Telephone: Fax: VAT Registration No.:

Similar documents
Telephone: Fax: VAT Registration No.:

Telephone: Fax: VAT Registration No.:

Telephone: Fax: VAT Registration No.:

Telephone: Fax: VAT Registration No.:

VOLKS CITY BEECH AVENUE CATTEDOWN PLYMOUTH PL4 0QQ

5. Engine Control Module (ECM) I/O Signal

Engine management/transmission

5. Engine Control Module (ECM) I/O Signal

2-17 CABLE/HARNESS ROUTING SERVICE INFORMATION 1 IAC VALVE 2P CONNECTOR. 11 No.1 INJECTOR 2 TP SENSOR 3P CONNECTOR 2P CONNECTOR

C915 - A147 Powertrain control module (PCM) C916 - A7 ABS control module

PGM-FI ( Models)

3. Engine Control System Diagram

PGM-FI (All Models except D16B5; D16Y5 with M/T)

Troubleshooting Self-diagnostic Procedures

DTC Summaries. NipponDenso V12 Engine Management

TROUBLE DIAGNOSIS. ECM Harness Connector Terminal Layout. ECM Terminals and Reference Value EC-107

Fuel control. The fuel injection system tasks. Starting fuel pump (FP)

For Troubleshooting of DTC related components, see chart on page INTAKE AIR BYPASS (IAB) HIGH CONTROL SOLENOID

Oxygen sensor control,

1996 Mustang. 1. Remove air cleaner outlet tube (9B659). Refer to Section Disconnect battery ground cable (14301). Refer to Section

ECT SENSOR 2 2P CONNECTOR. Clamp the main wire harness and the ECT sensor 3 wire as shown.

SYTY Trouble Code: ALDL INFORMATION

1. Connect the Honda PGM Tester or an OBD II scan tool to the 16P Data Link Connector (DLC) located behind the right side of the center console.

Zoom and Print Options

Powertrain DTC Summaries EOBD

1993 ENGINE PERFORMANCE Volkswagen System & Component Testing - Digifant. EuroVan

TOYOTA TUNDRA NEW FEATURES. The main components of the 2UZ-FE engine control system are as follows:

TROUBLESHOOTING FOR EFI ELECTRONIC CIRCUIT WITH VOLT/OHMMETER

DIAGNOSTIC TROUBLE CODE CHART

2003 Taurus/Sable Workshop Manual

7. Remove the starter motor. Refer to Starter Motor Replacement (2.2L) or Starter Motor Replacement (4.3L).

BUZZERS, RELAYS & TIMERS

G - TESTS W/CODES - 2.2L

Oxygen sensor control,

DTC P2100, P2103 THROTTLE CONTROL MOTOR RELAY

Powertrain DTC Summaries EOBD

Transmission Electronic Control System

PSI ENGINE CODES CODE LIST

A: ENGINE CONTROL MODULE (ECM) I/O SIGNAL FOR MT VEHICLES. Signal (V) Ignition SW ON (Engine OFF) B B B

DIAGNOSTIC TROUBLE CODE CHART (SAE Controlled)

Data Unit Value Coolant temperature 0.436V (130 ) ~4.896V (-40 )

Auto Diagnosis Test #7 Review

VOLKS CITY BEECH AVENUE CATTEDOWN PLYMOUTH PL4 0QQ

5. Control System CONTROL SYSTEM FUEL INJECTION (FUEL SYSTEM) A: GENERAL. FU(STi)-27

SECONDARY PARAMETERS AND ENABLE CONDITIONS

Fuse and Relay Information

5. Main Components of Engine Control System

Fuel Metering System Component Description

FUEL 13-1 CONTENTS MULTIPOINT INJECTION (MPI)... 2 GENERAL INFORMATION... 2 SERVICE SPECIFICATIONS... 3 SEALANT... 3 SPECIAL TOOLS...

Appendix B. Data Parameters. Current and Past TMC Engines Covered in this Section. Fig. B-1. TL874fB01. Engine Control Systems II - Course 874 B-1

1991 TOYOTA Electrical Components MR2. evaporator. compartment. ARTICLE BEGINNING BUZZERS, RELAYS & TIMERS

Stop Lamp Switch. STP or BRK. Stop Lamps

DIAGNOSIS SYSTEM DESCRIPTION EG2 170

PROBLEM SYMPTOMS TABLE

DTC P0300 Random / Multiple Cylinder Misfire Detected. DTC P0301 Cylinder 1 Misfire Detected. DTC P0302 Cylinder 2 Misfire Detected

SPEED SHIFT/TWO-STEP MODULE INSTALLATION MANUAL

2. Disconnect the accelerator control cable and the cruise control cable from the throttle body. 3. Disconnect the vacuum hose from the throttle body.

