TECHNICAL DATA SHEET Mt-x 7 Manitou Telescopic mining
Mt - X 7 mining Lifting Max. capacity Max. lifting height Max. outreach Break-out force with bucket Boom movements speeds (unladen) Lifting / Lowering Extension / Retraction Crowd / Dump Engine Cubic capacity Power Max. torque Injection Cooling Hydraulics Pump 00 kg,90 m,9 m 700 dan 7, /, secs, /, secs,9 /,8 secs PERKINS 0D- T 00 cm 9 HP / 70 kw 9 Nm - 00 rpm direct water "gear type with flow divider 0 l/min - 0 bar" Electrical Battery V - 0 Ah - 70 A EN Alternator V - 8 A - Denso Ai Starter V -. kw AZE Transmission Gear box TURNER mechanical with Torque Converter Forward/Reverse Selector electro-hydraulic Torque Converter SACHS Number of gears (forward/reverse) / Front & Rear axles / Differential "DANA / Limited slip front rigid - rear oscillating" Drive Wheels Permanent wheel drive Tyres 00/80- optional NOKIAN.00-0 Armor Gard Mine Max. travel speed 7 kph (may vary according to applicable regulations) Steering mode wheel steer - steering modes Uphill/downhill safe operating grade up to : (%) Laden drawbar pull 9000 dan Towable mass on trailer with no braking 00 kg with independent braking 000 kg with assisted braking (hydraulic or pneumatic) 000 kg
Mt - X 7 mining Braking & Steering Service brake Control Parking/Emergency brake Control mining Fail-Safe Braking System Hydraulic power brake dual acting master cylinder with independent lines to multi-disk brakes in oil bath on front & rear axles. foot-operated for front & rear axles spring applied hydraulic release (SAHR) on front & rear axles. electro-hydraulic. Cabin manual hydraulic lever. automatic application on engine shut-down. Slope holding performance % Operator test & warning "daily service & park brake test switch procedure warning: Low brake pressure, residual service brake pressure, loss of cabin driver presence." Standards/Guidelines based on ISO 0:0 Emergency steering based on ISO 00:99 Control systems & Warning Stability longitudinal stability limiter with movement cut out Critical functions monitoring & engine shut down Pre-Start Warning Horn "Manitou Guardian Angel mining system - level engine-steering-hydraulic-speed-tip over" s General protections - Fire prevention & control Cabin ROPS ISO:7 - FOPS ISO: 9 Level and Body boom cylinder rod, lights & cabin guards - metallic self cleaning engine pre-filter Electricals Fuse board & main harness Ultimate Fuse Board protection system Wiring and other electrical components "Exhaust in accordance with EPA CTM 0 99, EPA CTM 00 997, UNI EN 79:0, UNI EN 8-:00, including variable engine rpm cycles to simulate real working environment." Fire prevention & control Extinguisher(s) Prevention "Ultimate Wiring protection system (standard in Australia MDG, option other country)" "MANITOU Safe Exhaust System - purifier & diluter reduce exposure to toxic gas: -8% (volume) -0% (mass) -0% (temperature)" x 9Kg Powder "Engine Compartment Fire Prevention System (standard in Australia MDG, option other country)"
Mt-X 7 mining A 00 B 80 C 9 C 8 blind spots on right hand side and rear D 7 fwd/rev directionnal lights, rear light on when rev D 9 warning & danger, controls & pre-op, refelctive hi-visibility, access & maintenance point D 9 E 9 F 8 F 8 G G 0 G 0 I 78 J 8 K 00 L N 90 O Ergonomics, access, visibility LED Lights & Cameras Work lights Cameras Other Markings, Signs, Labelling Visibility Safety System LED 00 lux (x front x rear x boom) Isolation points & miscellaneous Emergency stops Isolation Miscellaneous cabin x - External x "dual pole battery + starter isolators, fuel isolation valve, jump start receptacle, all inside engine bay" "radiator safety cap belts & pulleys safety guards wheel chocks x boom cylinder lock loose wheel nut indicators" Capacities Hydraulic oil 8 l Fuel 0 l Noise and vibration P ( ) 7, P ( ) R 78 db S 98 Environmental noise (LwA) 0 db T 90 Vibration to whole hand/arm <. m/s U 00 Vibration on driver's body.0 m/s U 0 V 800 V 0 Noise at driving position (LpA) Weight 700 kg 98 V 800 W 0 Y ( ),9 Z ( ),8
Mt - X 7 mining OPTIONAL EQUIPMENT Fail safe braking and steering Emergency Steering Control systems & warnings Stability Control: Rated Capacity Limiter External overload light tower indicator for rated capacity limiter (Green, Yellow, Red) Guardian angel mining system - Level Bi-axial spirit level indicator Tyre pressure & temperature monitoring General protection Hydraulic Hose Sleeve Burst Protection Cabin Guard: roof Belly guard (plate) Guard: A/C condensor Elevated breathers Side bumper - Protector bar Rear bumper - Protector bar Steel mudguards Ultimate wiring protection system Nokian.00-0 Armor Gard Mine Fire prevention & control Engine Compartment Fire Prevention System - Fuel lines fire resistant steel braided Fire resistant Fuel filter Turbo Sock Fire Resistant Engine Bonnet Exhaust line / Muffler Insulation Blanket Fire suppression system - Manual & automatic activation Cabin extinguisher Ergonomics access visibility Seat Tractor-Back shape + Autoretracting Seat Belt 7mm wide Air conditioning Maintenance Battery, Starter isolation points + Jump Start Receptacle In External Weatherproof Enclosure Fast fill dry break point - Fuel Fast fill dry break point - Hydraulic oil Central Greasing System Auxiliary hydraulic-electric quick multi-coupling plate system Easy Connect System - Attachment hydraulic hoses Hydraulic locking of attachment on T.S. Predisposition Tyre handler predisposition
Mt - X 7 mining Machine on tyres with forks (Norm EN9-B) 8 Machine on tyres with forks (Norm AS8.9) 8.90 7 800kg.90 7 E 800kg D C B A 00kg 00kg 00kg 000kg 00kg 00kg 900kg 00kg 00kg 000kg 00kg 00kg - 0.m - 0.m.7.9...8...70..8.79..0..09. Machine on tyres with PC0 (Norm EN9-B) Machine on tyres with PC0 (Norm AS8.9) 8.9 7 7.90 8, E D C 800kg B A - 000kg 00kg 00kg 000kg 00kg 00kg 0-00kg 00kg 000kg 00kg 000kg.9..9.90.0... -.7.0.0.90..08
Mt - X 7 mining Machine on tyres with TH (Norm EN9-B) 8 7.0 0kg 000kg 00kg 000kg -7 0.m..70.0..9
Your nearest dealer : HANDLING YOUR WORLD This brochure describes versions and configuration options for Manitou products which may be fitted with different equipment. The equipment described in this brochure may be standard, optional or not available depending on version. Manitou reserves the right to change the specifications shown and described at any time and without prior warning. The manufacturer is not liable for the specifications given. For more information, contact your Manitou dealer. Non-contractual document. Product descriptions may differ from actual products. List of specifications is not comprehensive. The logos and visual identity of the company are the property of Manitou and may not be used without authorisation. All rights reserved. The photos and diagrams contained in this brochure are provided for information only. MANITOU BF SA - Limited company with board of directors - Share capital: 9,7,8 euros - 87 80 08 RCS Nantes FT7EN_A_0_MTX7_Mn