MINI-SOLENOID VALVES direct operated subbase mounted, CNOMO ( mm width) connector size / Series 0 FEATURES Low consumption (0,W) Compact, monobloc solenoid pilot valve with spade-plug connector type AMP,8x0, with 9, mm spacing, or to ISO 7/DIN DIN 60C with 8 mm spacing. Version with or without integral LED and electrical protection. LED indicator visible from sides Solenoid valves satisfy all relevant EC directives GENERAL Pressure Differential pressure Pneumatic base Connection Response time 0 to 0 bar [ bar = 00 kpa] See "SPECIFICATIONS" CNOMO size (E06.6.0N) subbase 8 - ms (on air P = 6 bar) fluids ( ) temperature range (TS) sealings ( ) air or inert gas - 0 C to + 0 C (LP ; LP) () NBR (nitrile) filtered at 0µm, lubricated or not - C to + 0 C (LP) () () LP, LP, LP : see "electrical characteristics" table MATERIALS IN CONTACT WITH FLUID ( ) Ensure that the compatibility of the fluids in contact with the materials is verified. Body IXEF (polyarylamide) Internal parts POM, PET, stainless steel and brass Sealing NBR, FPM Pneumatic interface seal Hytrel OTHER MATERIALS Coil Thermoplastic PET PNEUMATIC to CNOMO (standard) ELECTRICAL CHARACTERISTICS Coil insulation class F Connector Spade plug, to 6 mm diameter cable Electrical safety EN 6070 Standard voltages (-% / +0%) DC (=) : V - V - V - 8V (60 Hz on request) AC (~) : V - 8V - V - 0V / 0 Hz coils nominal ratings ( ) ambiant voltages inrush holding hot/cold temperature (V) ~ ~ = (TS) ~ = (VA) (VA) (W) (W) ( C) LP - - - - 0, / 0, LP -8- ---8,,, /, LP 0,9,6, /,7 see table on page V79-6 protection moulded IP6 PNEUMO-ELECTRIC (available on request) ( ) Nominal ratings of versions without LED indicator and electrical protection. For versions with LED indicator and electrical protection, add: 0, W with DC (=) 0, W / VA with AC (~) SPECIFICATIONS orifice size at 6 bar l/min (ANR) flow (mm) min. max. (PS) ~ = ~ = - normally closed 0,6 0 0, 0, 0 8 LP - 0X06-0X07 0,6 0 0, 0, 0 0 LP 0X09 0X09 0X0 0X0 0,8 7 8 0,6 0,8 0 8 LP 0X 0X 0X 0X, 0, 0,90 0 LP 0X8 0X8 0X9 0X9, 0, 0,90 0 0 LP 0X - 0X -, 0, 0,90 0 0 LP 0X 0X 0X 0X, 9 0,7 0,9 0 LP 0X 0X 0X 0X, 9 0,7 0,9 0 6 LP 0X7-0X8 -, 9 0,7 0,9 0 6 LP 0X7 0X7 0X8 0X8 When ordering, please specify in addition to the basic catalogue number: - the type of current: voltage / frequency - the version: with or without connector ~ = with connector --A --D without connector --L --P Examples : with connector coefficient Kv operating differential pressure (bar) to be inserted after the basic catalogue number V DC : 009--D V DC without connector V DC : 0009--P V DC basic catalogue number manual operator impulse-type screw -type X 0 connection ISO 7, 8 mm spacing connection AMP,8x0,, 9, mm spacing connection ISO 7-8 mm + LED and protection connection AMP,8x0, - 9, mm + LED and protection V79-GB-R V79-
MINI-SOLENOID VALVES SERIES 0 OPTIONS AND ACCESSORIES Version without manual operator Version with pneumo-electric Connector ISO 7 / DIN 60C, 8 mm spacing: - standard: catalogue number 88 0 - with cable m length: catalogue number 88 0 Connector AMP,8 x 0,, 9, mm spacing: - standard: catalogue number 88 8 - with cable, length m: catalogue number 88 67 INSTALLATION The mini-solenoid valves can be mounted in any position Mini solenoid valve supplied with mounting screws and seal(s) Installation/maintenance instructions are included with each mini-solenoid valves DIMENSIONS (mm), WEIGHTS (kg) 6 90 mounting surface holes Ø holes Ø, 7, 0 0 * 8, Exhaust () Outlet () Pressure (),8,8 8, Standard connector, CM6 (Pg 7P) Manual operator mounting screw M x 0, with 6 lobe recess, type Torx n 0 (supplied) Seal (supplied) Version with LED and electrical protection + 0 mm for connector clearance function weight () 0,07 () with standard connector V79-
