This parts list contains the part numbers and descriptions of the service parts for the NME1 and FME10 air and water cooled. The water cooled condenser changed between the A and B series. Be sure to check the complete model number before selecting the condenser part number. Table of Contents PANELS...................................... AIR COOLED REFRIGERATION......................... WATER COOLED REFRIGERATION....................... NME EVAPORATOR............................... FME EVAPORATOR............................... CONTROL BOX.................................. GEARMOTOR.................................. RESERVOIR, DRAINS, ICE CHUTE, ICE LEVEL SENSORS.......... WIRING DIAGRAMS............................... June 00 Page 1
PANELS 1 1 1 1 1. A1-00 Top Panel Stainless. A-00 Service Panel for S.S.. A-001 Filter (air cooled only). A1-00 Right End Panel S.S.. A10-00 Front Panel S.S.. 1-00-01 Emblem. 0-01-00 Clip For Emblem (). A-001 Base Assembly. 0--01 Screw. 0-- Washer. A1-00 Left End Panel S.S. 1. A0-00 Back panel 1. 0-10-1 Screw 1. A-01 Retainer July 01 Page
AIR COOLED REFRIGERATION 1,1 1 1 1 0 1 1 1 1 1 a b Alt. Access Valve 1. 1--01 Air Cooled Conden.. A1-001 Shroud. 0-1-01 Bolt. 0--0 Washer. -0-1 Expansion Valve. 1-0-0 Access valve a. 1-0-0 Stem cap b 1-0-0 Core cap. -001- Hi Pressure Control. 1-- 0-0/0/1 Comp. w/drier This compressor has an internal overload. 1-00- Grommet. 1-00- Sleeve 1. 0-10-0 Washer 1. 0-10-0 Bolt 1. 0-1-0 Drier 1. -00-1 L. P. Control 1. 1--0 Fan Motor 0--0 Screws, motor to bracket 1. 0-10-0 Screw 1. 0-- Washer 1. 0--01 Fan Motor Bracket 0. 1--01 Fan Blade 1. A1-00 Insulation for TXV 1--01 Access valve body 1--01 Core 1-0-01 Cap April 00 Page
WATER COOLED REFRIGERATION 1 1 1 1 1 1 1 0 1 1 Alt. Access Valve 1 b a 1. -0-1 Expansion Valve. 1-0-0 Access valve a. 1-0-0 Core cap b. 1-0-0 Stem cap. 1-- Compressor 0-0/0/1 Includes drier, Overload is internal. 1-00- Grommet. 1-00- Sleeve. 0-10-0 Washer. 0-10-0 Bolt. A1-00 Drain. 0-1-0 Drier. -00-1 Lo Press. Control 1. -00-1 Water Reg. Valve 1. 1-001-0 Elbow 1. -001- Hi Pressure Control 1. 1-00- A series WC Condenser 1--1 B series WC condenser 1. 0-1-01 Screw 1. 0--0 Washer 1 1-0-0 Insulation for TXV 1 1--01 Access valve body 0 1--01 Core 1 1-0-01 Cap February 01 Page
NME EVAPORATOR 1 1 1 1 1 1 1 1 1 1 0 1. A00-00 Breaker Includes Items 1 & 0. 0-1-0 Soc. head Screw. 1-01- O-ring. A01-0 Auger. 0-0- Water Seal. A-001 Ring, Water Seal. A0-00 Evaporator. 0-10- Hex Cap Screw. A-001 Bail clamp Note: Evaporator is not available assembled with internal parts.. 0-0-0 Ice Chute Cover. 0-1-01 Ice Chute Body w/ins. 1. 0--01 Drain hose clip 1. 1-01- O-ring 1. 0-001-01 Ice Sweep 1. 0-1-0 Breaker Cover 1. 0-00-01 Auger Stud 1. 0--01 Lip Seal 1. 0-10-1 Cap screw 1. A-00 Bearing 0. 0--01 Lip Seal 1. 1-01- O-Ring. 1-01-01 Water Shed 1-0-0 Insulation donut March 00 Page
