CERTIFICATE OF ACCREDITATION

Transcription

1 CERTIFICATE OF ACCREDITATION ANSI-ASQ National Accreditation Board 500 Montgomery Street, Suite 625, Alexandria, VA 22314, This is to certify that Energy Assurance, LLC 5202 Belle Wood Court, Suite 106 Buford, GA has been assessed by ANAB and meets the requirements of international standard ISO/IEC 17025:2005 while demonstrating technical competence in the field of TESTING Refer to the accompanying Scope of Accreditation for information regarding the types of tests to which this accreditation applies. AT-1601 Certificate Number Certificate Valid: 01/04/ /08/2020 Version No. 004 Issued: 01/04/2018 This laboratory is accredited in accordance with the recognized International Standard ISO/IEC 17025:2005. This accreditation demonstrates technical competence for a defined scope and the operation of a laboratory quality management system (refer to joint ISO-ILAC-IAF Communiqué dated April 2017).

2 SCOPE OF ACCREDITATION TO ISO/IEC 17025:2005 Energy Assurance, LLC 5202 Belle Wood Court, Suite 106, Buford, GA Cindy Millsaps Phone: TESTING Valid to: January 8, 2020 Certificate Number: AT-1601 Preconditioning (Battery cycling) (T1) Altitude Simulation (Low Pressure) (T2) Thermal Test (T3) Vibration (T4) Shock (Mechanical Shock) (T5) Short Circuit (T6) Impact/Crush Insulation and Wiring Discharge Performance at 20 C, and -20 C IEC 62281, UL 1642 IEC 62281, IEC 62133, UL62133, IEC , IEC IEC IEC , IEC , IEC and IEC , IEC 62281, UL 1642, IEC , IEC , RTCA DO-293 IEC , IEC IEC 62133, UL 62133, IEC , IEC , RTCA DO-347, IEC and Secondary Nickel cells and and Secondary Nickel cells and and Secondary Nickel and Secondary Nickel and Secondary Nickel Secondary Li Ion and Secondary Nickel Cells and Vacuum Chamber Vibration / Slip Table Vibration Controller Accelerometer Mechanical Shock System Accelerometer Test Chamber (Impact) Hydraulic Press (Crush) Insulation Resistance Tester Stopwatch Page 1 of 4

3 High Rate Discharge Performance at 20 C Charge (Capacity) Retention and Recovery Charge (Capacity) Recovery After Long Term Storage Endurance in Cycles Battery Internal Resistance Physical Examination Rated Capacity (including at temperature testing) Rapid Discharge (including at temperature testing) Constant Current Discharge (including at temperature testing) IEC IEC 61960, RTCA DO-347, IEC 61960, IEC 61960, IEC 61960, RTCA DO-347 RTCA DO-347, RTCA DO-347, and Nickel and and Secondary Li Ion and Secondary Li Ion and Thermal Chamber Impedance Meter Misc. Dimensional Measurement Equipment RTCA DO-347 Secondary Li Ion Charge Stability Temperature Shock Temperature shock chamber Humidity Handle Strength Strength of connector receptacle Constant Voltage Discharge (including at temperature testing) RTCA DO-347, Secondary Li Ion and Charge Acceptance RTCA DO-347, Secondary Li Ion Duty Cycle Performance RTCA DO-347, Secondary Li Ion Deep Discharge RTCA DO-347, Secondary Li Ion, and Precision Resistor Acceptance Test Procedure RTCA DO-347 Secondary Li Ion N/A Page 2 of 4

4 Short Circuit with Protection Disabled Overcharge with Protection Disabled RTCA DO-347, UL 2054 RTCA DO-347 Secondary Li Ion Secondary Li Ion Thermal Runaway Containment RTCA DO-347 Secondary Li Ion Shelf Life RTCA DO-347 Secondary Li Ion Float Life RTCA DO-347 Secondary Li Ion Abnormal Charging Test UL 2054, UL 1642 Abusive Overcharge Test UL 1642, UL 2054 Forced Discharge Test UL 2054, UL 1642 Limited Power Source UL 2054 Battery pack component and surface temperature tests UL 2054 Secondary Li Ion 250N steady force test UL 2054 Secondary Li Ion Induced Destructive Overcharge Cell and Battery Application Testing ANSI C18.1M, Part 1:2015 and IEC :2011 Portable Primary Cells and with Aqueous Electrolyte Ignition Source Point Heat Apparatus Stopwatch Force Indicator Mechanical Press Misc. Mechanical Measurement Equipment Page 3 of 4

5 Note: 1. This scope is formatted as part of a single document including Certificate of Accreditation No. AT Page 4 of 4