Alarms & Remote Start Automotive Data Solutions Inc. INSTALL GUIDE ADS-AL(DL)-VW7-EN AVAILABLE FOR : ADS-AL CA Rev. Date: March 03, 06 Doc. No.: ##789## U.S. PATENT NO. 8,856,780 VW7 The brand names and logos found in this guide are property of their respective owners. NOTICE: The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself or to the installed device. This device must be installed by a certified technician. This guide has been written for properly trained technicians; a certain level of skill & knowledge is therefore assumed. Please!review the Installation Guide carefully before beginning any work.
Page of ADS-AL(DL)-VW7-EN Doc. No.: ##789## 06030 INSTALL TYPE SELECTION features Make MoDel Year InStall type SecUre takeover arm oem alarm DISarM oem alarm Door lock Door Unlock trunk/hatch release Door StatUS output VolkSWaGen trunk StatUS output HooD StatUS output* tachometer output Brake PeDal StatUS output e-brake output Golf PTS AT 5 Golf PTS MT 5 *Available only if vehicle is equipped with factory hood switch.
Page 3 of ADS-AL(DL)-VW7-EN Doc. No.: ##789## 06030 COMPONENT LOCATOR A C B F D E
Page 4 of ADS-AL(DL)-VW7-EN Doc. No.: ##789## 06030 TYPE - WIRE CROSS REFERENCE CHART - OF Make WolkSWaGen MoDel Year WIre DeScrIPtIon connector name connector color connector type PoSItIon WIre color PolarItY MoDUle location component locator CanH ~ Black 6 pin 6 Orange/Green (DATA) Module, bottom of steering column F CanL ~ Black 6 pin 5 Orange/Brown (DATA) Module, bottom of steering column F Ignition ~ Purple 6 pin 0 Black/Blue (+) OBDII connector B Golf PTS AT 5 V ~ Purple 6 pin 6 Red/White (+) OBDII connector B Brake C Black/White 73 pin 58 Black/Red (+) BCM C PTS ~ Black 6 pin 3 Purple (-) Module, bottom of steering column F PTS ~ Black 6 pin 04 Purple/Blue (-) Module, bottom of steering column F Parking Light ~ Red 0 pin 08 Red/White (+) Light switch A Parking Light ~ Red 0 pin 03 Gray/Yellow (+) Light switch A Immobilizer ~ Black 0 pin 0 Blue (DATA) Immobilizer D
Page 5 of ADS-AL(DL)-VW7-EN Doc. No.: ##789## 06030 TYPE - WIRING DIAGRAM - OF TWO KEYS ARE REQUIRED FOR THIS INSTALLATION. ONE KEY WILL REMAIN PERMANENTLY IN THE VEHICLE. THE OTHER KEY WILL BE USED FOR THE PROGRAMMING PROCEDURE. IT WILL THEN BE RETURNED TO THE OWNER. IMMOBILIZER CONNECTOR - BLACK IMMOBILIZER 5-6 LOOPS AROUND KEYFOB REMOVE BATTERY REMOTE STARTER STARTER (+) OUTPUT PARKING LIGHT V (-) (+) OUTPUT INPUT V (+) INPUT TACH (AC) INPUT E-BRAKE STATUS (-) INPUT STARTER (+) OUTPUT TRUNK (-) OUTPUT UNLOCK (-) OUTPUT LOCK (-) OUTPUT V (+) GROUND (-) GROUND WHEN RUNNING (-) OUTPUT DATA MODE REQUIRED -> IGNITION (+) INPUT/OUTPUT REQUIRED -> BRAKE STATUS (+) INPUT REQUIRED -> HOOD STATUS (-) INPUT OPTIONAL -> TRUNK STATUS (-) INPUT OPTIONAL -> DOOR STATUS (-) INPUT AMP DIODE N400 LEGEND NOT REQUIRED IN DATA MODE (-WAY) NOT REQUIRED IN DATA MODE (-WAY) USE DATA MODE OR HARDWIRE MODE DATA MODE GWR (-) INPUT - BLUE/WHITE (NC) WHITE GROUND - BLACK V (+) - RED LOCK/ARM (-) INPUT - GREEN/BLACK UNLOCK/DISARM (-) INPUT - BLUE/BLACK TRUNK (-) INPUT - RED/WHITE (NC) BROWN (NC) PURPLE/YELLOW (NC) PURPLE/BLACK (NC) WHITE STARTER (+) INPUT - BLACK/WHITE E-BRAKE STATUS (-) OUTPUT - GREEN TACH (AC) OUTPUT - PURPLE/WHITE WHITE/BLACK - IMMOBILIZER VEHICLE SIDE WHITE/RED - IMMOBILIZER CONNECTOR SIDE WHITE - IMMOBILIZER CONNECTOR SIDE YELLOW/BLACK - DOOR STATUS (-) OUTPUT YELLOW/RED - TRUNK STATUS (-) OUTPUT YELLOW - HOOD STATUS (-) OUTPUT BROWN/RED - CANH BROWN/YELLOW - CANL ORANGE/BLACK (NC) ORANGE/WHITE (NC) ORANGE - BRAKE (+) OUTPUT PINK/BLACK (NC) PINK - IGNITION (+) INPUT 5 AMPS BLUE/RED (NC) BLUE/YELLOW (NC) GREEN/RED - PTS (-) OUTPUT GREEN/YELLOW (NC) GRAY/RED - PTS (-) OUTPUT GRAY/YELLOW (NC) V (+) 3 4 5 6 7 8 6 5 4 3 0 9 9 0 3 4 5 6 IGNITION (+) MODULE, BOTTOM OF STEERING COLUMN BLACK OBDII CONNECTOR 8 7 6 5 4 3 CANL CANH PTS (-) PTS (-)
Page 6 of ADS-AL(DL)-VW7-EN Doc. No.: ##789## 06030 TYPE - WIRING DIAGRAM - OF PARKING LIGHT SWITCH RED 3 4 5 6 7 8 9 0 PARKING LIGHT (+) PARKING LIGHT (+) 86 87 87A 85 BCM 30 BLACK/WHITE BRAKE (+) 3 4 5 6 7 8 9 0 3 4 5 6 7 8 9 0 3 4 5 6 7 8 9 30 3 3 33 34 35 36 37 38 39 40 4 4 43 44 45 46 47 48 49 50 5 5 53 54 55 56 57 58 59 60 6 6 63 64 65 66 67 68 69 70 7 7 73
Page 7 of ADS-AL(DL)-VW7-EN Doc. No.: ##789## 06030 TYPE - WIRE CROSS REFERENCE CHART - OF WolkSWaGen Make MoDel Year WIre DeScrIPtIon connector name connector color connector type PoSItIon WIre color PolarItY MoDUle location component locator CanH ~ Black 6 pin 6 Orange/Green (DATA) Module, bottom of steering column F CanL ~ Black 6 pin 5 Orange/Brown (DATA) Module, bottom of steering column F Ignition ~ Purple 6 pin 0 Black/Blue (+) OBDII connector B Golf PTS MT 5 V ~ Purple 6 pin 6 Red/White (+) OBDII connector B PTS ~ Black 6 pin 3 Purple (-) Module, bottom of steering column F PTS ~ Black 6 pin 04 Purple/Blue (-) Module, bottom of steering column F Parking Light ~ Red 0 pin 08 Red/White (+) Light switch A Parking Light ~ Red 0 pin 03 Gray/Yellow (+) Light switch A Clutch ~ Black 05 pin 0 Purple/White (-) Clutch pedal E Clutch ~ Black 05 pin 04 White/Red (OPEN) Clutch pedal E Immobilizer ~ Black 0 pin 0 Blue (DATA) Immobilizer D
