Using your lighted seating set Your seating set comes with an innovative D lighting system. The D's are found in a strip along the bottom of the chairs, loveseat and coffee table. This edge-lit strip is powered by a solar panel that converts the sun's light into storable energy. There's no need to plug your furniture into an outlet, but you do need to place the furniture where it will get around 6 hours of sunlight. If less sunlight is available, the batteries will run down in a shorter period of time. fully charged system should provide about to 6 hours of use, perfect for an evening outside! Installation s shown in step of the assembly instructions, you need to connect the wires that run from the solar panel and the light strip. These two wires end in plastic plugs that need to be connected. Once that's done, simply set your furniture in sunlight to charge the batteries. Use ach of the solar panels have a push button that operates the D lights. Here's how the button works: - One push: turns the lights on at low brightness. -Two pushes: turns the lights to medium brightness. -Three pushes: turns the lights to maximum brightness. -our pushes: turns the lights off. Care reeport's solar panels do best when kept clean and in a sunny location. Clean the panel with a slightly damp cloth whenever you see dust building up. Solar batteries don't do well when left outside over the winter. We recommend removing them during cold weather. They can be easily replaced by removing the bottom panel of the solar array, removing the old batteries, and replacing them with new batteries with the same specifications as the old ones. The D lights are long lasting and should not require replacing or maintenance. Use care when moving the furniture to avoid kicking or bumping the light strip. Owner s Manual Please refer to part numbers when reordering or questions or comments about product: mail: acs@americancustomerservice.com or Call toll-free: -888-577-985 Made in / Hecho en CHIN Distributed by Sears, Roebuck and Co., Hoffman states, I 6079 See our extensive assortment of outdoor living products on-line at www.sears.com and www.kmart.com RPORT PC STING ST Caution: Use care when handling and installing the solar panel. Product Code: D7 M6 UPC Code: 8857 005 Date of Purchase: / /
Note: Do not tighten bolts all the way until you have assembled the chair. Once assembly is complete, go back and tighten each bolt. Seating Chair O P Step : Connect and to form Seat ack ssembly. J COD PRTS QTY. C COD PRTS QTY. J M6x50mm K M6x0mm D M G N H O I P D M6x0mm M 8 C M6x0mm M6x5mm M6x8mm Step : a) Connect Side Panel C and D to Seat ack ssembly +. b). Connect Seat rame to Side Panel C and D. N
Step : Connect Seat eg Structure K Step : a) Connect Seat ack ssembly to bottom of Seat rame. b) Connect plugs from solar panel and light strip together. H 5 Step 5: Place cushions H, G, and I on chair. G I
Using your lighted seating set Your seating set comes with an innovative D lighting system. The D's are found in a strip along the bottom of the chairs, loveseat and coffee table. This edge-lit strip is powered by a solar panel that converts the sun's light into storable energy. There's no need to plug your furniture into an outlet, but you do need to place the furniture where it will get around 6 hours of sunlight. If less sunlight is available, the batteries will run down in a shorter period of time. fully charged system should provide about to 6 hours of use, perfect for an evening outside! Installation s shown in step of the assembly instructions, you need to connect the wires that run from the solar panel and the light strip. These two wires end in plastic plugs that need to be connected. Once that's done, simply set your furniture in sunlight to charge the batteries. Use ach of the solar panels have a push button that operates the D lights. Here's how the button works: - One push: turns the lights on at low brightness. -Two pushes: turns the lights to medium brightness. -Three pushes: turns the lights to maximum brightness. -our pushes: turns the lights off. Care reeport's solar panels do best when kept clean and in a sunny location. Clean the panel with a slightly damp cloth whenever you see dust building up. Solar batteries don't do well when left outside over the winter. We recommend removing them during cold weather. They can be easily replaced by removing the bottom panel of the solar array, removing the old batteries, and replacing them with new batteries with the same specifications as the old ones. The D lights are long lasting and should not require replacing or maintenance. Use care when moving the furniture to avoid kicking or bumping the light strip. Owner s Manual Please refer to part numbers when reordering or questions or comments about product: mail: acs@americancustomerservice.com or Call toll-free: -888-577-985 Made in / Hecho en CHIN Distributed by Sears, Roebuck and Co., Hoffman states, I 6079 See our extensive assortment of outdoor living products on-line at www.sears.com and www.kmart.com RPORT PC STING ST Caution: Use care when handling and installing the solar panel. Product Code: D7 M6 UPC Code: 8857 005 Date of Purchase: / /
Note: Do not tighten bolts all the way until you have assembled the chair. Once assembly is complete, go back and tighten each bolt. Step : Connect and to form Seat ack ssembly. oveseat O P Step : a) Connect Side Panel C and D to Seat ack ssembly +. b). Connect Seat rame to Side Panel C and D. COD PRTS QTY. C D G H I COD PRTS QTY. J M6x50mm K M N O P J M6x5mm M6x0mm 0 M6x0mm M6x5mm M6x8mm M N
Step : Connect Seat eg Structure Step : a) Connect Seat ack ssembly to bottom of Seat rame. b) Connect plugs from solar panel and light strip together. K 5 H Step 5: Place cushions H, G, and I on chair. I G
Using your lighted seating set Your seating set comes with an innovative D lighting system. The D's are found in a strip along the bottom of the chairs, loveseat and coffee table. This edge-lit strip is powered by a solar panel that converts the sun's light into storable energy. There's no need to plug your furniture into an outlet, but you do need to place the furniture where it will get around 6 hours of sunlight. If less sunlight is available, the batteries will run down in a shorter period of time. fully charged system should provide about to 6 hours of use, perfect for an evening outside! Installation s shown in step of the assembly instructions, you need to connect the wires that run from the solar panel and the light strip. These two wires end in plastic plugs that need to be connected. Once that's done, simply set your furniture in sunlight to charge the batteries. Use ach of the solar panels have a push button that operates the D lights. Here's how the button works: - One push: turns the lights on at low brightness. -Two pushes: turns the lights to medium brightness. -Three pushes: turns the lights to maximum brightness. -our pushes: turns the lights off. Care reeport's solar panels do best when kept clean and in a sunny location. Clean the panel with a slightly damp cloth whenever you see dust building up. Solar batteries don't do well when left outside over the winter. We recommend removing them during cold weather. They can be easily replaced by removing the bottom panel of the solar array, removing the old batteries, and replacing them with new batteries with the same specifications as the old ones. The D lights are long lasting and should not require replacing or maintenance. Use care when moving the furniture to avoid kicking or bumping the light strip. Owner s Manual Please refer to part numbers when reordering or questions or comments about product: mail: acs@americancustomerservice.com or Call toll-free: -888-577-985 Made in / Hecho en CHIN Distributed by Sears, Roebuck and Co., Hoffman states, I 6079 See our extensive assortment of outdoor living products on-line at www.sears.com and www.kmart.com RPORT PC STING ST Caution: Use care when handling and installing the solar panel. Product Code: D7 M6 UPC Code: 8857 005 Date of Purchase: / /
Coffee Table Note: Do not tighten bolts all the way until you have assembled the table. Once assembly is complete, go back and tighten each bolt. Step : ttach leg section to coffee table body. D Step : Connect plugs from solar panel and light strip together. Step : Carefully place glass table top C into inset top section of coffee table body. COD PRTS QTY. COD PRTS QTY. C D 8 M6x8MM 8 C Step : utton to control light settings is at bottom of frame.