COMMISSIONING Model SN= Software version= Registration of A/C service station calculation on www.brainbee.com/ (reserved area) Registration code= Software available by Clima Solution Software version = Software updating by USB dongle - YES - NO A/C service station initial verification Remove screw under gas scale Gas weight zero Oil weight verification First internal cylinder fill A/C service station first filling by external refrigerant bottle Refrigerant quantity filled: kg A/C service station parameters setup Car s A/C system service car model: Quick mode Zero tolerance Vehicle s refrigerant amount: g Oil kind PAG-xx or POE-xx: Oil injection mode: Vacuum time: Vacuum test time: ECO LOCK procedure Operation control Pressure check on Car s A/C system Environmental T. = C LP= bar HP= bar SHORT BRAIN BEE 2016 ESERCIZI SV-0307-04[1] REV3.DOC 1/5
SERVICE Model: SN: Installation of CLIMA UPDATE software on technician PC Installation of CLIMA SOLUTION software on technician PC Pneumatic circuit schema (to write the electro valves letter involved on phase) electro valves involved: Recovery Vacuum. Oil/tracer injection Recharge.. Not condensable gas discharge (air purge).. Gas scale weight calibration - Reference weight used = Oil scale weight calibration - Reference weights used = Pressure calibration - Reference gage - used = Touch screen calibration (only for touch screen models) Long life pump after work time = hours Vacuum pump oil replacement after work time (max) = hours Dryer filter periodical change every = kg (R134a) kg (R1234yf) Metrological verification Gas scale weight verification Ref. weight = A/C Station Reading = Error = Pressure verification Ref. pressure gage reading = A/C Station Reading = Error = SHORT BRAIN BEE 2016 ESERCIZI SV-0307-04[1] REV3.DOC 2/5
REPAIR Model SN= Manual activation (inside Service Menu password BRN ): open electro valve OUT R and read gauges: open electro valve OUT I and read gauges: close electro valve OUT R & OUT I, open electro valve OUT A, start OUT C for 5 minutes, then stop all valves and read gauges: Manual activation (inside Service Menu password BRN ): Replacement of components connected to refrigerant circuit How to empty refrigerant by manifold, which manual and electro valves are involved? Please describe the procedure: Manual valves closed on refrigerant s internal tank: inlet outlet Electro valves opened: R L T I V A N S C Pump or compressor activated: Pump Compressor Pressure gages reading: Cleaning and/or replacement of refrigerant OUT A solenoid valve: Cleaning and/or replacement of oil/tracer check-valve (one way valve): Replacement of pressure sensor: Replacement of electronic logic board, actions carried out: SHORT BRAIN BEE 2016 ESERCIZI SV-0307-04[1] REV3.DOC 3/5
BRAIN BEE 6000 PLUS R L I V A S C Recovery phase? R I V A N S C Vacuum phase? R I V A N S C Oil/Tracer injection phase? R I V A N S C Recharge phase? R I V A N S C Not condensable discharge phase? R I V A N S C Attendee: / / SHORT BRAIN BEE 2016 ESERCIZI SV-0307-04[1] REV3.DOC 4/5
BRAIN BEE 6000 ECO R I V A N S C Recovery phase? R I V A N S C Vacuum phase? R I V A N S C Oil/Tracer injection phase? R I V A N S C Recharge phase? R I V A N S C Not condensable discharge phase? R I V A N S C Attendee: / / SHORT BRAIN BEE 2016 ESERCIZI SV-0307-04[1] REV3.DOC 5/5