Page 8 of ADS-AL(DL)-VW7-EN Doc. No.: ##789## 06030 TYPE - WIRING DIAGRAM - OF TWO KEYS ARE REQUIRED FOR THIS INSTALLATION. ONE KEY WILL REMAIN PERMANENTLY IN THE VEHICLE. THE OTHER KEY WILL BE USED FOR THE PROGRAMMING PROCEDURE. IT WILL THEN BE RETURNED TO THE OWNER. IMMOBILIZER CONNECTOR - BLACK IMMOBILIZER 5-6 LOOPS AROUND KEYFOB REMOVE BATTERY REMOTE STARTER NEG. STARTER (-) OUTPUT PARKING LIGHT V (-) (+) OUTPUT INPUT V (+) INPUT TACH (AC) INPUT E-BRAKE STATUS (-) INPUT STARTER (+) OUTPUT TRUNK (-) OUTPUT UNLOCK (-) OUTPUT LOCK (-) OUTPUT V (+) GROUND (-) GROUND WHEN RUNNING (-) OUTPUT DATA MODE REQUIRED -> IGNITION (+) INPUT/OUTPUT REQUIRED -> BRAKE STATUS (+) INPUT REQUIRED -> HOOD STATUS (-) INPUT OPTIONAL -> TRUNK STATUS (-) INPUT OPTIONAL -> DOOR STATUS (-) INPUT AMP DIODE N400 LEGEND NOT REQUIRED IN DATA MODE (-WAY) NOT REQUIRED IN DATA MODE (-WAY) USE DATA MODE OR HARDWIRE MODE DATA MODE GWR (-) INPUT - BLUE/WHITE (NC) WHITE GROUND - BLACK V (+) - RED LOCK/ARM (-) INPUT - GREEN/BLACK UNLOCK/DISARM (-) INPUT - BLUE/BLACK TRUNK (-) INPUT - RED/WHITE (NC) BROWN (NC) PURPLE/YELLOW (NC) PURPLE/BLACK (NC) WHITE STARTER (+) INPUT - BLACK/WHITE E-BRAKE STATUS (-) OUTPUT - GREEN TACH (AC) OUTPUT - PURPLE/WHITE WHITE/BLACK - IMMOBILIZER VEHICLE SIDE WHITE/RED - IMMOBILIZER CONNECTOR SIDE WHITE - IMMOBILIZER CONNECTOR SIDE YELLOW/BLACK - DOOR STATUS (-) OUTPUT YELLOW/RED - TRUNK STATUS (-) OUTPUT YELLOW - HOOD STATUS (-) OUTPUT BROWN/RED - CANH BROWN/YELLOW - CANL ORANGE/BLACK (NC) ORANGE/WHITE (NC) ORANGE - BRAKE (+) OUTPUT PINK/BLACK (NC) PINK - IGNITION (+) INPUT 5 AMPS BLUE/RED (NC) BLUE/YELLOW (NC) GREEN/RED - PTS (-) OUTPUT GREEN/YELLOW (NC) GRAY/RED - PTS (-) OUTPUT GRAY/YELLOW (NC) V (+) 3 4 5 6 7 8 6 5 4 3 0 9 9 0 3 4 5 6 IGNITION (+) MODULE, BOTTOM OF STEERING COLUMN BLACK OBDII CONNECTOR 8 7 6 5 4 3 CANL CANH PTS (-) PTS (-) 3
Page 9 of ADS-AL(DL)-VW7-EN Doc. No.: ##789## 06030 TYPE - WIRING DIAGRAM - OF 3 PARKING LIGHT (+) PARKING LIGHT (+) 3 6 7 8 4 9 5 0 PARKING LIGHT SWITCH RED 87 86 87A 30 85 AMP DIODE N400 CLUTCH (OPEN) 5 4 3 CLUTCH (-) CLUTCH SWITCH BLACK 87 86 87A 30 85
Page 0 of ADS-AL(DL)-VW7-EN Doc. No.: ##789## 06030 INSTALLATION MODE SELECTION Press and release programming button to select installation mode. Press and hold programming button until LED turns solid GREEN to register selection. LED flashes (X) once = DATA MODE LED flashes (X) twice = STANDARD HARDWIRE MODE! After registration, follow Factory Reset Procedure to change installation mode and restart this procedure. MODULE PROGRAMMING PROCEDURE OFF ACC ON START Turn ignition to ON position. 3 OFF ACC ON START Turn ignition to OFF position. ENGINE START ENGINE START STOP STOP Wait, LED will turn solid GREEN for seconds. 4 Module Programming Procedure completed.
