INSTLLTION INSTRUTIONS FOR PRT 99-7869 99-7869 KIT FETURES IN Radio Provision with Pocket ISO Mount Radio Provision with Pocket ouble IN Radio provision Stacked ISO Mount Units Provision KIT OMPONENTS PPLITIONS Honda Odyssey 005-00 ) Radio Housing ) ISO rackets ) Trim Plate ) ouble IN Trim Plate E) ouble IN rackets F) Pocket G) Panel lips - () Panel lips supplied - user asembly onto rear of Radio Housing required G WIRING N NTENN ONNETIONS (Sold Separately) Harness: 70-7 - Honda/cura harness 998-up 70-7 - Honda harness 006-up E F TOOLS REQUIRE: 0-H0 - Honda antenna adapter 005-up Phillips Screwdriver Small Flat lade Screwdriver Socket Wrench
99-7869 SH ISSSEMLY HON OYSSEY 005-00 isconnect the negative battery terminal to prevent an accidental short circuit. Unclip and remove climate control panel below radio. (Figure ) Remove () Phillips-7 MM screws securing the radio to remove. (Figure )
99-7869 KIT SSEMLY IN RIO PROVISION WITH POKET ttach () Panel lips to Radio Housing rear connectors. (Figure ) Slide the IN cage into the Radio Housing and secure by bending the metal locking tabs down. (Figure ) RER VIEW - RIO HOUSING INSTLL () LIPS Slide the aftermarket radio into the cage and secure. (Figure ) Snap the pocket into the housing. (Figure )
99-7869 KIT SSEMLY ISO MOUNT RIO PROVISION WITH POKET ttach () Panel lips to Radio Housing rear connectors. (Figure ) Mount the ISO rackets to the head unit with the screws supplied with the unit. (Figure ) RER VIEW - RIO HOUSING INSTLL () LIPS Slide the head unit into the radio opening until the side clips engage. (Figure ) Snap the Trim plate into the Radio Housing. (Figure ) 5 Snap the Pocket into the Housing. (Figure )
99-7869 KIT SSEMLY OULE IN RIO PROVISION ttach () Panel lips to Radio Housing rear connectors. (Figure ) ut and remove the center bar from the 99-7869 radio housing. (Figure ) INSTLL () LIPS Snap the ouble IN brackets to the inside edge of the 99-7869 radio housing. (Figure ) RER VIEW - RIO HOUSING 5 Slide the ouble IN radio into thebracket/trim plate assembly and secure the radio to the assembly using the screws supplied with the radio. (Figure ) Snap the ouble IN trim plate into the radio housing. (Figure )
99-7869 KIT SSEMLY STKE ISO MOUNT UNITS PROVISION 5 ttach () Panel lips to Radio Housing rear connectors. (Figure ) ut and remove the center bar from the 99-7869 radio housing. (Figure ) Snap the ouble IN brackets to the inside edge of the 99-7869 radio housing. (Figure ) Slide the Stacked ISO units into the bracket/trim plate assembly and secure the units to the assembly using the screws supplied with the radio. (Figure ) Snap the ouble IN trim plate into the radio housing. (Figure ) RER VIEW - RIO HOUSING INSTLL () LIPS
FINL SSEMLY Locate the factory wiring harness in the dash and make the connection as shown. Metra recomends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) Re-connect the negative battery terminal and test the unit for proper operation. Reassemble radio and dash assemblies in reverse order of disassembly. FINL WIRING ONNETIONS Make wiring connections using the EI color code chart shown below and the instructions included with the head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electrical short circuit. 99-7869 KIT SSEMLY ) Strip wire ends back /" ) Twist ends together ) Solder ) Tape METR / EI WIRING OE V Ignition / cc... Red V att / Memory.. Yellow Ground........... lack* Power ntenna..... lue mp Turn-On...... lue / White mp Ground....... lack / White Illumination........ Orange immer.......... Orange / White Right Front (+)..... Gray Right Front (-)...... Gray / lack Left Front (+)...... White Left Front (-)....... White / lack Right Rear (+)...... Violet Right Rear (-)...... Violet / lack Left Rear (+)....... Green Left Rear (-)....... Green / lack *NOTE: When lack a wire is not present, ground radio to vehicle chassis. ll colors may not be present on all leads due to manufacturer s specifications. METR ESSORIES STEREO SH KITS