PRE-RINSE UNIT B Deutsch: Installations- und Wartungsanleitungen. Español: la Instalación y las Instrucciones de Mantenimiento

Transcription

1 Installation and Maintenance Instructions Limited One Year Warranty T&Swarrants tothe originalpurchaser (other than for purposes of resale) that such product is free from defects in material and workmanship for a period of one () year from the date of purchase. During this one-year warranty period, if the product is found to be defective, T&S shall, at its options, repair and/or replace it. To obtain warrantyservice, productsmust be returned to T&S Brass and Bronze Works, Inc. Attn: Warranty Repair Department 2 Saddleback Cove Travelers Rest, SC Shipping, freight, insurance, and other transportation chargesof the product to T&S and the return of repaired or replaced product to the purchaser are the responsibility of the purchaser. Repair and/or replacement shall be made within a reasonable time after receipt by T&S of the returned product. This warranty does not cover Items which have received secondary finishing orhave been altered or modified afterpurchase, or for defects caused by physical abuse to or misuse of the product, or shipment of the products. Any express warranty not provided herein, and any remedy for Breach of Contract which might arise, is herebyexcluded and disclaimed. Any implied warranties of merchantability or fitness for a particular purpose are limited to one year in duration. Under no circumstances shall T&S be liable for loss of use or any special consequential costs, expenses or damages. Some states do not allow limitations on how long and implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitationsor exclusionsmay not apply to you. Specific rights under this warranty and other rights vary from state to state. P/N: Date: Drawn: CW Checked: MAB 4/6/99 Approved: MW 4/6/99 PRE-RINSE UNIT B-03 Deutsch: Installations- und Wartungsanleitungen Español: la Instalación y las Instrucciones de Mantenimiento Français: les Instructions d Installation et d Entretien

2 Exploded View * Some items are listed for instructional purposes and may not be sold as separate parts. 2

3 Part Number Guide Base Faucet Assembly Body, Faucet * 2 Asm, Spdl LH - Eterna w/ Spring Checks Asm, Spdl RH - Eterna w/ Spring Checks Asm, Lever Handle (LH) Lever Handle, Zinc - Hot Index Button, Red - Hot Screw, Lever Handle Asm, Lever Handle (RH) Lever Handle, Zinc - Cold Index Button, Blue - Cold Washer, Body Locknut, Shank Asm, Spreader Nut, Spreader Coupling Washer, Spreader Asm, Spreader Body & Pin * 7 Tailpiece Nut, Nipple Coupling Pre-Rinse Unit 9 Assembly, Spray Valve B Assembly, Flex S/S Hose B-0044-H 2 Spring, Overhead Spring, Body Nipple, 3/8 x Assembly, Finger Hook & Screw

4 General Instructions Faucet Installation:. Shut off water supply and drain lines. Drill a hole approximately -/4 diameter in countertop where you are installing no.. 2. Loosen no.4 with a -5/6 wrench and separate the two sections. 4. Place no. through hole in sink, align hot and cold sides parallel to sink line 4 3 Note: Dont turn no.4 any further after disassembly. sink 2 5. Install no. and no.2 on no., tighten no.2. Screw no.4 up on no., tightening by hand, making sure to align pins on no.3 with corresponding holes at base of no.. Note: If no.3 and no. are joined correctly, the no.3 will not move or twist if tried Tighten no.4 with a -5/6 wrench. 7. Connect supply lines and check for leaks. Caution: Turn off water supply at base faucet when not in use. 3. Remove no.2 and no. from no.. 4

5 General Instructions Pre-Rinse Installation:. Shut off water supply and drain lines.apply Teflon tape or pipe joint compound to threads on both ends of no.24. Screw no.24 into no. and hand tighten. 2. Slide no.25 down no.24 (about halfway) and tighten temporarily. Note: If new no.22 is being installed on no.2, make sure it s installed in the upright position Screw no.23 down on no.24 and hand tighten, then tighten no.23 with a wrench, which will also tighten no.24. Make sure to align no.25 over center of sink, directly in front of no.24 while tightening. 23 BOTTOM 4. Adjust position of no.25 so that no.20 hangs loosely in it without straining no.2 or no Turn on water supply and check for leaks. See back pages for similar unit installations. 24 Caution: Turn off water supply at base faucet when not in use. 5