Powr Distribution Board SVS20PWR (ControlPlx ) Dscription Togthr with th bus controllr CPC10 and th lctronic circuit protctor ESX50D-S1xx th powr distribution board typ SVS20PWR-xx forms th intllignt powr distribution systm ControlPlx Board SVS20CP. Its consistnt communication capabilitis hlp to mt th rquirmnts of automation tchnology with rgard to rliabl ovrcurrnt protction and optimisd currnt distribution on th DC 24 V lvl. Th powr distribution board SVS20PWR-xxx for rail mounting is availabl in a numbr of vrsions from 8 to 24 slots. Th total possibl currnt of th systm is max. 40 A and th connctd loads ar slctivly protctd by mans of th lctronic circuit protctor typ ESX50D-S1xx. Th max. load currnt pr slot is 10 A and is mad availabl to th usr with two protctd»+«load outputs ach and just as many minus trminals. Th positiv ffct is a signicant rduction of wiring tim and fforts. Th status of th circuit protctors and thir paramtrs and unit data ar transmittd cyclically and non-cyclically to th connctd bus controllr CPC10 via th propritary bus systm ELBus. This allows a continuous analysis of systm data and thus a corrsponding raction in th vnt of anomalis or disruptions. Th lin ntry for th DC 24 V supply as wll as th load output trminals ar dsignd as so that th ntir systm can b wird quickly and cost-ffctivly. Suitabl for th following typs: Elctronic circuit protctors Faturs and Bnfits l Intllignt powr distribution systm for bus-capabl circuit protctors typ ESX50D-S l Systmatic intgration of protction and distribution functions l Powr distribution and slctiv protction of DC 24 V load circuits all in on l Clarly laid-out distribution concpt l Profitability through considrably rducd wiring tim l Rduction of planning, dsign and installation tim l Eas of maintnanc, diagnosis and systm xtnsion l Compact powr distribution for compact control cabints l 2 plus and 2 minus trminals pr slot Ordr numbring cod ESX50D-S100 ESX50D-S110 Typ SVS20PWR powr distribution systm for ESX50D-S l for short-circuit limitd DC 24 V applications l max. 40 A cont. load l communication to CPC10 and ESX50D-S via ELBus l Incl. 2 trminals Y31154801, 3-pol for ELBus Max. numbr of circuit protctors on th distribution systm 08 8 circuit protctors (F1...F8) 16 16 circuit protctors (F1...F16) 24 24 circuit protctors (F1...F24) Population, load output, minus signalling trminals 001 compltly fittd with (max. 2.5 mm 2, without wir nd frrul) SVS20PWR - 08-001 ordring xampl Accssoris: s pag "accssoris" Tchnical data (T amb = 25 C, U B = DC 24 V) Application: Modular powr distribution systm for short circuit currnt limitd DC 24 V applications Supply Ratd voltag: DC 24 V (18... 30 V) Total currnt max. 40 A DC 24 V (+) = / DC 24 V (- = / PE = PE Trminals 5-pol max. 10 mm 2, for powr supplis intgral loop-through, for sub-wiring cabl cross sction flxibl with wir nd frrul (with plastic slv) 0.5 10 mm 2 strippd lngth 18 mm F-slots up to 24 slots for circuit protctors, prpard for typs ESX50D-S100 and ESX50D-S110 F1...F4 = trminals X1... X24 Load outputs, load output (+) and load output (-) pr way (X1...X24) Ratd voltag DC 24 V (18... 30 V) Currnt max. 10 A pr trminal block (1 to 24) Load trminals: up to 24 x and protctd pr slot F1...F24 1) Minus trminals: Trminals: SVS20PWR-16-001, unpopulatd up to 24 x and pr slot F1...F24 Push-in trminal block, 2 x pol max. cabl cross sction flxibl with wir nd frrul (with plastic slv) 0.25-1.5 mm 2 flxibl with wir nd frrul (without plastic slv) 0.25-2.5 mm 2 stripping lngth 8 mm 1) Whn mountd sid-by-sid and whn fully populatd with circuit protctors ESX50D-S ratd 10 A, th dvics can only carry 80% of thir ratd load continuously. www.-t-a.d 1
Powr Distribution Board SVS20PWR (ControlPlx ) Tchnical data (T amb = 25 C, U B = DC 24 V) ELBus connction for conncting with th bus controllr CPC X50-1 Connction for th bus controllr CPC (-X51, -X52, -X63, -X54) Cabl lngth max. 2m typically H0V-K 1.5mm² connctor 1: ELBus ELB data lin connctor 2: ELBus DC +24V connctor 3: ELBus Trminals push-in, 3-pol (2 pcs includd) max. cabl cross sction flxibl with wir nd frrul (with plastic slv) 0.25 0.5 mm 2 flxibl with wir nd frrul (without plastic slv) 0.25 1.5 mm 2 stripping lngth 9 mm Th plus path is protctd sparatly by a PTC (R). In th vnt of a short circuit this will caus a disconnction of th circuit. Th disruption will automatically b rvokd at th nd of th cooling priod. Mounting of housing Tmpratur rang Storag tmpratur Housing matrial Dgr of protction Insulation voltag Dimnsions Mass symmtrical rail to EN 6015-35 x.5 0...50 C (without condnsation) -20...