KARAVAN T R A I L E R S

Size: px

Start display at page:

Download "KARAVAN T R A I L E R S"

Gervais Blair
5 years ago
Views:

1 C 0 MJH B 036 KMH ADDED (4) REPLACED WITH ; WITH (2X); WITH ; WITH -0006; WITH X 0.00.XXXX 0.00 OF

2 NOTES:.) WINCH SHOULD BE MOUNTED IN SUCH A POSITION THAT THE TOP CARRIAGE IS STRAIGHT UP AND DOWN OR, SLIGHTLY BACK WHEN LOCKED TO THE WINCH. THIS MAKES FOR EASIER LOWERING OF PONTOON. 2.) SEE ADDITIONAL INSTRUCTIONS ON PAGE THREE. 3.) SEE ADDITIONAL INSTRUCTIONS ON PAGE FOUR. 4.) SEE ADDITIONAL INSTRUCTIONS ON PAGE SIX C 0 MJH B 036 KMH DWG. REV ECR/NDR NUMBER REVISED BY ADDED (4) REPLACED WITH ; WITH (2X); WITH ; WITH -0006; WITH SEE ITEM NO. PART NUMBER QTY. NOTES TIE DOWN BRACKET FRONT STOP ANGLE TORSION AXLE 00# W/HUB COUPLER AMBER SNAP-LOC LIGHT SNAP-LOC GROMMET 3, RED SNAP-LOC LIGHT 2 8 3, TAIL LIGHT ASSY AMBER REFLECTOR TAPE RED REFLECTOR TAPE PIGTAIL WIRE HARNESS WIRE HARNESS WIRE HARNESS 3, SNAP-LOC LIGHT TILT PIN SAFETY CABLE AND HOOK "-3 X 3.00" HX HD BOLT "-3 X 3.0" HX HD BOLT "-3 X 4.00" HX HD BOLT " FLAT WASHER "-6 X.00" HX HD BOLT " FLAT WASHER "-3 X 3.063" X.2" U-BOLT "-6 X 2.03" X 3.2" U-BOLT "-3 CENTERLOCK HEX NUT "-4 X 2.2" X.3" U-BOLT "-6 CENTERLOCK HEX NUT "- X." HX HD BOLT "-6 X 3.00" HX HD BOLT "- REG. HEX NUT " SPLIT LOCK WASHER "-3 X.00" HX HD BOLT "- X.83" LUG NUT " FLAT WASHER "-6 X 4.00" X 4.06" U-BOLT " SAE FLAT WASHER ZINC "-4 CENTERLOCK HEX NUT TONGUE JACK LICENSE PLATE BRACKET END CAP PULLEY TUBE END CAP BUSHING TRAILERING CHECKLIST LOGO PIVOT TUBE WELDMENT PIVOT TUBE WELDMENT TAIL LIGHT BRACKET L.H TAIL LIGHT BRACKET R.H UPPER CARRIAGE WELDMENT BOTTOM CARRIAGE WELDMENT WINCH ASSY ROLLER ASSY TIRE SEE OPTIONS 4.X 0.00.XXXX OF

3 OPTIONS KPS X 2C PARTS.30 X 2D TIRES C 0 MJH B 036 KMH ADDED (4) REPLACED WITH ; WITH (2X); WITH ; WITH -0006; WITH X 0.00.XXXX OF

4 6 8 VIEW A GREEN & WHITE WIRES RUN DOWN RIGHT SIDE TUBE YELLOW WIRE RUNS DOWN LEFT SIDE TUBE A 2 3 WIRE HARNESS C 0 MJH B 036 KMH ADDED (4) REPLACED WITH ; WITH (2X); WITH ; WITH -0006; WITH X 0.00.XXXX OF

5 .8 60 FT LBS - 8X B 2 FT LBS - 6X FT LBS - X REFLECTOR VIEW B 3.4 REFLECTOR REFLECTOR NOTES:.) TORQUE CALLOUTS IN PARENTHESIS ARE FOR REFERENCE. TIGHTEN FASTENERS UNTIL PINCHED TIGHT (DO NOT OVER TIGHTEN BUNK PIVOT POINTS). MINOR DEFLECTION OF MATERIAL IS ACCEPTABLE C 0 MJH B 036 KMH DWG. REV. ECR/NDR NUMBER REVISED BY X DIM. TAKEN FROM INSIDE OF SIDE TUBE TO REFLECTOR. ADDED (4) REPLACED WITH ; WITH (2X); WITH ; WITH -0006; WITH X 0.00.XXXX 0.00 OF

6 C FT. LBS - 6X VIEW C. TRAILER CHECK LIST NOTES: 6 DIMENSION IS FROM THE BACK OF THE AXLE MOUNTING BRACKET TO THE BACK OF THE FRAME. DIMENSION INDICATES THE SET LOCATION OF THE RIGHT EDGE OF THE PIN STAMPER. C 0 MJH B 036 KMH ADDED (4) REPLACED WITH ; WITH (2X); WITH ; WITH -0006; WITH X 0.00.XXXX OF

7 CARRIAGE PIVOT ASSEMBLY ASSEMBLY INSTRUCTIONS VIEW 2 PULLEY ASSEMBLY INSTRUCTIONS VIEW ROLLER ASSEMBLY INSTRUCTIONS VIEW TAIL LIGHT/LICENSE PLATE ASSEMBLY INSTRUCTIONS VIEW 4 2 C 0 MJH B 036 KMH ADDED (4) REPLACED WITH ; WITH (2X); WITH ; WITH -0006; WITH X 0.00.XXXX 0.00 OF

KARAVAN T R A I L E R S

KARAVAN T R A I L E R S G F DWG. REV. 5505 5036 KMH 04-28-0 ECR/NDR NUMBER PROPERTY OF TRAILERS, INC. ANY THE WRITTEN PERMISSION OF TRAILERS, DAD.X 0.00.XXXX 0.00 06-8-2 ADDED (4)2-0036. 4/0/2007 REPLACED 208-0003 WITH 208-00049;