000 Electro-Pneumatic Regulator Series 000/000 Standard Specifications Symbol Straight type Right angle type Model Minimum supply pressure Maximum supply pressure Regulating pressure range Voltage Power supply Current consumption Input signal Input impedance () put signal (monitor output) put pressure display Weight Current type Voltage type Preset input Current type Voltage type Preset input Accuracy Minimum unit Ambient and fluid temperature Enclosure Analog output Switch output Sensitivity Temperature characteristics 0 0 () How to Order 0 0 0 0 Set pressure +MPa MPa MPa 05 to MPa 05 to MPa 05 to MPa 4V DC ±%, to 5V DC 4 to 0mA, 0 to 0mA 0 to 5V DC, 0 to V DC 4 points 50Ω or less Approx. 6.5kΩ Approx..7kΩ 05 05 Power supply voltage 4V DC type: A or less Power supply voltage to 5V DC type: 8A or less to 5V DC (load impedance: kω or more) 4 to 0mA (sink type) (load impedance: 50Ω or less) NPN open collector output: Max. 0V, 0mA PNP open collector output: Max. 0mA Within ±% (full span) Within % (full span) Within ±% (full span) Within % (full span) Within ±% (full span)/ C ±% (full span) MPa:, kgf/cm :, bar:, PSI: (), kpa: 0 to 50 C (with no condensation) IP65 equivalent 50g 645g Note ) wire type 4 to 0mA is not available. Power supply voltage (4V DC or to 5V DC) is required. Note ) Select either analog output or switch output. Further, when switch output is selected, select either NPN output or PNP output. Note ) The minimum unit for 05 is PSI. AC AV AU AF AR IR VEX AW AMR AWM AWD VBA VE VY AL Power supply voltage 0 0 4 Model 000 000 4V DC to 5V DC Monitor output None (for preset input) Analog output to 5V DC Switch output/npn output Switch output/pnp output Analog output 4 to 0mA 0 0 Pressure range 5 MPa MPa MPa 0 4 Input signal Current 4 to 0mA Current 0 to 0mA Voltage 0 to 5V DC Voltage 0 to V DC Preset input Thread type N T F Rc(PT) NPT NPTF (PF) 0 Port size 4 /4 (000, 000) /8 (000, 000) / (000) S 4 5 Cable connector type S L N Pressure display unit Straight type m Right angle type m Without cable connector Bracket B C Without bracket MPa kgf/cm bar PSI kpa.-
000 Series 000/000 tspacer Specification Combinations Specifications : Standard specifications : Combination possible Blank: Combination not possible Applicable model Symbol 0 0 Approx. 89 Approx. 78 qaf000 wafm000 e000 e rt-bracket 000 Set pressure max. MPa Set pressure max. MPa Set pressure max. MPa Connection Rc(PT) /4 Connection Rc(PT) /8 Connection Rc(PT) / Bracket Accessories Bracket Connection NPT/4 Connection NPT/8 Connection NPT/ Connection (PF) /4 Connection (PF) /8 Connection (PF) / Standard specifications Optional specifications 5 0 0 04 B C N0 N0 N04 F0 F0 F04 Approx. 4 Approx. 7 Modular Connection Part Numbers Attachments Description Air filter Mist separator T-bracket Spacer Spacer with Spacer with T-bracket 0 AF000 AFM000 BL BT Y0 Y0L Y0T 0 AF4000 AFM4000 B4L B4T Y40 Y40L Y40T Modular Products and Accessory Combinations Applicable products and accessories q Air filter w Mist separator e r T-bracket t Spacer y Spacer with u Spacer with T-bracket Applicable model 0 0 AF000 AF4000 AFM000 AFM4000 BL B4L BT B4T Y0 Y40 Y0L Y40L Y0T Y40T Accessories (Optional)/Part Numbers Description Part No. 0 0 P004 INI-98-0-6 Dimensions 40 5 () (7) 0 6 50 4-ø5.5 6 84 4-ø7 7 50 6 60 0 70 6 7 4 qaf4000 wafm4000 e000 5 5 7 R.5..6 4-ø5.5.-
