VALVOLINE ZEREX DEXCOOL ANTIFREEZE COOLANT Valvoline ZEREX DEXCOOL antifreeze coolant is a patented* carboxylate formulation with a service life of up to five years or 5, miles. It incorporates stateoftheart organic acid technology in an ethylene glycol base for protection of all cooling system metals including aluminum. ZEREX DEXCOOL antifreeze coolant contains no phosphates, silicates, borates, nitrates, amines and nitrites. Its global formulation meets the phosphatefree requirements of European automobile manufacturers and the silicate free requirement of Asian automobile manufacturers like Toyota, Scion, Acura, Hyundai, Kia, Honda, Isuzu and others. It can be mixed with any DEXCOOL and is approved by Opel, Dae Woo and Saab. It is dyed orange to distinguish its unique chemistry from traditional green and yellow silicate coolants. When diluted 5% with water, ZEREX DEXCOOL protects modern engine components from winter freezing and summer boiling. The chart at the top right provides detailed mixing information. ZEREX DEX COOL antifreeze coolant is storage stable for up to five years as both a concentrate or diluted with water. It contains a high quality defoamer and will not harm gaskets, hoses, plastics or original vehicle paint. ZEREX DEXCOOL is an approved formula for the following specifications: GM 677M GM since 996 Opel SAAB Saturn ZEREX DEXCOOL is formulated to meet or exceed the following antifreeze specifications: ASTM D336 Dae Woo Federal Spec AA87A Fiat Chrysler MS6 since 3 Ford truck since 4 Ford car since Ford WSSM97B44D SAE J34 SAE J94 SAE J84 Scania Simens Wind Turbines TMC of ATA RP3B Volvo Valvoline recommends that spent coolant never be disposed of by dumping into a septic system, storm sewer or onto the ground. Instead, contact your state or local municipality for instructions on where to and how to properly dispose of this coolant and protect our environment. If any coolant is spilled onto the ground, contain the spill and call the state authorities and ask for proper instruction on how to clean up the spill. Trademark of Valvoline or its subsidiaries, registered in various countries 7 Valvoline
ZEREX DEXCOOL Antifreeze/Coolant Boil/Freeze Protection % Antifreeze 4 5 6 7* Freezing Point, F/ C /4 34/36 54/48 9/67 Boiling Point**, F/ C 6/6 65/8 7/33 77/35 * Maximum freeze protection is at 7%. ** Boiling point shown using conventional 5 psig radiator cap. Typical Physical Properties Antifreeze Glycols mass % Corrosion Inhibitors mass % Flash Point F/ C Weight per gallon @ 6 F/6 C lbs / KG Silicates Phosphates 93.5 3.5 3. 5/ 9. 99 / 4.8 max 3 max Water Pump Tests ASTM D89 Pump Cavitation (Extended Test) Test Period Results Specification hours 9 8 ASTM cavitation corrosion rating: perfect perforated Characteristics Specifications Typicals ASTM Method Chloride Silicon Specific gravity, 6/6 F Freezing point, 5% V/V Boiling point, undiluted Boiling point, 5% V/V Effect on engine or vehicle finish Ash content, mass % ph, 5% V/V Reserve alkalinity* Color Effect on nonmetals Storage stability Foaming Cavitationerosion rating 5, max. 5, max...4 34 F/36 C 35 F/6 C 6 F/7 C 5 max 8.3 8.8 Report 5 max. Distinctive No Adverse Effect 5 ml Vol., max. 5 sec. Break, max. 8 min. <5 <5. 34 F/36 C 33 F/6 C 6 F/7 C.36 8.6 4.8 3. Orange No Adverse Effect 5 years 3.7 ml 3 sec. 9 D3634 D D77 D D D9 D87 D D3 D89 *Reserve alkalinity (RA) is a term used to indicate the amount of alkaline inhibitors present in an antifreeze formulation. It is incorrect to relate a high RA with a highquality antifreeze. Present stateoftheart antifreeze formulations contain many new inhibitors which give added protection to certain metals but do not raise the RA number. Trademark of Valvoline or its subsidiaries, registered in various countries 7 Valvoline
