durable, capable of handling oil and fluid greases. Available in four reservoir capacities to fit your space requirements and lubrication demands. The SureFire lubricator is a self-contained electric, motor-driven gear pump that can adapt to a broad range of production machinery. It can handle single injectors or injector groups serving up to 100 lubrication points. Its versatility also allows it to perform with other lubrication systems and applications. Volumetric version schematic OPERATION As the motorized gear pump pulls lubricant in from the reservoir and delivers lubricant to the distribution system, the PDIs in the system discharge a fixed amount of lubricant to the lubrication points. After the injectors are fired, the pressure in the system continues to rise until the pressure switch setting is reached. Once the limit is reached, the pressure switch signals the motor to stop. When the momentary pressure in the distribution system becomes greater than the gear pump pressure, the pressure differential actuates a quick release valve which relieves the distribution line pressure back into the reservoir. This causes each PDI in the distribution system to reset and refill for the next cycle. Resistance version schematic 1 / 10 P_2009_6_Surefire single phase _GB
DETAILS Works with oil and soft greases. Low level switch for failsafe operation. Hydraulic outlet connections on either side. Quick snap-on reservoir. Convenient plug-in type terminal strip. Large capacity fill cap with built in strainer. Operational timer or controller/monitor. TECHNICAL CHARACTERISTICS VOLUMETRIC VERSION Output volume... 250 cc/min for 24V DC;... 200 cc/min for 115/230V AC 60Hz; 168 cc/min for 115/230V AC 50Hz Output pressure... max. 31 bar (450 psi), 20 bar (300 psi) Lubricant viscosity... 20 to 1500 Cst on operating temperature Soft grease *... NLGI 000 / NLGI 00 Inlet filter... sieve 120 µm Reservoir capacity... 1,8 L / 2,7 L / 6 L / 12 L Motor voltage options... 24 V DC, 2.4 A; 115/230 V AC, 2.2/0.95 A, 50/60 Hz Motor power requirement.. Around 140 Watts Operating temperature range... + 5 o C à + 40 o C IP rating... IP 54 Electrical fitting... Liquid tight Output connection... G ¼ BSPP Capacitive grease level control..... 12-24VCC 15mA Max Oil floating level controller...... 230 V Max power cut 40 V A Pressure switch....250 V Max power cut 5 A maxi Main line... Ø ext. Min. recomended 6 mm * contact a bijur technician for soft grease application TECHNICAL CHARACTERISTICS RESISTANCE VERSION Output volume... 250 cc/min en 24V DC;... 200 cc/min en 115/230V AC 60Hz; 168 cc/min en 115/230V AC 50Hz Output pressure... max. 5 bars (75 psi), pressure switch 1.4 bars +/- 0.3 bar (20 psi) Lubricant viscosity... 20 à 1500 Cst on operating temperature Inlet filter... sieve 120 µm Reservoir capacity... 1,8 L / 2,7 L / 6 L / 12 L Motor voltage options... 24 V DC, 2.4 A; 115/230 V AC, 2.2/0.95 A, 50/60 Hz Motor power requirement. Around 140 Watts Operating temperature range... + 5 o C à + 40 o C IP rating... IP 54 Electrical fitting... Liquid tight Output connection... G ¼ BSPP Grease level control capacity...... 230 V Max power cut 40 V A Pressure switch...250 V Max power cut 5 A maxi Main line... Ø ext. Min. recommanded 6 mm 2 / 10 P_2009_6_Surefire single phase _GB
HOW TO ORDER Define the correct reference using the code below : Pump code S F Reservoir capacity 2 1,8 Litres plastic 3 2,7 Litres plastic 6 6 Litres plastic 12 12 Litres metal Distribution system A B Resistance Volumetrique Options N A B C D Standard oil version Snap on connector for grease Standard version for grease Snap on connector for oil Two tier level switch Programmation A C Terminal strip Controller Voltage B C D 24 V CC 115 V AC 50/60 Hz 230 V AC 50/60 Hz Electrical fitting A M 12 X 1 Example: To order a 2.7L SureFire pump for a volumetric system (PDI) without option controller and with a motor 230V AC and connected M12x1: SF 3BNCDA NB : The «C» option «snap-on connector for oil» including a two-tier level switch. 3 / 10 P_2009_6_Surefire single phase _GB
SUREFIRE PUMP 1,8 LITRES Item Description Quantity 1 Oil output G ¼ BSPP 1 2 Electrical fitting 1 3 Manual prelub 1 4 Lubrication LED 1 5 Pressure gauge 1 6 Filler cap 1 7 Plastic reservoir 1 8 Low level control NO 1 9 Pressure switch NO 1 4 / 10 P_2009_6_Surefire single phase _GB
SUREFIRE PUMP 2,7 LITRES Item Description Quantity 1 Oil output G ¼ BSPP 1 2 Electrical fitting 1 3 Manual prelub 1 4 Lubrication LED 1 5 Pressure gauge 1 6 Filler cap 1 7 Plastic reservoir 1 8 Low level control NO 1 9 Pressure switch NO 1 5 / 10 P_2009_6_Surefire single phase _GB