MINI-SOLENOID VALVES direct operated subbase mounted, CNOMO ( mm width) connection M or with cable ends / Series 0 FEATURES Low consumption (0,6W) Compact, monobloc solenoid pilot valve with M connector (not supplied) or cable ends Version with integral LED indicator and electrical protection. LED indicator visible from sides Solenoid valves satisfy all relevant EC directives GENERAL Pressure 0 to 0 bar [ bar = 00 kpa] Differential pressure See "SPECIFICATIONS" Pneumatic base CNOMO size (E06.6.0N) Connection subbase Response time 8 - ms (on air P = 6 bar) fluids ( ) temperature range (TS) sealings ( ) air or inert gas - 0 C to + 0 C (LP) () filtered at 0µm, lubricated or not - C to + 0 C (LP) () NBR (nitrile) () LP, LP: see "electrical characteristics" table MATERIALS IN CONTACT WITH FLUID ( ) Ensure that the compatibility of the fluids in contact with the materials is verified. Body IXEF (polyarylamide) Internal parts POM, PET, stainless steel and brass Sealing NBR, FPM Pneumatic interface seal Hytrel OTHER MATERIALS Coil Thermoplastic PET ELECTRICAL CHARACTERISTICS Coil insulation class F Connection connector M (not supplied), or cable ends Electrical safety connector M CNOMO E0.6.0.N cable ends EN 6070 Standard voltages (-% / +0%) DC (=) : V coils nominal ratings ( ) ambiant voltages inrush holding hot/cold temperature (V) ~ ~ = (TS) protection ~ = (VA) (VA) (W) (W) ( C) LP - - - - 0,6 / 0,70 LP - - - -, /,0 see table on page V79-6 moulded IP67 PNEUMO- ELECTRIC (available on request) PNEUMATIC to CNOMO (standard) ( ) Nominal ratings of standard versions (with LED indicator and electrical protection) SPECIFICATIONS flow orifice operating differential catalogue number size at 6 bar coefficient pressure (bar) l/min (ANR) Kv manual operator (mm) min. max. (PS) impulse-type screw-type - normally closed 0,6 0 0, 0, 0 8 LP 0X06 0X07 0,6 0 0, 0, 0 0 LP 0X09 0X0 0,8 7 8 0,6 0,8 0 8 LP 0X 0X, 0, 0,90 0 LP 0X8 0X9, 9 0,7 0,9 0 LP 0X 0X X connection M (connector not supplied) + LED and protection cable ends + LED and protection V79-
MINI-SOLENOID VALVES SERIES 0 OPTIONS AND ACCESSORIES Version without manual operator Version with pneumo-electric Straight M connector, cable entry Ø to 6mm: catalogue number 88 00 0 INSTALLATION The mini-solenoid valves can be mouted in any position Mini solenoid valve supplied with mounting screws and seal Installation/maintenance instructions are included with each mini-solenoid valves DIMENSIONS (mm), WEIGHTS (kg) a b 7 Exhaust () 7 Exhaust (), 0 6 * 8, Outlet () Pressure (), 0, 8, Outlet () Pressure () a b M connection (connector not supplied) electrical supply wires, length: 0,m Manual operator mounting screw M x 0, with 6 lobe recess, type Torx n 0 (supplied) Seal (supplied) + connector M function weight (M) () weight (cable) 0,07 0,00 () Without connector,8,8 mounting surface 8, holes Ø holes Ø, V79-
MINI-SOLENOID VALVES SERIES 0 - SUBBASES DIMENSIONS (mm), WEIGHTS (kg) MINI - SOLENOID VALVE ON SINGLE SUBBASE 60 6 90 orifices Ø M (,, ) Mounting: holes M, depth, + 0 mm for connector clearance 0 0 9 6*,, Outlet () can be connected on the left or on the right of the subbase. subbase alone code weight material 88 6 00 0,0 aluminium MINI - SOLENOID VALVE ON ADAPTER CNOMO SIZE 0 6 8 6, 0 60 * 90 6 7, 9 6, 6 Mounting: screw M x 0 (supplied) Exhaust () (not-collectable) Outlet () Pressure () + 0 mm for connector clearance adapter alone code weight material 88 6 00 0,08 aluminium MINI - SOLENOID VALVE ON JOINABLE SUBBASES, 8, 8,, 9, 8 6 6 6 8 8 6 8 6 (x) L (x) 0 0* Ports (pressure) and (exhaust): G/8 Port (outlet): coupling for mm OD tube Fixing hole Ø, ( for x ; for x) Fixing hole M, depth 8 ( for x ; for x) Mating surface blanking plates (option) TS DIN rail (not supplied) Clip for DIN rail mounting (option) subbases alone (aluminium) code x subbases L weight 00 6 x - 0,07 00 6 x - 0,9 00 66 6 x + x 0 0, 00 67 8 x + x 0,9 00 68 0 x + x + x 7 0,6 00 69 x + x + x 06 0,7 x = place for mini-solenoid valves. plugs G/8 supplied. V79-
MINI-SOLENOID VALVES SERIES 0 - SUBBASES OPTIONS AND ACCESSORIES Additional subbase with places (with seals): catalogue number 00 70 tie-rods + nuts for a subbase with: places : catalogue number 88 00 7 6 places : catalogue number 88 00 7 8 places : catalogue number 88 00 7 0 places: catalogue number 88 00 7 places: catalogue number 88 00 76 Mounting kit for DIN rail ( clips + screws + washers) : catalogue number 88 00 77 Mating surface blanking plate: catalogue number 88 0 0 AMBIANT TEMPERATURE RANGES current type range coil version DC (=) AC (~) LP LP LP LP LP 0, W standard 0,6 W LED + protection -0 C ; +0 C -0 C ; +0 W standard - C ; +60 C, W LED + protection - C ; +60 C - C ; +0 C W standard -0 C ; +0 C -0 C ; +0 C, W LED + protection -0 C ; +0 C -, VA standard,7 VA LED + protection - C ; +60 C - C ; +0 C,9 VA standard - C ; +60 C - C ; +0 C, VA LED + protection - C ; +0 C - V79-6 ASCO/JOUCOMATIC reserves the right to alter the availability, design and specifications without notice.