JACKAROO TIPS Understanding the MIL fault codes on a Jackaroo Turbo Diesel

Powertrain DTC Summaries OBD II

ECU Pinout Chart 2002 WRX Engine Control Module (ECM) I/O Signals. Wire Ignition SW Color ON Engine ON (Idling)

2001 Lincoln LS V6-3.0L DOHC VIN S Vehicle > Powertrain Management > Diagrams > Electrical - Interactive Color (Non OE) Engine Controls - Page 1 of 4

Motronic September 1998

If a single test is completed entirely, but indicated as "not OK", a DTC will be stored in DTC memory. Check DTC Memory Page

5. Engine Control Module (ECM) I/O Signal S008526

Powertrain DTC Summaries EOBD

5. Control System CONTROL SYSTEM FUEL INJECTION (FUEL SYSTEM) A: GENERAL FU(H4DOTC)-29

Service Bulletin. DTC Detection Item Associated Monitor

ON-BOARD DIAGNOSTICS II SYSTEM. 5. Specified Data. Signal (V) Ignition SW ON (Engine OFF)

Position of Parts in Engine Compartment

ENGINE IMMOBILISER SYSTEM

RX8 - Workshop Manual - Engine

MULTIPOINT FUEL INJECTION (MPI) <4G63-Turbo>

TELORVEK EFI 5.0 Coyote Sequential Fuel Injection System Part # CY-11

Fuel System (Central SFI)

rear RH side of engine compartment in E-Box AGS transmission control module Component connector (9-pin, Blue), AGS transmission control module

G ELECTRICAL WIRING ROUTING

DATA LIST/ACTIVE TEST

Fig.11 Powertrain Control Module (PCM)

PERFORMANCE SYSTEMS INTEGRATION

Electronics III Sensors

cylinder cars / trucks (except Saturn S-series cars) ENGINE DIAGNOSTIC PARAMETERS

INSTALLATION. Engine. All vehicles. 1. Install the special tool to the threaded hole located at the LH side of the engine block.

Position of Parts in Engine Compartment

VOLKS CITY BEECH AVENUE CATTEDOWN PLYMOUTH PL4 0QQ

20 C (68 F) Ω C (68 86 F)

OBD-II Diagnostic Powertrain (P) Trouble Codes

BUZZERS, RELAYS & TIMERS

ENGINE CONTROL (5VZ-FE)

1ZZ-FE ENGINE CONTROL SYSTEM SFI SYSTEM

Electronics III Sensors

MULTIPOINT FUEL INJECTION (MPI) <4G9>

Position of Parts in Engine Compartment

01 03B SYMPTOM TROUBLESHOOTING [ENGINE CONTROL SYSTEM (FS)]

G ELECTRICAL WIRING ROUTING

1993 ENGINE PERFORMANCE Volkswagen Self-Diagnostics. EuroVan

2AZ-FE ENGINE CONTROL SYSTEM SFI SYSTEM TERMINALS OF ECM. Terminal No. (Symbols) Wiring Color Terminal Description Condition Specified Condition

ENGINE CONTROL SYSTEM. 1. General ENGINE 3VZ FE ENGINE

ATASA 5 th. Detailed Diagnosis & Sensors. Please Read The Summary

Powertrain Management: Electrical Diagrams Fuel Injection System

2.8 Liter VR6 2V Fuel Injection & Ignition, Engine Code(s): AAA m.y

Transcription:

Telephone: Fax: VAT Registration No.: Terminal side Wire side Component/circuit description ECM pin Signal Condition Typical value Oscilloscope setting (Suggested settings - Voltage/time per division) Wave form AC compressor clutch relay 54 Engine idling - AC ON AC compressor clutch relay 54 Engine idling - AC ON - accelerator pedal briefly fully depressed 0-1 V briefly Air conditioning 10 Engine idling - AC OFF Air conditioning 10 Engine idling - AC ON - AC compressor ON Battery 1 Ignition OFF Brake pedal position (BPP) - 1990-96 18 Ignition ON - brake pedal released Brake pedal position (BPP) 18 Ignition ON - brake pedal depressed Crankshaft position (CKP) - without integral 56 Engine idling 45 Hz Crankshaft position (CKP) 56 Engine idling 5 V/20 ms Data link connector (DLC) 1 Data link connector (DLC) 48