XX-XX PATENT INSTALL GUIDE PAGE X-X Page of ADS-AL(DL)-VW7-EN Doc. No.: ##789## 06030 IDENTIFY VEHICLE NOTICE YEAR Locate the Vehicle Identification Number (VIN), identify the 0th character then match it to its corresponding year. Æ 4 3 A 5 Y N 5 T A L 8 D 5 R 0 X Æ a 980 l 990 Y 000 a 00 B 98 M 99 00 B 0 c 98 n 99 00 c 0 D 983 P 993 3 003 D 03 e 984 r 994 4 004 e 04 f 985 S 995 5 005 f 05 G 986 t 996 6 006 G 06 H 987 V 997 7 007 H 07 J 988 W 998 8 008 J 08 k 989 X 999 9 009 k 09 led StatUS Flashing RED DIaGnoStIcS DUrInG ProGraMMInG DUrInG remote Start WItH IGnItIon off Missing/wrong information from firmware or vehicle Incorrectly programmed Solid RED Waiting for more vehicle information Incorrectly programmed Flashing GREEN Additional steps required to complete programming MODULE DIAGNOSTICS Correctly programmed and operational Incorrectly programmed or connected Not programmed waiting for more vehicle information False ground when running status from remote starter Solid GREEN then OFF Correctly programmed Reset in progress Reset in progress OFF No activity or already programmed Invalid ground when running status from remote starter At rest and ready for a remote start sequence FACTORY RESET PROCEDURE DISCONNECT all connectors from module EXCEPT the black 4-PIN standard or optional data connector. DISCONNECT black 4-PIN standard or optional data connector. 5 6 LED will turn solid red for seconds. RESET COMPLETED. RECONNECT all connectors. 3 PRESS AND HOLD programming button while connecting either 4-PIN standard or optional data connector. 7! Repeat programming procedure. Failure to follow procedure may result with a DTC or a CHECK ENGINE error message. 4 When LED flashes red, RELEASE programming button. This product is protected by one or more of the following patents: U.S. LETTERS PATENT NO. 5,79,55; 6,0,460; 6,43,004; 6,49,6; 6,75,47; 6,97,73; 6,346,876; 6,39,534; 6,59,4; 6,696,97; 6,756,885; 6,756,886; 6,77,67; 6,8,89; 6,94,750; 7,00,40; 7,03,86; 7,046,6; 7,06,37; 7,068,53; 7,05,830; 7,05,679; 7,4,083; 7,369,936; 7,378,945; 7,489,33; 7,50,937; CANADIAN PATENT NO.,30,48;,45,03;,46,670;,44,99;,45,0;,45,07;,45,038;,45,04;,50,893;,45,490;,45,96;,45,487; EUROPEAN PATENT NO.,053,8; DE 69807-94T; U.S. 00045535; 006098; 0060984; 00400784; 008003036; 009007955; EP500565; 538038; 538037;
IMPORTANT Page of ADS-AL(DL)-VW7-EN Doc. No.: ##789## 06030 WARNING: READ BEFORE REMOTE NOTICESTARTING THE VEHICLE I All vehicle doors must be closed and locked prior to remote start sequence. Failure to comply will result in remote starter malfunction. TAKE OVER PROCEDURE - PTS - TO THE VEHICLE OWNER NOTE I È All vehicle doors must be closed and locked prior to remote start sequence. TIME RESTRICTIºN COMING UP! Unlock vehicle door using OEM or after-market remote. TIME RESTRICTIºN Within 45 SECONDS from previous step: 3! Open vehicle door. Enter vehicle. Close vehicle door. Press and release BRAKE pedal. Take over procedure completed. Failure to follow procedure will result in vehicle engine shutdown.