113 North Griffith Rd. P.O. Box 625 Carroll, Iowa 51401 Phone: 712-792-3143 Fax: 712-792-6658 WATS: 1-800-568-2403 E-mail: sales@feldfire.com Website: www.feldfire.com Member: NFPA, NAFED, I.A.F.C., I.F.A., I.F.C.A. Comprehensive Hydraulic Rescue System Inspection and Maintenance Agreement Revision 1 Effective 1/1/2010 Department: Cost of Agreement: $600.00 for first system per year $350.00 for each additional system per year (System is defined as: AMKUS Power Unit (, Spreader (, Cutter(, Rams () Additional tools or systems to be billed additionally. Individual Tools: Power Unit Spreader Cutter Combination Tools Rams Extension Hoses & Reels $350.00/year $75.00/year $75.00/year Terms of Agreement: 1. Billing terms: Net 30 days from invoice date. 2. Ed M. Feld Equipment Co., Inc. agrees to perform the services listed under service performed to customer during each agreement period. 3. Ed M. Feld Equipment Co., Inc. will furnish written documentation for all services performed. 4. A factory-trained technician will perform all services in accordance with manufacturer s recommendations. 5. Service will be performed at customer s location. If available a complete set of rescue tools will be placed on customer s vehicle for use while their system is out of service. 6. Any suggestion of replacement of external/internal parts which are damaged or worn will be discussed with the customer prior to replacing with cost estimates provided. This estimate will include parts and labor rates and will be billed in addition to the contract rates. This may include parts, labor and drive time. 7. Drive time is included to one facility. Additional drive time to another facility or additional trips to original facility will be billed to the fire department or facility. 8. Ed M. Feld Equipment Co., Inc. will supply only genuine AMKUS Rescue System parts and/or accessories.
Service Performed Hydraulic Power Unit: 1. Clean and inspect for wear and damage 2. Inspect hydraulic hoses for cuts and/or abrasions. 3. Clean and check quick disconnects for proper operation. 4. Check line pressure and adjust pressure relief valve, if needed. 5. Refill reservoir with clean mineral base hydraulic fluid. 6. Change engine oil according to manufacturer recommendations. 7. Clean and service air cleaner. 8. Inspect and clean spark plug. 9. Start engine and adjust carburetor, if necessary. 10. Perform line pressure test on side A and side B. Spreader: 1. Clean and inspect for excessive wear or damage. 2. Remove arms, clean and inspect pivot area, rack and gear assembly. 3. Remove rack shield and straighten, if needed. 4. Lubricate rack, spreader arm gear and pivot pins. 5. Clean and inspect fittings, hoses and quick disconnects. 6. Check line hydraulic pressure. Cutter: 1. Clean and inspect for excessive wear or damage. 2. Remove, clean and inspect center bolt, blades, knuckle housing, friction plates, and cutter housing. 3. Check friction plate roll pins for proper clearance and adjust, if needed. 4. Clean and inspect fittings, hoses, and quick disconnects. 5. Check line hydraulic pressure. Rams: 1. Clean and inspect for wear or damage. 2. Inspect ram shaft for burrs or rust. 3. Inspect ram head threads. 4. Inspect top and bottom cap for leaks. 5. Inspect top cap wiper seal for excessive leakage. 6. Inspect and clean fittings, hoses and quick disconnects. 7. Check line hydraulic pressure. 8. Hydraulic Extension Hoses and/or Hydraulic Reels: 9. Clean and inspect for cuts and abrasions. 10. Pressure test. 11. Inspect and clean hose fittings and quick disconnects.
SUMMARY AMKUS LIFETIME WARRANTY EXPLANATION Amkus full warranty outline is attached to this contract. If not please request a copy. Exclusions to Warranty Program: 1. Warranty only applies to the original purchaser of the Amkus Rescue Tools and Equipment 2. Damage caused by accident, and unreasonable use of neglect, deterioration, wear & tear, or mishandling 3. Damage occurring during shipment (claims to be made at time of delivery to carrier) 4. Damage to or deterioration of any accessory other than Amkus accessories. 5. Damage & breakages from failure to follow instructions contained in your owner s manual & use of tools in operation other than reasonable extrication & other rescue. 6. Damage resulting from repairs or alterations by someone other than Amkus or an authorized Amkus Service Center such as Ed M. Feld Equipment Co., Inc.. 7. Defects in electric or gas motors which are sold with the Amkus products. These are separately warrantied by the manufacturer of the motor under their separate warranty. Who Pays for What?: Amkus will pay labor & material for a period of one year. If necessary repairs are not covered by this warranty, or if a unit is examined which is not in need of repair, you will be charged for the repairs or the examination. (This may include parts, labor and drive time) You must pay any shipping charges incurred in getting your Amkus product to Ed M. Feld Equipment Co., Inc., the Certified Service Center or to Amkus Direct. Amkus will pay return shipping charges if the repairs are covered by the warranty. Amkus will not reimburse for shipping to the Ed M. Feld Equipment Co., Inc. or the factory at any time. MODIFICATIONS Absolutely no modifications, changes or additions to this agreement shall be binding upon Ed M. Feld Equipment Co., Inc. unless expressly consented to in writing. DAMAGES Ed M. Feld Equipment Co., Inc. shall not be liable to the customer for any damages of any kind or nature, to include consequential damages, damages to property, damages for loss of use, loss of time, loss of profits, loss of income, personal injuries of subsequent use of the equipment by the customer, employees, servants, agents, successors or assignees.
ENTIRE AGREEMENT This agreement contains the entire and complete understanding of the parties as to this transaction and does not contain all the warranties, representation, promises and agreement made by them and Ed M. Feld Equipment Co., Inc. and shall not be bound by any warranties, representations, promises or agreements pertaining to this transaction unless produced in writing and signed by an authorized representative of Ed M. Feld Equipment Co., Inc. The purchaser acknowledges that he/she has read and does understand all of the terms and conditions of this agreement, to include the limitation of warranties and liabilities of Ed M. Feld Equipment Co., Inc. Signature Section First System Price: $600.00 Additional Systems: List number of additional systems: Additional Tools: List additional tools: Total Cost for Agreement: Customer: Address: City/State/Zip: Signature: Date: Name Printed: Title: Please fax, mail or e-mail agreement to the following: Fax: 712-792-6658 Mail: E-Mail: Ed M. Feld Equipment Co., Inc. 113 N. Griffith Rd. Carroll, IA. 51401 Attn: AMKUS Service Contract sales@feldfire.com Signature: Date: Ed M. Feld Equipment Co., Inc. Representative
TOOL REGISTRATION FOR MAINTENANCE CONTRACT The following tools are under contract for a maintenance agreement for. This contract will expire on. Service performed on. Equipment Model Number Serial Number AMKUS Spreader AMKUS Cutter AMKUS Combination Tool AMKUS Ram AMKUS Power Unit AMKUS Hose (length, color) AMKUS Hand Pump AMKUS Air Pump AMKUS Accessories 5)