FC Catalogue Section 4 ntennas and Reflectors. Large antenna specifications (.7m, 4.m & 5.0m diameter). -ft/.7m diameter motorized antenna system. 4-ft/4.m diameter motorized antenna system 4. 6-ft/5.0m diameter motorized antenna system 5. Large antenna reflector specifications 6. Large antenna reflector drawings 7. Trailer mounted.7 meter motorized antenna 8. Trailer mounted 5.0 meter motorized antenna 9. Trailer Specifications 0. Small antenna reflector specifications. ntenna and Pipe Mount dapter photographs. 0.76m diameter reflector drawing..m diameter reflector drawing 4..8m diameter reflector drawing 5..4m diameter reflector
FC Large ntenna Specifications PR-Series ntenna PR--xCF PR-4-xCF PR-6-xCF Effective aperture.66-meter 4. meter 5.0-meter Reflector type Prime Focus, axial Prime Focus, axial Prime Focus, axial Reflector (x = ) piece piece piece Reflector material Fiberglass Fiberglass Fiberglass Reflector Coating Zinc Zinc Zinc Reflector weight 00 lbs 550 lbs 800 lbs Focal-length 4.9-inches 60-inches 60-inches f/d 0.05 0.57 0.05 VSWR.5:.5:.: Mid band Gain Rx (4GHz) 4.0 d 4.5d 44.0 d Rx (.GHz) 50.8 d 5.6 d 5.6 d / power beamwidth Noise Temp Rx - C.45 deg.5 deg.0 deg Rx -Ku 0.46 deg 0.4 0.40 deg t 0 Elevation 4 K 9 K 9 K t 0 Elevation 7 K 4 K 4 K Feed Type DPCK DPCK DPCK C&Ku RO C&Ku RO C&Ku RO Feed mount 4 spars 4 spars 4 spars Wind Loading 5 mph 5 mph 5 mph Temp range -5 to +5 C -5 to +5 C -5 to +5 C Mount Type Elevation/zimuth adjustable, High Wind ring based, galvanized steel pedestal. Elevation adjusts 5 to 90 degrees and zimuth adjustment range 60 degrees. lternate feed types for S, C, X, & Ku and frequencies are available. 0//08 ntennas For Communications Page
4 REVISION HISTORY ZONE REV DESCRIPTION DTE PPROVED Value 0/0/009 jongho PR 90 46 5/6 in 0 /6 in 6 5/6 in Elevation angle = 0 degree Elevation angle = 80 degrees -D VIEW 4 PRELIMINRY These documents by ntennas for Communications contain information of a proprietary nature and shall not be copied or duplicated in whole or in part or used in whole or in part for any purpose other than for preparation of bids or fabrication.. LL MCHINED SURFCES TO E 5 MICROINCHES OR SMOOTHER.. LL DIMENSIONS RE IN INCHES..X `. [.5mm] FRCTIONS.XX `.04 [.0mm] ` /6.XXX `.008 [0.mm] NGLE `~ NTENNS DESIGN FC PRODUCTION QULITY PR, 4, 6 Motorized Pedestal Motorized Pedestal for PR, PR4, PR6 PR_6M FOR COMMUNICTIONS INC. OCL, FLORID SIZE CGE CODE DWG NO PR_6 Motorized Pedestal0 DRWING Y SCLE USE FOR SHEET J. LEE MNUFCTURING 0/0/009 /4 = ' /
4 REVISION HISTORY ZONE REV DESCRIPTION DTE PPROVED Value 0/0/009 jongho PR4 90 68 in 0 5/6 in Elevation angle = 0 degree 6 7/6 in Elevation angle = 80 degrees -D VIEW 4 PRELIMINRY These documents by ntennas for Communications contain information of a proprietary nature and shall not be copied or duplicated in whole or in part or used in whole or in part for any purpose other than for preparation of bids or fabrication.. LL MCHINED SURFCES TO E 5 MICROINCHES OR SMOOTHER.. LL DIMENSIONS RE IN INCHES..X `. [.5mm] FRCTIONS.XX `.04 [.0mm] ` /6.XXX `.008 [0.mm] NGLE `~ NTENNS DESIGN FC PRODUCTION QULITY PR, 4, 6 Motorized Pedestal Motorized Pedestal for PR, PR4, PR6 PR_6M FOR COMMUNICTIONS INC. OCL, FLORID SIZE CGE CODE DWG NO PR_6M Motorized Pedestal0 DRWING Y SCLE USE FOR SHEET J. LEE MNUFCTURING 0/0/009 /4 = ' /