+0 C mouldd trminals IP20 DIN 40050 printd circuit board IP00 DIN 40050 (doubl coating) DC 250 V (pcb) s dimnsions (tolrancs to DIN ISO 286 part 1 IT13) SVS20PWR-08-001 approx. 390 g SVS20PWR-16-001 approx. 65 g SVS20PWR-24-001 approx. 960 g Nots for installation l Th max. total currnt of 40A pr way must not b xcdd l Th usr has to nsur that th cabl cross sction of th load circuit in qustion complis with th currnt rating of th usd load or circuit protctor. l Plas obsrv th tchnical data of th circuit protctors and th corrsponding manual for ControlPlx systms. l In addition spcial prcautions must b takn in th systm or machin (.g. us of a safty PLC) which rliably prvnt an automatic r-start of parts of th systm (cf. Machinry Dirctiv 98/3/EG and EN 60204-1, Safty of Machinry). In th vnt of a failur (short circuit/ovrload) th load circuit will b disconnctd by th circuit protctor. l Th powr distribution systm must only b installd by qualifid prsonnl. l It is only intndd for us with safty xtra-low voltag (=24 V DC). l Only aftr xprt installation must th dvic b supplid with powr. l Aftr tripping of th circuit protctor, bfor rst, th caus of short circuit or ovrload has to b rmdid. l Th national standards (.g. for Grmany DIN VDE 0100) hav to b obsrvd for installation and slction of fd and rturn cabls. l Connction to a highr or not rliably disconnctd voltag can caus hazardous conditions or damags. Schmatic diagram SVS20PWR-xx-001 X50 1/ELB R F1 Lin+ Lin+ Lin+ F2 F23 F24 PE Lin+ DC 24 V/max. 40 A X1 X2 X23 X24 2 www.-t-a.d
Powr Distribution Board SVS20PWR (ControlPlx ) Powr distributor SVS20PWR-08-001 Plas ordr th rquird population option sparatly. without quipmnt Powr distributor SVS20PWR-16-001 Powr distributor SVS20PWR-24-001 Plas ordr th rquird population option sparatly. without quipmnt Mounting position www.-t-a.d 3
Powr Distribution Board SVS20PWR (ControlPlx ) Dimnsions SVS20PWR-08-001 top hat rail EN 6015-35x,5 (not supplid with product) 140 G E R M A N Y Typ: SVS20PWR-08-001 X50 1/ELB PE F1 F2 F3 F4 F5 F6 F F8 X4 X5 X1 X2 X3 X6 X X8 trminals powr supply 10,0 mm 2, 1 pol, max. 40 A load output trminals 2 x 2 pol 1,5 mm 2, max. 10 A load output and signalling trminals 1.5 mm 2 wir nd frrul with plastic slv 2.5 mm 2 wir nd frrul without plastic slv Dimnsions SVS20PWR-16-001 top hat rail EN 6015-35x,5 (not supplid with product) 240 G E R M A N Y Typ: SVS20PWR-16-001 X50 1/ELB PE F1 F2 F3 F4 F5 F6 F F8 F9 F10 F11 F12 F13 F14 F15 F16 X1 X X10 X11 X12 X13 X14 X15 X16 X2 X3 X4 X5 X6 X8 X9 trminals powr supply 10,0 mm 2, 1 pol, max. 40 A load output trminals 2 x 2 pol 1,5 mm 2, max. 10 A load output and signalling trminals 1.5 mm 2 wir nd frrul with plastic slv 2.5 mm 2 wir nd frrul without plastic slv 4 www.-t-a.d
Powr Distribution Board SVS20PWR (ControlPlx ) Dimnsions SVS20PWR-24-001 top hat rail EN 6015-35x,5 (not supplid with product) 340 GERMANY Typ: SVS20PWR-24-001 X50 1/ELB F1 F2 X1 F3 X2 F4 X3 F5 X4 F6 X5 F X6 F8 X F9 X8 F10 X9 F11 X10 X11 F12 F13 F14 F15 F16 X15 F1 X13 X14 X16 X1 F18 X18 F19 F20 X19 F21 X20 X21 F22 X22 F23 F24 X23 X24 X12 PE trminals powr supply 10,0 mm2, 1 pol, max. 40 A load output trminals 2 x 2 pol 1,5 mm2, max. 10 A load output and signalling trminals 1.5 mm2 wir nd frrul with plastic slv 2.5 mm2 wir nd frrul without plastic slv 0 ESX50D-S... Application xampl: SVS20PWR-08-001, fittd with ESX50D-S1xx 140 GERMANY Typ: SVS20PWR-08-001 X50 1/ELB F1 F2 X1 X2 F3 F4 X3 X4 F5 F6 X5 F X6 F8 X X8 12 PE www.-t-a.d 5
Powr Distribution Board SVS20PWR (ControlPlx ) Accssoris Elctronic circuit protctor ESX50D-S1xx 60 oprating ara Elctronic Ovrcurrnt Protctor ESX50D-S1xx-DC24V-1A-10A XXXX 0 mounting ara 10,3 6,8 6x6,8 = 40,8 blad trminals EN 60934-6,3-0,8 polarizing tooth ESX50D -S100- DC24V 10A r on off s 12,3 ESX50D -S110- DC24V I N / A r on off s t t All dimnsions without tolrancs ar for rfrnc only. E-T-A rsrvs th right chang spcifications at any tim in th intrst of improvd dsign, prformanc and cost ffctivnss, th right to mak changs in ths spcifications without notic is rsrvd. Product markings may not b xactly as th ordring cods. Errors and omissions xcptd. 6 www.-t-a.d