PUMP SUREFIRE 6 LITRES Item Description Quantity 1 Oil outlet G ¼ BSPP 1 2 Electrical fitting 1 3 Manual prelub 1 4 Lubrication LED 1 5 Pressure gauge 1 6 Filler cap 1 7 Plastic reservoir 1 8 Low level control NO 1 9 Pressure switch NO 1 6 / 10 P_2009_6_Surefire single phase _GB
ELECTRIC OUTLET CONNECTION The user connects the pump via 2 connectors M12 to IEC 60947-5-2 standard. The C1 connector has 5 pins. The C2 connector has 8 pins and is the signal connector. The main connector is usualy created for applications in CA, it has a pin on earth and a cabling of 0.75mm², estimated for 4A to 250 Vac. The connector signal has an inner wiring 0,25 mm², each cable being suitable for 2A to 30 Vdc. To connect the cables : All cables must follow the norms IEC 60227 or IEC 60245. Mains cables must be minimum 0,75mm2 CSA Signal cable must be minimum 0,25mm2 CSA Connectors must follow the norms IEC 61076-2-101 or IEC 60947-5-2. Section 11.2 includes a detailed list of cabling accessories available. These cables can be directly supplied by Bijur Delimon. If purchased elsewhere please ensure recommended norms are respected. In case of any doubt, please contact your local Bijur technician.. Connector 1 - Supply Pin Nbr Description Color 1 V (+ve) Brown 2 n/a White 3 V (-ve) Blue 4 n/a Black 5 Earth Yellow/green Connector 2 - Signal Pin Nbr Description Color 1 K1 (n/c) White 2 K2 (n/c) Brown 3 K3 (n/o) Green 4 K Common Yellow 5 Pulse switch Grey 6 Pulse switch Pink 7 n/a Blue 8 Air contact pressur Red 7 / 10 P_2009_6_Surefire single phase _GB
Cabling with connector M 12 x 1 : Cable Code M 12 Number of poles 5 5 poles (power) 8 8 poles (signal) Connector type A Elbow at 90 S Straight Cable length 02 Length 2 m 05 Length 5 m 10 Length 10 m Anti-interference duct U No sheathed power S Sheathed signal Wire section 75 75 mm² 25 25 mm² Connector without cable : Straight connector 5 poles : reference 23694 Elbow connector 5 poles : reference 236941 Straight connector 8 poles : reference 23837 Elbow connector 8 poles : reference 23842 8 / 10 P_2009_6_Surefire single phase _GB
MAINTENANCE DESCRIPTION REFERENCE Maintenance kit for 1,8 L 23374 Maintenance kit for 2,7 L 23375 Maintenance kit for 6,0 L 23376 Fuse 5A (Controller version) 27993 Pressure switch for volumetric pump version (PDI) 23472 Pressure switch for resistance version (SLR) 23545 Oil level control for a 1,8 L et 2,7 L versions 34797 Oil level control for a 6 L et 12 L versions 34798 Version 1,8 L et 2,7 L two tier level switch 23396 Capacitive level control grease version 23470 Pressure gauge volumetric version (PDI) 0-60 Bar 23411 Pressure gauge resistance version (SLR) 0-11 Bar 23522 Motor 24 V DC 27632 Motor 115/230 V AC 50/60 Hz 26342 9 / 10 P_2009_6_Surefire single phase _GB
Bijur Delimon Bijur Delimon Bijur Delimon Germany Spain France Arminstraße 15 Avda. Txori-Erri 38 BP 50 D-40227 Düsseldorf 48150 Sondica - (Vizcaya) ZI de Courtabœuf Postfach 10 20 52 Tel : (34) 94 453 20 00 5, Avenue de I'Atlantique D-40011 Düsseldorf Fax : (34) 94 453 25 00 91942 Courtaboeuf Cedex Tel: (49) 211 7774 0 www.bijurdelimon.com Tel : (33 )1 692 985 85 Fax : (49) 211 7774 210 Fax : (33) 1 690 776 27 info@delimon.de contact@bijurdelimon.com www.bijurdelimon.com www.bijurdelimon.com Bijur Delimon United Kingdom Bijur Delimon Ramsden Court, Ramsden Road No B-5 & 6, A Block, SNS Arcade, & Rotherwas Industrial Estate Airport Road (HAL),BANGALORE Hereford India Bijur Delimon HR2 6LR 560010 Niederlassung Beierfeld Tel : +44 (0) 1432 365 000 Tel : (91 0 )80 2522 1541 / 3959 / 652 Am Bockwald 4 Fax : +44 (0) 1432 365 001 mksantosh@bijurdelimon,in D-08344 Grünhain-Beierfeld info@delimon.co.uk www,bijurdelimon,com Tel : (49) 377 475 65 11 0 www.bijurdelimon.com Fax : +(49) 377 746511 0 Bijur Delimon Ireland Bijur Delimon Gort Road Austria Bijur Delimon Ennis, county Clare Am Spitz 2-3 / Schloßhofer Str. 4-6 USA Ireland Stiege 4, Top 20 2100 Gateway center Tel : 353 65 682 1543 A-1210 Vienna Blvd suite 109 Fax : 353 65 682 0327 Tel : (43) 1 585 66 17 Morrisville NC 27560 www.bijurdelimon.com Fax : (43) 1 585 66 17 50 Tel : +1 919 465 44 48 info@delimon.at Fax : +1 1 919 465 0516 Bijur Delimon www.delimon.at www.bijurdelimon.com China www.bijurdelimon.com 9 Heng Tong Road Nanjing Economical And Technical Development zone 2100038 Nanjing Tel : +86 258 580 1188 Fax : +86 85802277 www.bijurdelimon.com 10 / 10 P_2009_6_Surefire single phase _GB