4 REVISION HISTORY ZONE REV DESCRIPTION DTE PPROVED Value 0/0/009 jongho PR6 90 98 5/6 in n46 in 0 4 /6 in 9 in Elevation angle = 0 degree riser is required Elevation angle = 80 degrees -D VIEW 4 PRELIMINRY These documents by ntennas for Communications contain information of a proprietary nature and shall not be copied or duplicated in whole or in part or used in whole or in part for any purpose other than for preparation of bids or fabrication.. LL MCHINED SURFCES TO E 5 MICROINCHES OR SMOOTHER.. LL DIMENSIONS RE IN INCHES..X `. [.5mm] FRCTIONS.XX `.04 [.0mm] ` /6.XXX `.008 [0.mm] NGLE `~ NTENNS DESIGN FC PRODUCTION QULITY PR, 4, 6 Motorized Pedestal Motorized Pedestal for PR, PR4, PR6 PR_6M FOR COMMUNICTIONS INC. OCL, FLORID SIZE CGE CODE DWG NO PR_6 Motorized Pedestal04 DRWING Y SCLE USE FOR SHEET J. LEE MNUFCTURING 0/0/009 /4 = ' /
FC Large ntenna Reflector Specifications PR-Series ntenna PR--xCR PR-4-xCR PR-6-xCR Effective aperture.66-meter 4. meter 5.0-meter Reflector type Prime Focus, axial Prime Focus, axial Prime Focus, axial Reflector (x = ) piece piece piece Reflector material Fiberglass Fiberglass Fiberglass Reflector Coating Zn/l/Ni Zn/l/Ni Zn/l/Ni Reflector weight 00 lbs 600 lbs 00 lbs Focal-length 4.9-inches 60-inches 60-inches f/d 0.05 0.57 0.05 Wind Loading 5 mph 5 mph 5 mph (Survival with appropriate pedestal) Temp range -5 to +5 C -5 to +5 C -5 to +5 C Ultra Lite models are available with 40% lower weight Zinc, luminum or Nickel depending on frequency 0/0/08 ntennas For Communications Page
4 REVISION HISTORY ZONE REV DESCRIPTION DTE PPROVED Value 0/0/009 jongho 6'-7" [5. m] 7'-8" [. m] 4'-" [4. m] 7'-8" [. m] '-" [.7 m] 8' [.4 m] 4 in 4 in 4 in 46 in PR6 46 in PR4 46 in PR Donut ack Frames are same for all PR, PR4, and PR6 4 PRELIMINRY These documents by ntennas for Communications contain information of a proprietary nature and shall not be copied or duplicated in whole or in part or used in whole or in part for any purpose other than for preparation of bids or fabrication.. LL MCHINED SURFCES TO E 5 MICROINCHES OR SMOOTHER.. LL DIMENSIONS RE IN INCHES..X `. [.5mm] FRCTIONS.XX `.04 [.0mm] ` /6.XXX `.008 [0.mm] NGLE `~ NTENNS DESIGN FC PRODUCTION QULITY PR, 4, 6 Motorized Pedestal Motorized Pedestal for PR, PR4, PR6 PR_6M FOR COMMUNICTIONS INC. OCL, FLORID SIZE CGE CODE DWG NO PR_6 Motorized Pedestal05 DRWING Y SCLE USE FOR SHEET J. LEE MNUFCTURING 0/0/009 /4 = ' /
4 REVISION HISTORY ZONE REV DESCRIPTION DTE PPROVED Value 0/06/009 jongho '-7" [6.58 m] 7'-8" [.4 m] '- /4" [4.0 m] -D VIEW '- /4" [0.40 m] 0'- /4" [6.8 m] 4 PRELIMINRY These documents by ntennas for Communications contain information of a proprietary nature and shall not be copied or duplicated in whole or in part or used in whole or in part for any purpose other than for preparation of bids or fabrication.. LL MCHINED SURFCES TO E 5 MICROINCHES OR SMOOTHER.. LL DIMENSIONS RE IN INCHES..X `. [.5mm] FRCTIONS.XX `.04 [.0mm] ` /6 PR6M.XXX `.008 [0.mm] NGLE `~ NTENNS FOR COMMUNICTIONS INC. FC OCL, FLORID DESIGN PRODUCTION SCLE USE FOR QULITY 0/06/009 SHEET / PR6 Motorized, Transportable 6ft folding antenna on ' trailer SIZE PR6M_'Trailer0 CGE CODE DWG NO DRWING Y J. LEE /4 = ' MNUFCTURING
