Carry out replacement in the following order:

Transcription

1 How to replace front suspension shock absorbers on Carry out replacement in the following order: 1 Replace both shock absorbers at the repair of your car at the same time. 2 Tighten the parking brake lever. 3 Place wedge blocks under the rear wheels. Loosen the wheel mounting bolts. 4 5 Raise the front of the car and secure on supports. Remove the front wheels. 1 9

2 6 Disconnect the brake hose holder from the shock absorber strut Disconnect the fastener of the ABS sensor cable from the shock absorber strut. 8.1 Unscrew the lower fastener of the shock absorber strut

3 9 Open the hood Unscrew the upper fastening of the shock absorber strut. 11 Remove the suspension strut. 12 Set the shock absorber strut on the spring compressor tool. AutoDoc recommends: Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides. Ensure the correct position of the spring in the retainer. Make sure that the spring coils tightly entered the lock handles. 3 9

4 13 14 Compress the spring. Unscrew the top fastening of the shock strut mount. 15 Remove the top mount, the support bearing and the upper spring cup. 17 Remove the shock absorber dust cap and the bump stop. 16 Remove the spring. AutoDoc recommends: Τhoroughly examine the shock absorber mount, dust boot, bump stop. Replace them if necessary. 4 9

5 18 Before installing a new shock absorber you should pump it manually 3-5 times. 19 Install the dust sleeve and the bump stop on the new shock absorber 21 Install a new shock absorber on a special fixture for further mounting of the spring 20 Install the spring. 22 Compress the spring. Install the top mount, the strut mount bearing and the upper spring cup. 5 9

6 23 24 Tighten the upper fastener of the shock absorber strut mount. Install the shock strut into the wheel arch Tighten the shock strut top mount

7 Close the hood Tighten the lower fastening of the shock absorber Connect the fastener of the ABS sensor cable to the shock absorber strut

8 Fasten the brake hose on the strut. 30 Install the wheel. 31 Lower the car and working in a cross order, tighten the wheel bolts Video tutorials Watch our detailed video guides about your NISSAN X-TRAIL T30 repair on our youtube channel. Watch video guides. AutoDoc online We hope that this information have been useful for you! Highest quality shock absorbers for your car NISSAN X-TRAIL T30 are available on AutoDoc. Go to the website. 8 9

9 AUTODOC TOP QUALITY AND AFFORDABLE CAR PARTS ONLINE QUALITY AUTO PARTS NISSAN SHOCK ABSORBERS SHOCK ABSORBERS FOR NISSAN SHOCK ABSORBERS FOR Disclaimer: The document contains only general recommendations that may be useful for you when you perform repair or replacement works. AutoDoc shall not be liable for any loss, injury, damage of property, acquired in the repair or replacement process due to incorrect usage or misinterpretation of the provided information. AutoDoc shall not be liable for any possible mistakes and uncertainties in this guide. The information provided is for informative purposes only and cannot replace advice from specialists. AutoDoc shall not be liable for incorrect or hazardous usage of equipment, tools and car parts. AutoDoc strongly recommends to be careful and observe the safety rules when performing repair or replacement works. Remember: usage of low quality auto parts does not guarantee you the appropriate level of road safety. AUTODOC IN SOCIAL MEDIA Powered by TCPDF ( 9 9