S E R I E S P Directly operated mini-solenoid valves Series P 3/ way N.C. or N.O. Ports M5 (for single base) Cartridge ø 3 and 4 (for manifold) Note: All the serie P electrovalves are basic in DC. For their AC operation, at the same targe voltage you must use the 15-900 connector. GENERAL DATA Valve group Construction Mounting Materials Ports Installation Temperature Fluid Lubricant 3/ Way / Pos., N.C. or N.O. poppet type by means of screws plastic body - NBR seals - other stainless steel M5 - ø 3 cartridge ø 4 cartridge G1/8 manifold supply in any position 0 60 C filtered air, with or without lubrication without lubrication** The Series "P" directly operated solenoid valves can work both with dry or lubricated air. They are available as 3/ ways, either normally closed (NC) or normally opened (NO). The main feature of this solenoid valve consists in the fact that the body is integral with the encapsulated coil. This solution allows to have a very good power consumption/flow rate and guarantees high performance even with utilizations at the limits of the given values. Single or multiple manifolds are available for assembly in batteries. On these manifolds, it is possible to assemble both NC and NO functions (for the latter it is necessary to use an adaptor). The manifolds are available on stock only with cartridge fittings outlets with SUPER-RAPID Mod. 6700 for tubes of outer dia. 3 and 4 mm. ** In case lubricated air is used we recommend to use ISO VG3 oil. 001
P S E R I E S PNEUMATIC DATA Operating pressure Nominal pressure Nominal flow rate Nominal diameter ELECTRICAL DATA Voltage Power consumption see table 6 bar Qn 0 Nl/min. (6 bar P 1 bar), Qn 30 Nl/min (6 bar P 1 bar) ø0.9 mm, ø 1.5 mm *DC 6V, 1V, 4V, 48V W, 1 W Voltage tolerances ± 10% Class of insulation Protection class Duty cylce Response time * Other voltages on request. Note: For electrical connections use Mod. 15-800 (DC) For electrical connections use Mod. 15-900 (AC) CODING OF SERIES P VALVES SERIES P BODY DESIGN 0 = single sub-base (only M5) or interface 1 = single manifold = double sided manifold N OF PORTS AND FUNCTIONS 0 = not defined 3 = 3-ways N.C. 4 = 3-ways N.O. class F IP54 (with connector DIN 40050 IP65) ED 100%, continuous operation 4 5 ms NUMBER OF SEGMENTS 00 = interface 01 = single sub-base (only M5) 0 99 = No. of segments PORTS 0 = interface * = M5 side ports 3 = ø 3 tube side port 4 = ø 4 tube side port *6 = M5 rear ports 7 = ø 3 tube rear ports 8 = ø 4 tube rear ports P000-303-P53 SOLENOID DIMENSION 5 =15x15 NOMINAL DIAMETER * 1 = 0,9 (1W) 3 = ø1,5 (W) 5 = ø0,9 NA (W) SOLENOID VOLTAGE * L = 1V 50/60 Hz * B = 4V 50/60 Hz * C = 48V 50/60 Hz * D = 110V 50/60 Hz * 1 = 6V DC * = 1V DC 3 = 4V DC * 4 = 48V DC * 6 = 110V DC *on request, not available in stock. ENCAPSULATED MATERIAL P = special thermoplastic MAX PRESSURE 7 bar (NC) 7 bar (NO) 7 bar (NC) 5 bar (NO) 10 bar (NC) 10 bar (NO) *on request. 00
S E R I E S P 3/ way solenoid valve NC The 3/ way solenoid valve NC can be mounted on single sub-bases or manifold. These solenoid valves are provided with a manual over ride for stable or monostable operation. The solenoid valve is supplied with interface seal and screws. Function Orifice Kv Qn Pressure Mod. ømm (Nl/min) min-max bar P000-305-P53 (NC) 0.9 0.3 0 0 10 P000-303-P53 (NC) 1.5 0.45 30 0 7 3/ way solenoid valve NO The 3/ way solenoid valve NO can be mounted on single sub-bases or manifold. These solenoid valves are provided with a manual over ride for stable or monostable operation. The solenoid valve is supplied with interface seal and screws. Function Orifice Kv Qn Pressure Mod. ømm (Nl/min) min-max bar P000-405-P53 (NO) 0.9 0.3 0 0 10 P000-403-P53 (NO) 1.5 0.34 3 0 5 Single sub-base Mod. P001-0 NO Interface Manual override Manual override 003
P S E R I E S Excluder tap Mod. P000-TP Single manifold rear outlets Screws M3x6 Mod. N valves L L1 L L3 *= 6 *= 7 *= 8 P R P10-0* 53 39 18.5 16 M5* ø3 ø4 G1/8 G1/8 P103-0* 3 69 55 18.5 16 M5* ø3 ø4 G1/8 G1/8 P104-0* 4 85 71 18.5 16 M5* ø3 ø4 G1/8 G1/8 P105-0* 5 101 87 18.5 16 M5* ø3 ø4 G1/8 G1/8 P106-0* 6 117 103 18.5 16 M5* ø3 ø4 G1/8 G1/8 Single manifold front outlets Assembling scheme on DIN 4677/3 guide. Mod. N valves L L1 L L3 *= *= 3 *= 4 P R P10-0* 53 39 18.5 16 M5* ø3 ø4 G1/8 G1/8 P103-0* 3 69 55 18.5 16 M5* ø3 ø4 G1/8 G1/8 P104-0* 4 85 71 18.5 16 M5* ø3 ø4 G1/8 G1/8 P105-0* 5 101 87 18.5 16 M5* ø3 ø4 G1/8 G1/8 P106-0* 6 117 103 18.5 16 M5* ø3 ø4 G1/8 G1/8 004
S E R I E S P Double sided manifold rear outlets Mod. N valves L L1 L L3 *= 6 *= 7 *= 8 P R P04-0* 4 53 39 18.5 16 M5* ø3 ø4 G1/8 G1/8 P06-0* 6 69 55 18.5 16 M5* ø3 ø4 G1/8 G1/8 P08-0* 8 85 71 18.5 16 M5* ø3 ø4 G1/8 G1/8 P10-0* 10 101 87 18.5 16 M5* ø3 ø4 G1/8 G1/8 P1-0* 1 117 103 18.5 16 M5* ø3 ø4 G1/8 G1/8 Double sided manifold front outlets Assembling scheme on DIN 4677/3 guide. Mod. N valves L L1 L L3 *= *= 3 *= 4 P R P04-0* 4 53 39 18.5 16 M5* ø3 ø4 G1/8 G1/8 P06-0* 6 69 55 18.5 16 M5* ø3 ø4 G1/8 G1/8 P08-0* 8 85 71 18.5 16 M5* ø3 ø4 G1/8 G1/8 P10-0* 10 101 87 18.5 16 M5* ø3 ø4 G1/8 G1/8 P1-0* 1 117 103 18.5 16 M5* ø3 ø4 G1/8 G1/8 Pin spacing 9,4 mm Mod. 15-800 (Din 43650 pin spacing 9.4mm): to be used in all DC valves with voltages from 6 110 V Mod. 15-900 (Din 43650): to be used in all DC valves connected to a AC voltage of the same nominal voltage or even for DC valves, when protection is required against overvoltage impulses (see the scheme). Mod. 15-800 (PG7) for Series P000 Mod. 15-900 for Series P000 1 = groove for electric connection identification 005