4 REVISION HISTORY ZONE REV DESCRIPTION DTE PPROVED Value 0/06/009 jongho 75 ELEVTION NGEL = 5 degrees Rear Deck Folded 4 PRELIMINRY These documents by ntennas for Communications contain information of a proprietary nature and shall not be copied or duplicated in whole or in part or used in whole or in part for any purpose other than for preparation of bids or fabrication.. LL MCHINED SURFCES TO E 5 MICROINCHES OR SMOOTHER.. LL DIMENSIONS RE IN INCHES..X `. [.5mm] FRCTIONS.XX `.04 [.0mm] ` /6 PR6M.XXX `.008 [0.mm] NGLE `~ NTENNS FOR COMMUNICTIONS INC. FC OCL, FLORID DESIGN PRODUCTION SCLE USE FOR QULITY 0/06/009 SHEET / PR6 Motorized, Transportable 6ft folding antenna on ' trailer SIZE PR6M_'Trailer0 CGE CODE DWG NO DRWING Y J. LEE /4 = ' MNUFCTURING
-foot ntenna Trailer Model TR-6. 0 Overall Trailer length (' 7" with antenna). 8 Overall width. 78 deck width 4. I-beam Galvanized steel construction with Diamond plate floor and 4- gauge steel cross member pedestal supports. 5. Hitch for -inch Hitch ball 6. Trailer weight with PR6 antenna assembly 500 lbs 7. Tongue weight 400 lbs 8. Leveling jacks 4 each 0. Pedestal mount interface for FC Ring ased, trailer mount pedestal. Max height -ft -in. with PR6 antenna (with foldable reflector wings). Running Gear; Double axle, Springs, Wheels, Tires and single-axle Surge rakes (includes 4 wheels + Spare wheel).. Electrical wire harness with Turn Signals, Tail Lights and rake lights. 4. Hand cranks or motors for elevation & azimuth setting/adjustment (optional). 5. Steel tie down straps for site blocking and anchoring (optional) NTENNS FOR COMMUNICTIONS 50 CYPRESS ROD, OCL, FL 447 WWW.RDOME.NET WWW.FCST.COM WWW.TLLGUIDE.COM TEL (5) 687-4 FX (5) 687-0
FC Small ntenna Reflector Specifications PR Series Reflector P/N PR.5-KR PR4-KR PR6-KR PR8-Kr Effective aperture 0.76 meter.-meter.8-meter.4 meter Reflector type Prime Focus Prime Focus Prime Focus Prime Focus Reflector piece piece piece piece Reflective coating Zn/l/Ni Zn/l/Ni Zn/l/Ni Zn/l/Ni Reflector weight 5 lbs 40 lbs 80 lbs 50 lbs focal-length 9.0-inches 4.6-inches 7.4-inches 40-inches f/d 0.05 0.05 0.8 0.46 Wind Loading 5 mph 5 mph 5 mph 5 mph (Survival with appropriate pipe mast or pedestal) Temp range -5 to +5 C -5 to +5 C -5 to +5 C -5 to + 5 C Mount Interface 8 diameter 8 diameter 8 diameter 8.9 diameter olt circle - olt circle bolt circle bolt circle 4 eq. spaced bolts eq. spaced bolts eq. spaced bolts eq. spaced bolts Ultra Lite models with a 40% lower weight are available. Zinc, luminum or Nickel depending on frequency Revision.5 ntennas For Communications Page
FC.8 meter antenna - Model PR-6T-KF Pipe Mount daptor - for PR.5, 4 and 6 antennas FC PR-.5 antenna & roadband Log Periodic Feed