Electro-Pneumatic Regulator Series 000/000 Working Principles When the input signal rises, the air supply solenoid valve () turns ON, and the exhaust solenoid valve () turns OFF. Therefore, supply pressure passes through the air supply solenoid valve () and is applied to the pilot chamber (). The pressure in the pilot chamber () increases and operates on the upper surface of the diaphragm (4). As a result, the air supply valve (5) linked to the diaphragm (4) opens, and a portion of the supply pressure becomes output pressure. This output pressure feeds back to the control circuit (8) via the pressure sensor (7). Here, a correct operation functions until the output pressure is proportional to the input signal, making it possible to always obtain output pressure proportional to the input signal. Working Principle Diagram Block diagram Power supply Input signal () Air supply solenoid valve (4) Diaphragm (6) Exhaust valve (5) Supply valve SUP Pressure display (8) Control circuit Supply pressure put signal () Exhaust solenoid valve (7) Pressure sensor () Pilot chamber EXH EXH AC AV AU AF AR IR VEX AW AMR AWM AWD VBA VE VY AL Input signal + (8) Control circuit () Air supply solenoid valve () Exhaust solenoid valve (4) Diaphragm Pilot valve put pressure (7) Pressure sensor.-
Series 000/000 Series 0 0 9 8 7 6 5 4 0 0 4 6 8 Set pressure: 5MPa 5 Supply pressure: MPa 5 Supply pressure: MPa 0 5 0 5 0 5 0 00 400 600 0 0 00 400 600 800 Series 0 0 9 8 7 6 5 4 0 0 4 6 8 Set pressure: 5MPa 5 Supply pressure: MPa 5 Supply pressure: MPa 0 5 0 5 0 5 0 0 500 0 500 000 0 0 500 0 500 000.-4
Electro-Pneumatic Regulator Series 000/000 Series 0 Series 0 Set pressure: MPa 0 500 0 500 000 Supply pressure: MPa 0 4 6 8 0 500 0 500 000 0 4 6 8 Supply pressure: MPa AC AV AU AF AR IR VEX AW AMR AWM AWD VBA VE VY AL Set pressure: MPa Supply pressure: MPa Supply pressure: MPa 0 0 000 000 4000 50006000 0 0 000 000 4000 5000.-5
Series 000/000 Series 05 5 0 5 0 4 6 8 Set pressure: MPa. Supply pressure: MPa 0 500 0 500 000 500 Supply pressure: MPa 0 500 0 500 000 500 Series 05 0 4 6 8 Set pressure: MPa. 0 0 000 000 4000 5000 60007000 Supply pressure: MPa 0 0 000 000 4000 5000 6000 Supply pressure: MPa.-6
Electro-Pneumatic Regulator Series 000/000 Dimensions 0 Cable connector (4 wire) Cable connector (4 wire) Right angle type Note) Straight type 50 4-ø7 Mounting hole () AC AV UNLOCK RESET SET LOCK 40 5 000 000 AU AF 84 Note) Do not attempt to rotate, as it does not turn. AR IR.5 M X Cable connection threads VEX AW () AMR AWM AWD 000 SUP () () 9 Solenoid valve EXH 9.5 Rc(PT) /4 Exhaust port EXH () VBA VE VY 6 P004 (optional) 4-M5 X thread depth 6mm through Mounting hole -Rc(PT) /4, /8 Port size AL 5 9 R.5 5 7 6 () 0 (7) 6 INI-98-0-6 (optional) -Rc(PT) /4, /8 SUP port, port.-7
Series 000/000 Dimensions 0 66 Cable connector (4 wire) Right angle type Note) Cable connector (4 wire) Straight type 50 4-ø7 Mounting hole () RESET SET 40 5 UNLOCK LOCK 000 000 84 Note) Do not attempt to rotate, as it does not turn..5 M X Cable connection threads () 000 Solenoid valve EXH 4 SUP () () 5.7 8 5 Rc(PT) / Exhaust port EXH () 6 P004 (optional) -Rc(PT) /4, /8, / Port size 4-M5 X thread depth 6mm through Mounting hole 5 0 5 R.5 5 7 6.-8 () 0 (7) 6 INI-98-0-6 (optional) -Rc(PT) /4, /8, / SUP port, port