Pressure regulators E/P pressure regulators Brochure
Pressure regulators E/P pressure regulators E/P pressure regulator, Qn= 50 l/min Compressed air connection output: G /8 Electr. connection: Plug, EN 750-80, form C Signal connection: input and output, Plug, EN 750-80, form C Pilot valves Accessories Connector with cable, Series CN form C 8 mm, With coding pin 7 Connector with cable, Series CN form C 8 mm screened 8 Mounting for DIN rail, for EV04 9 Mounting kit, for EV04 0 Silencers, Series SI Sintered bronze Pneumatics catalog, online PDF, as of 07-0-6, AVENTICS S.à r.l., subject to change
Pressure regulators E/P pressure regulators E/P pressure regulator, Qn= 50 l/min Compressed air connection output: G /8 Electr. connection: Plug, EN 750-80, form C Signal connection: input and output, Plug, EN 750-80, form C Pilot valves Version Poppet valve Control Analog Certificates CE declaration of conformity Ambient temperature min./max. +5 C / +50 C Medium temperature min./max. +5 C / +50 C Medium Compressed air Max. particle size 50 µm Max. oil content of compressed air 0. mg/m³ 00656 Qn 50 l/min Mounting orientation vertical Operating pressure See table below Hysteresis 0, bar DC operating voltage 4 V Voltage tolerance DC -0% / +0% Permissible ripple 5% Max. power consumption 0. ma Protection class IP54 Compressed air connection input G /8 Compressed air connection output G /8 Compressed air connection, exhaust G /8 Weight 0.6 kg Materials: Housing Seal Die-cast aluminum; Die cast zinc Acrylonitrile butadiene rubber Nominal flow Qn with working pressure 7 bar, with secondary pressure 6 bar and Δp = 0. bar Technical Remarks The min. control pressure must be adhered to, since otherwise faulty switching and valve failure may result! The pressure dew point must be at least 5 C under ambient and medium temperature and may not exceed C. The oil content of compressed air must remain constant during the life cycle. Use only the approved oils from AVENTICS, see chapter Technical information. The protection class is only ensured when the plug is mounted properly. For detailed information, see operating instructions. Operating pressure max. Pressure setting range min./max. Nominal input value Actual output value Fig. Note Part No. [bar] [bar] 8 0. / 6 0-0 ma 0-0 ma Fig. - 560000 8 0. / 6 4-0 ma 4-0 ma Fig. - 56000 8 0. / 6 0-0 V 0-0 ma Fig. - 5600 8 0. / 6 0-0 V - - Fig. ) 56000 0. / 0 0-0 ma 0-0 ma Fig. - 56000 0. / 0 0-0 V - - Fig. ) 5600 ) Output 0V constant to supply a potentiometer Minimum working pressure = 0.5 bar + max. required secondary pressure Additional pressure setting ranges available on request Pneumatics catalog, online PDF, as of 07-0-6, AVENTICS S.à r.l., subject to change
4 Pressure regulators E/P pressure regulators E/P pressure regulator, Qn= 50 l/min Compressed air connection output: G /8 Electr. connection: Plug, EN 750-80, form C Signal connection: input and output, Plug, EN 750-80, form C Pilot valves Dimensions ) mounting space for name plate ) electrical connector can be plugged at 90 intervals ) spacer bushings are supplied loose 4) universal threaded connection, suitable for G/8 as per ISO 8/:000 and /8-7 NPTF D56_0 Functional diagram a) V G V T M T Z M b) U P a) Nominal input value, b) Actual output value. The E/P pressure control valve modulates the pressure corresponding to an analog electrical nominal input value. The integrated electronics make a comparison between the nominal input value and the pressure in the output line (actual value). The controller generates electrical input signals, which either ventilate or exhaust control volume Z of the relay valve by means of two pilot valves (M, M) until the specified pressure is attained in the output line. ) Operating pressure ) Working pressure ) Exhaust D56_ Pneumatics catalog, online PDF, as of 07-0-6, AVENTICS S.à r.l., subject to change
Pressure regulators E/P pressure regulators E/P pressure regulator, Qn= 50 l/min Compressed air connection output: G /8 Electr. connection: Plug, EN 750-80, form C Signal connection: input and output, Plug, EN 750-80, form C Pilot valves 5 Fig., Characteristic and pin assignment for current control with actual output value ) supply voltage ) input current nominal value (ohmic load 00 Ω, max. 50 ma. The voltage at the nominal input value may not exceed V. ) actual output value (max. total resistance of downstream devices < 00 Ω). 4) the supply voltage must be protected by an external M 0.5 A fuse. Connect plug via a shielded cable to ensure EMC. A) plug B) plug D56_0 Fig., Characteristic and pin assignment for voltage control with actual output value [bar] 0 5 0 6 5 4 0 0 4 6 8 0 [V] ) ) ) { { { 0 V + 4 V DC 0 V 0... 0 V DC 0... 0 ma 0 V 4) M 0,5 A A) B) ) Supply voltage ) Nominal input value voltage ) Actual output value (max. total resistance of downstream devices < 50 Ω) 4) The supply voltage must be protected by an external M 0.5 A fuse. Connect plug via a shielded cable to ensure EMC. A) Plug B) Plug 00775 Pneumatics catalog, online PDF, as of 07-0-6, AVENTICS S.à r.l., subject to change
