Square HeadTM Concrete Vibrators TM wycotool.com
TM Electric Square Head Concrete Vibrators Performance and Productivity End cap protects switch Heavy-duty protective frame Radial fan - motor runs cooler, lasts longer Optional steel quick-disconnect Heavy-duty aluminum motor housing Convenient filter location Resilient rubber frame support to absorb impact C LISTED 3LFS US Leading the industry for over fifty years, Wyco Tool s Electric Square Head Vibrator is the industry standard for quality concrete consolidation. Wyco s exclusive SQUARE HEAD design provides these benefits: Scientifically proven to consolidate concrete 20 50% faster in the first 15 seconds* 22% more surface area compared to a round head Constantly changing vibration pattern which reduces post holing One piece head housing is milled from solid square stock and has no threaded tip joints to wear out Wyco s Square Head provides higher force levels, greater amplitude, longer wear, and unmatched reliability. *Name and report upon request UL is a registered trademark of Underwriters Laboratories Inc. Consolidated 26 seconds with ROUND head Consolidated 15 seconds with SQUARE head 2 wycotool.com
TM Electric Square Head Concrete Vibrators The Square Head Advantage Wyco Tool s high-efficiency motor design operates at less than 65% of full load capacity under normal job conditions. It maintains speed under heavy loads which allows the use of longer shafts and larger diameter heads. Unrestricted air flow and high volume fan reduce operating temperatures. The 992A (12 amp motor) will drive four head sizes: 13/16", 1", 1-3/8", and 1-3/4". The 993 (15 amp motor) will drive five head sizes: 1-3/8", 1-3/4", 2", 2-1/4", and the 2-1/2" SBI short head. Optional polyurethane coated heads are also available to protect and maintain the integrity of epoxy coated rebar. The Square Head pattern The unique ever-changing, multiple flat sided, polygonal orbit of the Wyco Square Head is more energy efficient and more effective in reducing cavitation (post-holing) assuring faster and more complete consolidation, especially in low slump concrete. Wyco Vibrator Selection Chart Motor Core/Casing Shaft Core & Casing Head CK-8900 750-D 13/16" series 750-EH 1" 992A CK-9500 series *750-FI 1-3/8" 750-GI 1-3/4" 993 CK-9500 series *750-FI 1-3/8" 750-GI 1-3/4" *750-LI 2" 750-MI 2-1/4" *750-SBI 2-1/2" *Optional Polyurethane Heads 750-SBIPC 750-FIPC 750-LIPC Shafts: Available in 2, 5, 7, 10, 14, and 20 foot sections Optional Accessories: Shaft connector Quick-disconnect kit Carrying strap Shaft grease and head oil Shaft Extension Combinations Motor Shaft Connector Shaft Head **992A 993 CK-9500 series 4740 CK-9500 series Use above chart to select a head which will connect to the appropriate shaft ** 992A motor with a CK-9500 series shaft can be used with the FI, GI and SBI heads. NOTE: Do not use the LI or MI head with the 992A motor. 800-233-9926 3
TM Electric Square Head Concrete Vibrators The Square Head Advantage Ordering Information wycotool.com 4
Square Head TM Backpack Concrete Vibrator Lightweight, Portable and Full Powered Utilizing a powerful two stroke engine, the 402BP is a full powered gas vibrator capable of powering any size Square Head at electric vibrator speeds. Designed with a diaphragm carburetor and no low oil shutoff, the operator is free to move about the jobsite. The backpack model also features a digital tachometer to supply the operator with engine speed and total operating hours. The cast aluminum housing contains direct drive hardened steel gears that doubles engine speed no belts to slip, break or maintain. A Model 402BP B C 5 Runs up to speed in the mix Durable 40.2cc gas engine Compact and reliable gear increaser Heavy-duty clutch Swivel mounted, isolated frame Quick-disconnect for easy storage FLEXIBLE SHAFTS VIBRATOR HEAD Core and Model Casing Length Core Only Casing Only Number Size *BCK Series shafts are specially designed for use with Wyco backpack gas vibrators. Optional quick-disconnect Shaft side only Part number 40217 Backpack features allow the operator to match the vibrator speed with the