HOTEL SPA CLUB GOLF. EcoEclipse Installation Guide Triple Dispenser. Your Partner for Personal Care Solutions

Transcription

1 ReadyCare HOTEL SPA CLUB GOLF EcoEclipse Installation Guide Triple Dispenser Your Partner for Personal Care Solutions

2 ecoeclipse shower dispensing systems Congratulations! The EcoEclipse shower dispenser you recently purchased is a time-tested system that has been used in bathrooms of hundreds of properties around the world. The system helps deliver a great guest experience by conveniently displaying 8 oz. bottles of shampoo, conditioner & body wash, while helping properties reduce their bottle waste and manage their costs. Now it s time to get your dispenser installed properly to achieve maximum benefit. Questions:

3 Before You Install Your EcoEclipse Dispenser Read these instructions thoroughly before starting your installation. You will need ADHESIVE caulk, a level, and masking tape or a dry erase marker. Be sure to remove the bottles before installing. For bottle removal instructions, see Step 9. After installation, please wait a minimum of one hour before inserting filled bottles into your EcoEclipse dispenser. Don t worry. Hundreds of properties have successfully installed our EcoEclipse dispenser, and you will too.

4 Step 1 - Finding the Right Location 1a. Decide how high up you want your dispenser. The recommended height is 56 from the floor to the base of the dispenser. It s not a good idea to make someone reach up or down too much in the shower, because the surface of the tub or shower will be wet and it will increase the chances that someone will slip. To comply with ADA standards, wall mounted units should be located where their pumps are 44 (1,117 mm) above the finished floor. 1b. 1c. 1d. Use a level to make sure your dispenser is aligned horizontally and vertically. Then use masking tape or a dry erase pen to mark the upper corners. Make sure that the dispenser s location won t interfere with using the shower. Does it get in the way when entering the shower? Will water from the shower spray on it constantly? Also make sure the installation surface is clean and dry. Grime or soap scum will decrease the effectiveness of the adhesive and could cause the dispenser to dislodge prematurely.

5 Step 2 - Preparing the Adhesives Before removing the blue tape, use adhesive caulk and lay a small bead around the outside of the back plate as shown in the graphics above Note: Please make sure you are using ADHESIVE caulk.

6 Step 3 - Readying the Adhesive 3a. 3b. Make sure you know exactly where you are going to place the unit before removing the tape. Remove tape carefully as the tape can be very sticky. Also try to avoid smearing your lines of adhesive caulk. Step 4 - Adhering the Dispenser 4a. 4b. 4c. 4d. Hold the unit with both hands. Tip the bottom of the unit toward you so only the top edge will hit the wall. Once the top edge is in the proper location, tip the dispenser back so that it adheres to the wall. Take both hands and push dispenser against the wall for 15 seconds.

7 Step 5 - Caulking the Edges We recommend placing a small bead of clear or white caulk around the outside edges of the dispenser. This will prevent soap grime from getting behind the unit. Step 6 - Take a Break Now that the unit is on the wall, wait a minimum of 1 hour or the recommended 4 hours for everything to dry before inserting your bottles.

8 Step 7 - Loading Your Dispenser Now load the filled bottles. From left to right, they should be loaded as Shampoo, Conditioner & Body Wash. Bottles will go in easier if you insert them bottom first. Step 8 - Applying the Tamper-Resistant Locking Clamps Snap the locking clamps into place over each bottle as shown in the graphic.

9 Step 9 - Unlocking Your Unit for Refilling 9a. To remove the locking clamps to replace or refill the bottles, place your EcoEclipse key in bottom of unit and PRESS UPWARDS as you pull off the locking clamp. 9b. Do not turn or twist the key as this may break your key or your locking clamps.

10 Step 10 - Refilling Your Bottles Shampoo Refill Conditioner Refill Body Wash Refill 10a. To refill your bottles, hold the refill bag with your back hand on the bottom and with your forward hand, pour the liquid into the bottle. 10b. Fill bottles to rim under the threads. 10c. In-room refills are not recommended. Instead, remove the bottles, refill them back-of-house, and then replace dispensers with filled bottles.

11 ReadyCare HOTEL SPA CLUB GOLF About ReadyCare ReadyCare is a leading provider of personal care solutions to world-class hotels, spas, health clubs & golf clubs that value product choice, service quality & expert advice. For over 25 years, Denver-based ReadyCare has helped thousands of properties deliver great member & guest experiences by ensuring their personal care offering aligns with their clientele & brand. For more information, visit or contact us at / info@readycare.com Your Partner for Personal Care Solutions