Typical ASTM Corrosion Test Results Weight Loss Mg/Specimen Glassware Corrosion Test Spec. Actual ASTM Method Simulated Service Test Hot Surface Corrosion 3 3 6 6 mg/cm /wk 6 3 5 D384 D57 Specimen weight loss.. D434 Electrochemical Minimum, mv Ford Pitting Test >4.7 FLTM BL5 DEXCOOL is a trademark of General Motors Corporation. Used under license DC4. This information only applies to products manufactured in the following location(s): USA, Canada, and Mexico Material/Product Part # ZXEL ZXEL ZXEL ZXELRU ZXELRU Product ZEREX DEXCOOL AFC 6/ GAL ZEREX DEXCOOL AFC 55 GAL Drum ZEREX DEXCOOL Bulk ZEREX DEXCOOL ReadyToUse AFC 6/ GAL ZEREX DEXCOOL ReadyToUse 55 GAL Drum Effective Date: Expiration Date: Replaces: Author's Initials: Pages: 7/7/7 7/7/ 7/8/5 DET 3 Trademark of Valvoline or its subsidiaries, registered in various countries 7 Valvoline
Technical Bulletin Valvoline ZEREX DEXCOOL antifreeze coolant is a patented * carboxylate formulation with a service life of up to five years or 5, miles. It incorporates stateoftheart organic acid technology in an ethylene glycol base for protection of all cooling system metals including aluminum. ZEREX DEXCOOL antifreeze coolant is approved by General Motors to the GM 677M specification. ZEREX DEXCOOL antifreeze coolant contains no phosphates, silicates, borates, nitrates, amines and nitrites. Its global formulation meets the phosphatefree requirements of European automobile manufacturers and the silicate free requirement of Asian automobile manufacturers like Toyota, Scion, Acura, Hyundai, Kia, Honda, Isuzu and others. It can be mixed with any DEXCOOL and is approved by Opel, Dae Woo and Saab. It is dyed orange to distinguish its unique chemistry from traditional green and yellow silicate coolants. When diluted 5% with water, ZEREX DEXCOOL protects modern engine components from winter freezing and summer boiling. The chart at the top right provides detailed mixing information. ZEREX DEXCOOL antifreeze coolant is storage stable for up to five years as both a concentrate or diluted with water. It contains a high quality defoamer and will not harm gaskets, hoses, plastics or original vehicle paint. ZEREX DEXCOOL is formulated to meet or exceed the following antifreeze specifications and/or is recommended: ZEREX DEXCOOL Antifreeze / Coolant % Antifreeze 5 Years / 5, miles / 3, hours GM Approved DEXCOOL 4 5 6 7* Silicate & Phosphate Free Formula ZEREX DEXCOOL Antifreeze/Coolant Boil/Freeze Protection Freezing Point, F/ C /4 34/36 54/48 9/67 Boiling Point**, F/ C 6/6 65/8 7/33 77/35 * Maximum freeze protection is at 7%. ** Boiling point shown using conventional 5 psig radiator cap. ZEREX DEXCOOL Typical Physical Properties Antifreeze Glycols mass % Corrosion Inhibitors mass % Flash Point F/ C Weight per gallon @ 6 F/6 C lbs / KG Si from Silicates Phosphates 93.5 3.5 3. 5/ 9. 99 / 4.8 max 3 max ASTM D336 SAE J34, J84 SAE J94 Ford WSSM97B44D Saab, Opel Approved Scania, Volvo GM 677M DEXCOOL APPROVED Siemens Wind Turbines TMC of ATA RP3B Federal Specification AA87A Navistar CEMS B Type IIIA ZEREX DEXCOOL Water Pump Tests ASTM D89 Pump Cavitation (Extended Test) Test Period Results Specification hours 9 8 ASTM cavitation corrosion rating: perfect perforated Valvoline recommends that spent coolant never be disposed of by dumping into a septic system, storm sewer or onto the ground. Instead, contact your state or local municipality for instructions on where to and how to properly dispose of this coolant and protect our environment. If any coolant is spilled onto the ground, contain the spill and call the state authorities and ask for proper instruction on how to clean up the spill. *US Patents 6,35,7 and 6,6,85 The information contained herein is correct to the best of our knowledge. The recommendations or suggestions contained in this bulletin are made without guarantee or representation as to results. We suggest that you evaluate these recommendations and suggestions in your own laboratory prior to use. Our responsibility for claims arising from breach of warranty, negligence or otherwise is limited to the purchase price of the material. Freedom to use any patent owned by Ashland or others is not to be inferred from any statement contained herein.