mix. A. Variable speed control Operator can lock-in the proper maximum speed for Square Head size B. Visual Readout Digital tachometer indicates vibrator speed so operator can adjust vibration C. Speed Increaser Provides a positive mechanical drive, no slippage effecting head speeds Engine Specifications: 40.2cc Air cooled Horsepower: 2 hp @ 7000 rpm Fuel Capacity: 37 oz./1.1 liter, 45-60 minutes @ full load Fuel Mix Ratio: 25:1 (gasoline to 2-cycle oil) Clutch: Heavy-duty centrifugal-type Rotation: Counterclockwise Backpack Unit Wt: 20 pounds Cast aluminum housing contains 2x internal gear speed increaser, plus simple, bearingless quick-disconnect wycotool.com
Square Head TM High Cycle Concrete Vibrator Uniform Speed, Uniform Results Wyco High Cycle Vibrators are designed to properly consolidate difficult performance based concrete mix designs. The consistent speed output, under variable loads, produces uniform results. Multiple rotor sizes (500, 1300, and 1600 lb) are available allowing units to be custom tailored to the application. Creates powerful force for consolidation Compatible with 230 volt, 3 phase, high cycle generators Large surface area for high production 25' power cord Maintains uniform speed/frequency under load Multi-Speed capability with Select-Cycle converter box Sealed switch design, practical for deep pours Optional Polyurethane Coated Head Technical Data Vibrator Model V-200T 1300 1600 Head Size 2" 2-3/8" 2-3/8" Head Length 14.17" 18.30" 19.30" Head Weight 9 pounds 17 pounds 18 pounds Head Oil N/A 70 ml 80 ml Amplitude.062 inches.087 inches.100 inches Force @ 180 Hz/10,800 VPM 500# 1300# 1600# Electric Current 230 volt, 180 Hz, 3-phase Amps 10 Hose Lengths 6, 16, 21 & 30 feet Cord Length 25 feet # = pounds force Ordering Information Part Model Head Force Length Shipping Number Number Size @ 10,800 VPM of Hose Wt. 417-050 V-200T-16 2" Round 500# 16' 33 pounds 417-051 V-200T-21 2" Round 500# 21' 36 pounds 416-206 1300-6 2-3/8" 1300# 6' 31 pounds 416-216 1300-16 2-3/8" 1300# 16' 37 pounds 416-221 1300-21 2-3/8" 1300# 21' 40 pounds 416-230 1300-30 2-3/8" 1300# 30' 45 pounds 416-306 1600-6 2-3/8" 1600# 6' 32 pounds 416-316 1600-16 2-3/8" 1600# 16' 38 pounds 416-321 1600-21 2-3/8" 1600# 21' 41 pounds 416-330 1600-30 2-3/8" 1600# 30' 46 pounds # = pounds force Extension Cordset 50' Extension Cord HCEC-50 399-415 11 pounds 100' Extension Cord HCEC-100 399-420 21 pounds 6 800-233-9926
Select-Cycle Converters Optimum Speed Selection Allows contractor to select the speed (8,000, 10,800 or 12,000 vpm) needed for the job Adapts 230V feature on regular generator or other single phase source to 230V 3-phase Operate up to two Wyco High Cycle vibrators Rugged construction with a protective frame Extra safety feature, keeps vibrators from surging Technical Information Input from 230 Volt AC Power Source Output to 230 Volt AC Vibrator Single Phase Three Phase 50/60 Hz (see chart below) 15 Amps 10.5 Amps Max (Total) Vibrator Technical Data @ Selected Speeds - V V T S I T S : : a - V - V 1300# 1600#.389.478.087.100 Select-Cycle Converter Box Ordering Information 8,000 10,800 12,000 133 180 200 710 1300 1605 874 1600 1975 416-055 416-056 416-059 SC 1420 SC 1430 SC 620 High Cycle Generators Two output receptacles Protective roll cage w/central lifting bar Solid state exciter system Ordering Information for 230V, single phase NEMA L1420R plug 8" x 11" x 10" 21 pounds for 230V, single phase NEMA L1430R plug 8" x 11" x 10" 21 pounds for 230V, single phase NEMA L620R plug 8" x 11" x 10" 21 pounds Brushless Honda Engine Conservative output rating Part Description Frame Net Number Dimensions Weight 4kW, 240 volt (10 amp), 3-Phase, 180 Hz High Cycle Electric Generator Set, 511807 with 8 hp (3600) RPM Honda, gasoline 21" x 21" x 21" engine, including 1.59 US gallon (6 liter) capacity tank and recoil start wycotool.com 140 pounds Honda Engine 511807 7