6 Pressure regulators E/P pressure regulators E/P pressure regulator, Qn= 50 l/min Compressed air connection output: G /8 Electr. connection: Plug, EN 750-80, form C Signal connection: input and output, Plug, EN 750-80, form C Pilot valves Fig., Characteristic and pin assignment for potentiometer control without actual output value [bar] 0 6 5 4 ) { 0 V + 4 V DC ) M 0,5 A A) 5 0 0 0 4 6 8 0 [V] 4) ) { 0 V 0... 0 V DC 0 V DC B) D56_40 ) Supply Voltage ) Nominal input value voltage ) The supply voltage must be protected by an external M 0.5 A fuse. Connect plug via a shielded cable to ensure EMC. 4) Potentiometer control (0 - kω (min.), 0-0 kω (max.)) A) Plug B) Plug Pneumatics catalog, online PDF, as of 07-0-6, AVENTICS S.à r.l., subject to change
Pressure regulators E/P pressure regulators 7 Accessories Connector with cable, Series CN form C 8 mm, With coding pin Protection class IP67 Operating voltage DC, max. 0 V DC Operational voltage AC, max. 0 V AC Cable exit angled 90 Materials: Cable sheath Polyvinyl chloride 00940 Technical Remarks The specified protection class is only valid in assembled and tested state. For 4 V DC applications, a coding pin is required to protect against reverse polarity. Max. current Contact assignment Number of wires Cable length L [A] [m] [kg] Weight Note Part No. BN BU GN/YE 6 +E 5 0.068 ) 894606 ) With coding pin Dimensions 8 ) 8 50 5m 00797 ) Coding pin Pneumatics catalog, online PDF, as of 07-0-6, AVENTICS S.à r.l., subject to change
8 Pressure regulators E/P pressure regulators Accessories Connector with cable, Series CN form C 8 mm screened Protection class IP67 Operating voltage DC, max. 4 V DC Operational voltage AC, max. 4 V AC Cable exit angled 90 Materials: Cable sheath Polyvinyl chloride 00940 Technical Remarks The specified protection class is only valid in assembled and tested state. Max. current Contact assignment Number of wires Cable length Weight L [A] [m] [kg] Part No. BK BU BN GN/YE 4 +E 4 5 0.95 8946060 Pneumatics catalog, online PDF, as of 07-0-6, AVENTICS S.à r.l., subject to change
Pressure regulators E/P pressure regulators Accessories 9 Dimensions 8 ) 8 5 40,5 M L 0 4675 Mounting for DIN rail, for EV04 0099 0055 Part No. Type Weight [kg] 56004 Mounting for DIN rail 0.06 Pneumatics catalog, online PDF, as of 07-0-6, AVENTICS S.à r.l., subject to change
0 Pressure regulators E/P pressure regulators Accessories Mounting kit, for EV04 P56_05 D56_05 ) use a screw from the proportional solenoid to secure the angle subbase. Part No. Weight [kg] 56005 0.4 for E/P pressure regulator, series EV04, ED04 Pneumatics catalog, online PDF, as of 07-0-6, AVENTICS S.à r.l., subject to change
Pressure regulators E/P pressure regulators Accessories Silencers, Series SI Sintered bronze Working pressure min./max. Ambient temperature min./max. Medium 0 bar / 0 bar -5 C / +80 C Compressed air Materials: Silencers Thread Sintered bronze Brass P00_060 Compressed air connection Sound pressure level Qn Order quantity Weight Part No. [db] [l/min] [piece] [kg] G /8 75 500 0 0.0 87000000 Dimensions D00_06 Part No. Port G SW Ø D L L 87000000 G /8 6 8 6 Sound pressure level measured at 6 bar at m distance Pneumatics catalog, online PDF, as of 07-0-6, AVENTICS S.à r.l., subject to change
AVENTICS GmbH Ulmer Straße 4 0880 Laatzen, GERMANY Phone +49 5 6-0 Fax +49 5 6-69 www.aventics.com info@aventics.com Find more contact information at www.aventics.com/contact Only use the AVENTICS products shown in industrial applications. Read the product documentation completely and carefully before using the product. Observe the applicable regulations and laws of the respective country. When integrating the product into applications, note the system manufacturer s specifications for safe use of the product. The data specified only serve to describe the product. No statements concerning a certain condition or suitability for a certain application can be derived from our information. The information given does not release the user from the obligation of own judgment and verification. It must be remembered that the products are subject to a natural process of wear and aging. 6-0-07 An example configuration is depicted on the title page. The delivered product may thus vary from that in the illustration. Subject to change. AVENTICS S.à r.l. This document, as well as the data, specifications and other information set forth in it, are the exclusive property of AVENTICS S.à r.l.. It may not be reproduced or given to third parties without its consent. PDF online