Installation Manual. 13.5Vdc 5A Series N645 MODELS : TPS13-5Si TPS13-5SiB TPS13-5SiBD TPS13-5SiBD-20

Transcription

1 13.5Vdc 5A Series MODELS : TPS13-5Si TPS13-5SiB TPS13-5SiBD TPS13-5SiBD The contents of this manual are copyright and may not be reproduced without the written permission of Tactical Technologies Pty Ltd. N645 DESIGNED & MANUFACTURED Installation Manual

2 CAUTION DANGER HIGH VOLTAGE Equipment must be installed & serviced by suitably qualified service personnel in a restricted access area. Dangerous Voltages Inside! Do not remove covers No user serviceable parts inside General These power supplies are designed for indoor use only. N645 TPS13-5Si models are high performance, Dual Channel ULDO Linear Regulated power supplies offering 13.5Vdc at 5A. When operating from mains, these models provide an output of 13.5Vdc ( to power connected equipment) and are configured with a separate 13.8Vdc battery charging channel. Available battery charge current is 13.8Vdc (total supply output current 5.7A ) In the event of mains failure, the connected standby battery will instantaneously power the load. When the mains voltage is restored, batteries are disconnected from the load and recharging commences automatically. Output short-circuit and overload protection are provided. Removal of the fault / short circuit condition will return the power supply to normal operation ( Auto-Reset ). Model Variants TPS13-5Si TPS13-5SiB TPS13-5SiBD TPS13-5SiBD Vdc 5A single output - Supply only - no cabinet (242L x 132W x 90Hmm) 13.5Vdc 5A single output supply in metal cabinet (340W x 290H x 105Dmm) 13.5Vdc 5A supply with10 x 500mA fused outputs in metal cabinet (340W x 290H x 105Dmm) 13.5Vdc 5A supply with20 x 250mA fused outputs in metal cabinet (340W x 290H x 105Dmm) Connection Single Output Models Multiple Output Models Screw terminal blocks provides the following: ( See over the page for a layout ) 12Vdc Output is via individually fused outputs ( 10 x 500mA or 20 x 250mA - model dependent) * 13.5Vdc Output * 13.8Vdc Output for SLA (Sealed Lead Acid) Batteries * AC Fail Relay Output ( SPDT ) * Low Battery Relay Output ( SPDT ) Screw terminal blocks provides the following: ( See over the page for a layout ) * 13.8Vdc Output for SLA (Sealed Lead Acid) Batteries * AC Fail Relay Output ( SPDT ) * Low Battery Relay Output ( SPDT ) Caution when handling batteries: Exercise care when terminating and connecting batteries. Mishandling or short circuit of Sealed Lead Acid batteries can cause severe damage and fire. TPS13-5Si Series.pdf

3 LAYOUT A Multi-Output Models ( e.g. TPS13-5SiBD ) B C D E F G H I J K L DESIGNED & MANUFACTURED A Output Terminals ( Multi Output models only ) B PDM Input ( Multi Output models only ) - G below C Individual Circuit Status LEDs ( Multi Output Models ) D Individual Circuit Fuses ( Multi Output models only ) E AC Fail Output (not fitted to SiE Model) F AC OK / Output OK LEDs (green) G - Output 13.5Vdc + ( Connect to load or PDM ) H - Battery + (Connect to Sealed Lead Acid Battery) I Battery Reversed / Battery Low LEDs (red) J Low Battery Output (not fitted to SiE Model) K Heatsink L 3 Pin 240V Mains plug TPS13-5Si_Series.pdf

4 Warranty Statement Tactical Technologies Pty Limited guarantees this product against defective parts and workmanship for a period of twelve (12) months from the date of purchase. If any defect appears during the warranty period, please return the goods to Tactical Technologies Pty Limited freight paid. The goods will be repaired or replaced, then returned. Tactical Technologies Pty Limited assumes no liability for consequential or indirect damage and accepts no responsibility for repairing damage to products caused by misuse, careless handling or where repairs have been made by others. In the interest of ongoing product development, Tactical Technologies Pty Limited reserves the right to modify, vary or alter the design of this product without written notice. Specifications : ( In the interests of product improvement, Tactical reserves the right to change specifications without notice) TPS13-5Si TPS13-5SiB TPS13-5SiBD TPS13-5SiBD-20 Output Voltage Output Current 13.5 Vdc 5A Continuous Output Channels Output per Channel 5A 500mA 250mA Input Voltage Input Current Battery Charger Low Battery Output AC Fail Output 240 Vac / 50Hz 240Vac 13.8Vdc / 700mA 1 x SPDT relay & LED 1 x SPDT Relay & LED Weight 3.8Kg 6.5Kg Dimensions 242L x 132W x 90H mm 340W x 290H x 105D mm Overload Protection Constant current limiting, short circuit shutdown, auto recovery DOFT Approval No: NSW Safety Standards AS/NZS 60950:2003 EMC Standards AS/NZS CISPR 14.1:2003 Securing Your Power Needs Now and into the Future... Designed & Manufactured Tel: Butterfield St, Blacktown NSW 2148 Fax:

5 For all Sales and Technical enquiries regarding this product, please contact Alarmcorp on: Tel: Web: Melbourne Branch: Sydney Branch: Unit 115, 45 Gilby Road, Mt Waverley VIC 3149 Level 1, 6 Childs Road, Chipping Norton NSW 2170 For the latest contact information, please visit: ALARMCORP. THE FUTURE IS SECURE.