COBRA Series Proven Reliability Converter Features Coverter box is interchangable with all Cobra series vibrator heads Environmentally sealed switch Inlet volume surge protection Protection at converter outlet limiting amps per phase Ergonomic box making transport and handling easier 50' of cable gives the equipment a high level of autonomy Vibrator Head Features Vibrating heads that easily adapt to a variety of jobs High-frequency encapsulated internal motor ensures high performance and great resistance to wear and tear Under conditions of normal use the vibrators do not require maintenance Vibrator Head Specifications Converter Specifications CONVERTER Weight lbs INPUT Voltage Frequency OUTPUT Power COBRA 18 115V, 50/60 Hz 1.1 KW COBRA 18 230V, 50/60 Hz 1.5 KW Voltage, Frequency, Amperage 230V, 3PH, 200Hz, 1.9A 230V, 3PH, 200Hz, 2.8A 230V, 3PH, 200Hz, 3.8A BD Pneumatic Concrete Vibrator 115V, 3PH, 200Hz, 3.8A 115V, 3PH, 200Hz, 5.6A Variable air flow rate, twist grip throttle 1 Easy to handle Quiet, smooth operation 3 Sizes: BD-35, 1-1/2" BD-55, 2-1/4" BD-65, 2-3/4" BD-75, 3" 2 Available in 10, 15, and 20 ft hose lengths Principles of Operation The BD Pneumatic Concrete Vibrator series features a built-in pneumatically driven motor which has only two moving parts, the vane (1) and rotor (2). Compressed air is supplied to the vibrator through the air valve and inner hose (3). Air flows into the rotor, passes through the passage ways in the vane, back through the air gap on the rotor and outer holes in the rear flange. This activates the rotor and the vibrator begins to vibrate. Options Specifications Strainer removes Amplitude Frequency Head Diameter Head Length Head Weight Centrifugal Force Air Consumption contaminates MODEL (total at tip) (max. at 85 psi) inches (mm) inches (mm) lbs (kg) (max. at 85 psi) (max. at 85 psi) from air line. inches (mm) vpm lbs (kg) cfm Part # W680-765 Oiler assures lubrication of internal components in pneumatic head. Part # W680-770 BD-35 BD-55 BD-65 BD-75 1.42 (36) 2.20 (56) 2.64 (67) 3.03 (77) 10.51 (267) 13.54 (344) 14.37 (365) 15.67 (398) 3.3 (1.5) 9.9 (4.5) 17.38 (7.9) 19.6 (8.9).027 (.69).037 (.94).054 (1.37).070 (1.78) 17,600 17,700 17,700 17,000 441 (200) 1484 (675) 2548 (1158) 3278 (1490) 27 54 54 85 8 wycotool.com
EZ Vibe TM Square Head TM Perfectly Balanced for Operator Comfort This compact, hand-held, W403-000 gas-powered concrete vibrator is a truly portable one-man operation. And with its four stroke engine, there's no need to mix oil in the fuel. There are no air hoses or electric cords to get tangled in the rebar or tie down. It is perfect for tilt-up walls, culverts, and any hard-to-reach, remote concrete construction site. It s also ideal as an emergency standby vibrator in case of a job site power failure. Product Specifications: 35cc Air-cooled 4-cycle engine 1.6 hp,.65 liter fuel capacity 6' shaft length with a 1.38" Square Head Diaphragm carburetor Lightweight at 23 pounds Includes a shoulder harness Adjustable speed EZ Vibe is ideal for: Footings Box Culverts 4' Retaining Walls Road Patching Flat Work Tilt-up Walls Residential Flatwork W404-000 800-233-9926 9
Square Head EZ Vibe ICF Hand-Held Gas Vibrator Wyco Tool offers an EZ Vibe to meet the specific demands of residential applications. The unit is designed with a longer shaft and smaller head size to easily fit Insulated Concrete Forms. A tachometer was also added to track operating hours as well as vibrator speed. The operator can then easily adjust vibration to handle the wide range of higher slump mix designs. Equipped with a 35 cc air-cooled 4-cycle Robin Engine 1.6 hp,.65 liter fuel capacity Available with 13/16" or 1" Square Head Choose from 8' and 12' shaft lengths Tachometer to track speed and operating hours Uses a diaphragm carburetor Adjustable shoulder harness included for operator comfort WYCO TOOL 8635 Washington Avenue Racine, Wisconsin 53406-3738 USA Tel: 262 639-6770 or 800-233-9926 Fax: 262 639-2023 or 888-992-6872 Website: www.wycotool.com E-Mail: wycosales@wycotool.com WYCO and SELECT-CYCLE are registered trademarks of Racine Federated Inc. Square Head and EZ Vibe are trademarks of Racine Federated Inc. UL is a registered trademark of Underwriters Laboratories Inc. 2008 Racine Federated Inc., all rights reserved. FORM NO. W-100 PRINTED IN USA 7/08