FME EVAPORATOR 1 1 1 1 1 1 1 1 1 1 1. A0-00 Breaker Includes Items 1 & 0. 0-1-0 Soc. head Screw. 1-01- O-ring. A01-0 Auger. 0-0- Water Seal. A-001 Ring, Water Seal. A0-00 Evaporator. 0-10- Hex Cap Screw. A-001 Bail clamp. 0-0-0 Ice Chute Cover. 0-1-01 Ice Chute Body w/ins. Note: Evaporator is not available assembled with internal parts. 0 1. 0--01 Drain hose clip 1. 1-01- O-ring 1. 0-001-01 Ice Sweep 1. 0-1-0 Breaker Cover 1. 0-00-01 Auger Stud 1. 0--01 Lip Seal 1. 0-10-1 Cap screw 1. A-00 Bearing 0. 0--01 Lip Seal 1. 1-01- O-Ring. 1-01-01 Water Shed 0-1-01 Slotted collar 1-01- O-ring. 1-0-01 Insulation donut March 00 Page
CONTROL BOX 1, 1. 1-101-1 Start Capacitor. 1-10- Run Capacitor. A1-00 Start Cap. Bracket 1-10- Relay. 0-1-0 Screw. A-001 Run Cap. Bracket. 1--0 1 Phase Contactor. 1-0-01 Mode Switch. 1-- Circuit Board. 1-0-01 Stand off. No Number Control Box 1. A-001 Cont. Box Cover Not shown: 1 1--01 Low voltage harness, pin 1 1--01 High voltage harness, pin February 00 Page
GEARMOTOR 1 *NOTE: GEARCASE COVER INCLUDES COVER, OUTPUT SHAFT, KEY, OUTPUT GEAR, BEARINGS, AND SEAL. 1. 1-0- Start Switch, Emerson 1-0- Start switch, GE split phase*. 1-0- Drive Motor 0-0 v. 0--01 Water Shed.. 1-0- Bearing, Emerson 1-0- Bearing, GE split phase. A-0 Bolt. A-0 First Gear & Bearing. A-0 nd Gear & Bearing. A-01 Gasket. A-00 Gear Case A-0 Oil, 1 Container. A-0 Gearcase Cover* 1. A0-0 Complete Gearmotor Assembly. 0-0 v. A0-00 Gearcase kit. No motor. OIL GE same as Marathon* October 0 Page Note: An output shaft seal is available, the part number is A-0. However, if water has entered the gearbox thru the seal, replace the gearcase cover, not just the seal.
RESERVOIR, DRAINS, ICE CHUTE, ICE LEVEL SENSORS b a 1 1 0 1 1, 1 1 1 1 1 1 1. 0--0 Ice Chute Lower. A-00 Insulation collar top* a A-001 Insulation collar, top*. A-001 Insulation Collar Inside*. A0-01 Ice level sensor set. A0-001 Chute Gasket. 0--01 Drip Pan. 0--01 Insulation Collar. same as item, use one per unit. A1-00 Strap kit. 0--01 Drain hose. 1-0-01 Inlet tube, ft req. 1. A1-00 Preformed Hose 1. 1-00-01 Plug 1. 1-0-01 Water inlet fitting 1. 1--01 Male connector August 0 Page 1. 0-- Drain fitting 1. A-01 Reservoir bracket 1. 1-00-00 Drip pan gasket 1. 0-1-00 Hose clamp 0. 0-1-01 Pal Nut 1. A1-00 Drain - Water Cooled. 1-0-1 Water level sensor. 0--01 Float & Reservoir complete a 0--0 Float valve b 0--0 Plunger * items, a and no longer used after Oct. 000. Insulation part of ice chute body & donut. See pages and.
AIR AND WATER COOLED, 0-0/0/1 January 000 Page
AIR AND WATER COOLED, 0-0/0/1 January 000 Page
Bulletin Number: PS-1- Bulletin Date: September 1 SERVICE BULLETIN Subject: NME, FME, NSE, NDE and TDE0/0 Top Bearing Lubrication Two parts have been made available as helpful aids to use when lubricating the top bearing. 1. 0--01 is a needle that snaps onto a standard grease gun fitting. Use it to insert and deeply pack the proper lubricant into the top bearing.. A0-001 is a tube of the proper lubricant, also designed to fit a standard grease gun. Both numbers are in the parts price list. Needle, shown inserted into bearing