WINSHIEL/WINOWGLSS/MIRROR FRONT SIE FIX WINOW REPLEMENT FRONT SIE FIX WINOW The instlltion procedures re the removl procedures in reverse order. However, only instlltion procedures requiring dditionl informtion re included. Use the sme procedures for the LH side nd RH side. The procedures listed elow re for the LH side. 1. REMOVE FRONT PILLR GRNISH SSY (See pge 7628) () Remove the front door scuff plte LH. () Remove the cowl side trim ord LH. (c) Remove the front door opening trim wetherstrip. (d) Remove the front pillr grnish corner piece. (e) Remove the front pillr grnish. 709 7012L01 Moulding 2. REMOVE FRONT SIE FIX WINOW () Using knife, cut off the moulding, s shown in the illustrtion. e creful not to dmge the vehicle ody with the knife. () Remove the remining moulding. Mke prtil cut in the moulding. Then pull nd remove it y hnd. ut Moulding ut ut ut 73414 lip Pino Wire (c) (d) From the interior, insert pino wires etween the vehicle ody nd glss, s shown in the illustrtion. Tie ojects tht cn serve s hndles (for exmple, wooden locks) to ll wire ends. Hook Fstener 73856 2004 Prius Preliminry Relese (RM1075U) uthor : te : 959
7010 WINSHIEL/WINOWGLSS/MIRROR FRONT SIE FIX WINOW Protective tpe 73857 pply protective tpe to the outer surfce of the vehicle ody to prevent its surfce from eing scrtched. When seprting the glss from the vehicle, e creful not to dmge the vehicle s pint or interior / exterior ornments. (e) ut through the dhesive y pulling the pino wire round the glss. (f) Using suction cup, remove the glss. Leve s much dhesive on the vehicle ody s possile when removing the glss. dhesive Vehicle ody dhesive 73084 3. LEN VEHILE OY () len nd shpe the contct surfce of the vehicle ody. (1) Using knife, cut wy ny rough dhesive on the contct surfce of the vehicle ody to ensure the pproprite surfce shpe. Leve s much dhesive on the vehicle ody s possile. (2) len the contct surfce of the vehicle ody with piece of shop rg sturted with clener. Even if ll the dhesive hs een removed, clen the vehicle ody. Instlltion re Vehicle ody 4. INSTLL QURTER PNEL SPER () Instll new spcer to the vehicle ody, s shown in the illustrtion. 73860 Hook Fstener 75785 5. INSTLL HOOK FSTENER () ot the instlltion prt of the hook fstener with Primer G. llow the primer coting to dry for 3 minutes or more. Throw wy ny leftover Primer G. o not pply too much Primer G. () Instll new hook fstener onto the glss, s shown in the illustrtion. 2004 Prius Preliminry Relese (RM1075U) uthor : te : 960
WINSHIEL/WINOWGLSS/MIRROR FRONT SIE FIX WINOW 7011 dhesive Primer M Primer M ORRET INORRET 6. INSTLL FRONT SIE FIX WINOW () Using rush, cot the exposed prt of the vehicle ody with Primer M. llow the primer coting to dry for 3 minutes or more. o not cot the dhesive with Primer M. Throw wy ny leftover Primer M. o not pply too much Primer M. : Primer M 73858 () Using rush or sponge, cot the edge of the glss nd the contct surfce with Primer G. ckside Mrking Mrking Mrking Mrking Mrking : Primer G 73859 If n re other thn tht specified is coted y ccident, wipe off the primer with clen shop rg efore it dries. llow the primer coting to dry for 3 minutes or more. Throw wy ny leftover Primer G. o not pply too much Primer G. 2004 Prius Preliminry Relese (RM1075U) uthor : te : 961
7012 WINSHIEL/WINOWGLSS/MIRROR FRONT SIE FIX WINOW (c) pply dhesive. dhesive: Prt No. 0885000801 or equivlent ckside : dhesive 73861 (1) ut off the tip of the crtridge nozzle, s shown in the illustrtion. fter cutting off the tip, use ll dhesive within the time descried in the tle Usge timefrme: Temperture 35 (95 F) 20 (68 F) 5 (41 F) Usge Timefrme 15 minutes 1 hour 40 minutes 8 hours (2) Lod the seler gun with the crtridge. (3) ot the glss with dhesive, s shown in the illustrtion. Specifiction: re Mesurement 8 mm (0.31 in.) 6 mm (0.24 in.) (d) Instll the front side fix window to the vehicle ody. (1) Hold the front side fix window in plce securely with protective tpe or equivlent until the dhesive hrdens. llow the primer coting to dry for 3 minutes or more. heck tht the hook fstener nd clips re ttched to the vehicle ody correctly. heck tht the vehicle ody nd glss hve smll gp etween them. 2004 Prius Preliminry Relese (RM1075U) uthor : te : 962
WINSHIEL/WINOWGLSS/MIRROR FRONT SIE FIX WINOW 7013 (2) Lightly press the front surfce of the glss to ensure tht the glss is securely fit to the vehicle ody. o not drive the vehicle for the mount of time descried in the tle elow. Minimum time: Temperture Minimum time prior to driving vehicle 35 (95 F) 1 hour 30 minutes 20 (68 F) 5 hours 5 (41 F) 24 hours 7. HEK FOR LEKS N REPIR () onduct lek test fter the dhesive hs completely hrdened. () Sel ny leks with uto glss seler. 2004 Prius Preliminry Relese (RM1075U) uthor : te : 963