Instruction page index: Installation Instructions for Kendo L & Kendo XL Models KL-XX & KXL-XX. Page 1 of 6

Transcription

1 Installation Instructions for Kendo L & Kendo XL Page of 6 Kendo L with fixed clip mounting Kendo L with adjustable hinge mounting Kendo L with magnetic mounting Instruction page index: Fixed mounting clip installation Adjustable hinge installation Magnetic installation Connect to Power Power feed layout guide

2 Fixed mounting clip installation Page of 6 flathead screw fixed 45 degree mounting clip. 4 every fixed mounting clip fixed mounting clip Determine the location of where the (s) will be installed. Lay the (s) on the, and make any necessary reference marks for the fixed mounting clips (or if using the fixed 45 degree mounting clip). Make marks 4" from each end of the (s) and also every 30" in between.. Lay the fixed clip onto the reference mark points and secure using the provided hardware. - end power feed with wire leads. fixed mounting clip - side power feed with wire leads pass through hole for power feed lead wires - bottom power feed with wire leads lead wires. If necessary make any pass through holes for wire lead/connector to the, depending on the power feed option. Then snap the into the fixed mounting clip to secure in place. Diagram on the right side illustrates the common way of connecting multiple s to each other, depending on the location of the power feed wires.

3 Adjustable hinge mounting clip installation loosen screws Page 3 of 6. flathead screw 4 every 30 4 adjustable hinge mounting clip Determine the location of where the (s) will be installed. Lay the (s) on the, and make reference marks for the mounting clips. Make marks 4" from each end of the (s) and also every 30" in between.. Slightly loosen the screws on the side on adjustable bracket. Lay the bracket onto the reference mark points and secure using the provided hardware. - end power feed with wire leads. adjustable hinge bracket - side power feed with wire leads bottom power feed - bottom power feed with wire leads. If necessary make any pass through holes for wire lead/connector to the, depending on the power feed option. Then rotate to the appropriate degree, followed by tightening the screws on the side. Then snap the into the fixed mounting clip to secure in place. Diagram on the right side illustrates the common way of connecting multiple s to each other, depending on the location of the power feed wires.

4 Magnetic mounting clip installation Page 4 of 6 steel Determine the location where the (s) will be installed. Must be made of steel or a ferrous metal. Clean the area thoroughly from any debris. - end power feed with wire leads. - side power feed with wire leads bottom power feed - bottom power feed with wire leads steel. If necessary make any pass through holes for wire lead/connector to the, depending on the power feed option. Place onto the to secure in place. Diagram on the right side illustrates the common way of connecting multiple s to each other, depending on the location of the power feed wires.

5 Connect to Power light OR male quick connect female quick connect wire leads Follow one of the two options to connect the to the power supply. Option - Secure female quick connect to male quick connect. Feed male quick connect wire through conduit. Option - Feed wire whip to the. 0 VAC class II power supply Page 5 of 6. Connect +4 VDC red wire from the to the +4 VDC red wire with a wire nut. Connect -4VDC black wire from the - 4VDC black wire with a wire nut.. 4 VDC to +4 VDC RED +4 VDC RED -4 VDC BLACK -4 VDC BLACK

6 Multiple powerfeed layouts Page 6 of 6 power supplies at the end of the run power supplies in the middle of the run consecutive layout, NOT RECOMMENDED