Characteristics Specifications Typicals ASTM Method Chloride Silicon Specific gravity, 6/6 F Freezing point, 5% V/V Boiling point, undiluted Boiling point, 5% V/V Effect on engine or vehicle finish Ash content, mass % ph, 5% V/V Reserve alkalinity* Color Effect on nonmetals Storage stability Foaming Cavitationerosion rating 5, max. 5, max...4 34 F/36 C 35 F/6 C 6 F/7 C 5 max 8.3 8.8 Report 5 max. Distinctive No Adverse Effect 5 ml Vol., max. 5 sec. Break, max. 8 min. <5 <5. 34 F/36 C 33 F/6 C 6 F/7 C.36 8.6 4.8 3. Orange No Adverse Effect 5 years 3.7 ml 3 sec. 9 D3634 D D77 D D D9 D87 D D3 D89 *Reserve alkalinity (RA) is a term used to indicate the amount of alkaline inhibitors present in an antifreeze formulation. It is incorrect to relate a high RA with a highquality antifreeze. Present stateoftheart antifreeze formulations contain many new inhibitors which give added protection to certain metals but do not raise the RA number. Typical ASTM Corrosion Test Results Weight Loss Mg/Specimen Glassware Corrosion Test Spec. Actual ASTM Method Simulated Service Test Hot Surface Corrosion 3 3 6 6 mg/cm /wk 6 3 5 D384 D57 Specimen weight loss.. D434 Electrochemical Minimum, mv Ford Pitting Test >4.7 FLTM BL5 DEXCOOL is a trademark of General Motors Corporation. Used under license DC4. The information contained herein is correct to the best of our knowledge. The recommendations or suggestions contained in this bulletin are made without guarantee or representation as to results. We suggest that you evaluate these recommendations and suggestions in your own laboratory prior to use. Our responsibility for claims arising from breach of warranty, negligence or otherwise is limited to the purchase price of the material. Freedom to use any patent owned by Ashland or others is not to be inferred from any statement contained herein.
This information only applies to products manufactured in the following location(s): USA Material/Product: Part # Product Unit UPC Carton UPC ZXEL ZEREX DEXCOOL AFC 6/ GAL 8885 6 8886 3 ZXEL ZEREX DEXCOOL AFC 55 GAL Drum ZXEL ZEREX DEXCOOL Bulk ZXELRU ZEREX DEXCOOL ReadyToUse AFC 6/ GAL 888547 7 888647 4 ZXELRU ZEREX DEXCOOL ReadyToUse 55 GAL Drum Effective Date: Expiration Date: Replaces: Author's Initials: Pages: Code: 6//4 6//9 /7/ DET 3 The information contained herein is correct to the best of our knowledge. The recommendations or suggestions contained in this bulletin are made without guarantee or representation as to results. We suggest that you evaluate these recommendations and suggestions in your own laboratory prior to use. Our responsibility for claims arising from breach of warranty, negligence or otherwise is limited to the purchase price of the material. Freedom to use any patent owned by Ashland or others is not to be inferred from any statement contained herein.