Digital multifunction display - 1992-96 34 Earth 20 Ignition ON Earth 40 Ignition ON Earth 49 Ignition ON Earth 60 Ignition ON Earth - brown wire 28 Ignition ON Earth - some models 5 Ignition ON Earth - without integral 16 Ignition ON Engine control relay 3 Ignition OFF Engine control relay 3 Ignition ON Engine control relay 5 Ignition OFF Engine control relay 5 Ignition ON Engine control relay - 1992-96 22 Ignition ON 0-1 V briefly then 11-14 V Engine control relay 22 Engine cranking 0-1 V temp. 0 C 3,8-3,9 V temp. 20 C 3-3,2 V temp. 80 C 0,6-0,9 V - 1993-96 46 Ignition ON 49 Ignition ON - valve not Engine under load - engine hot - valve 3-14 V Ignition ON Engine running - valve 1/50 ms backpressure transducer - if fitted 26 Ignition ON 5 V backpressure transducer 2 Ignition ON 0,4-3,9 V - varies with pressure backpressure transducer 46 Ignition ON - if fitted 1986-89 Accelerate briefly - engine hot 9-14 V Ignition ON Engine running - valve 5 V/20 ms Fuel flow - 1986-91 34 Fuel pump relay - 1986-91 22 Ignition ON 0-1 V briefly then 11-14 V Fuel pump relay 22 Engine cranking 0-1 V

Heated oxygen (HO2S) - 1986-88 Heated oxygen (HO2S) - LH 1989-96 Heated oxygen (HO2S) - RH 1989-96 Heated oxygen s (HO2S) - 4-wire 29 0,1-0,9 V fluctuating 0,2 V/1 sec. 43 0,1-0,9 V 0,2 V/1 sec. 29 0,1-0,9 V 0,2 V/1 sec. 46 Heated oxygen s (HO2S) 49 Idle adjustment connection - blue/yellow wire 28 Ignition ON or 5 V Idle air control (IAC) valve 21 9,5-11 V 2 V/5 ms Ignition amplifier 36 Engine idling 45 Hz 2 V/10 ms Ignition amplifier - with integral 16 Ignition ON Ignition amplifier 56 Engine idling 45 Hz 5 V/20 ms Injectors - group A 58 Ignition ON Injectors 58 Engine idling 2,3 ms 1/2 ms Injectors - group B 59 Ignition ON Injectors 59 Engine idling 2,3 ms 1/2 ms 0 C 3,8-3,9 V 20 C 3-3,2 V 40 C 2-2,2 V - 1993-96 46 Ignition ON 49 Ignition ON 26 Ignition ON 5 V 45 Ignition ON 10 Hz 45 Engine idling - engine cold 120 Hz - 1993-96 45 110 Hz 45 00 rpm 105 Hz 46 Ignition ON 49 Ignition ON Octane coding plug - if fitted 23 Ignition ON or 5 V Octane coding plug 24 Ignition ON or 5 V - 1986-91 Ignition start position - AT not in P or N Ignition start position - AT in P or N - engine cranking 0-1 V - 1992-96 Ignition ON - AT not in P or N

Ignition ON - AT in P or N 0-1 V (PAIR) - some models 1986-89 51 Engine idling - engine cold 9-14 V (PAIR) 51 (PAIR) 51 Ignition ON Throttle position (TP) 26 Ignition ON 5 V Throttle position (TP) 46 Ignition ON Throttle position (TP) 4 Throttle position (TP) 4 Ignition ON - throttle closed Ignition ON - throttle fully open 0,5-0,9 V 4,3-5 V Throttle position (TP) - 1993-96 49 Ignition ON Transmission kick-down relay/ - 1990-96 19 Ignition ON - accelerator pedal released Transmission kick-down relay/ 19 Ignition ON - accelerator pedal fully depressed Transmission modulator 53 Ignition ON 9-12 V Transmission modulator - 1990-96 15 Ignition ON 9-12 V Vehicle speed (VSS) 3 Ignition ON - vehicle pushed or Vehicle speed (VSS) 3 Vehicle moving 5 V/50 ms 4. Digital, DC, frequency modulated 20. Digital, DC, pulse width modulated or digital, DC, frequency modulated 21. Analogue, DC

29. Digital, DC, pulse width modulated or digital, DC, frequency modulated 32. Digital, DC, frequency modulated 35. Digital, DC, pulse width modulated 43. Digital, DC, frequency modulated input/output signal input signal output signal ECM ed earth ECM earth circuit