MULTI-CHARGER FOR 12 TO 18V NI-CD OR LI-ION BATTERIES 054-3169-4 Owner s Manual Input: Output: Optimum charging temperature: Battery types: Charging times: Weight: PRODUCT SPECIFICATIONS 120 V, 60 Hz 18V DC, 2A for Ni-Cd batteries 20V DC, 2A for Li-ion batteries 0 to 45 C (32 to 113 F) Mastercraft 12V Ni-Cd (054-3166-0) Mastercraft 18V Ni-Cd (054-3168-6) 1-hour 1 lb 1 oz (0.48 kg) Need Assistance? Call us on our toll free customer support line: 1-800-689-9928 Technical questions Replacement parts Parts missing from package Imported by Mastercraft Canada Toronto, Canada M4S 2B8
BATTERY & CHARGER SAFETY! WARNING: Only use the charger supplied to charge the Mastercraft 12V Ni-Cd (054-3166-0) or 18V Ni-Cd (054-3168-6). Charging any other batteries may damage the charger and possibly cause serious injury. Do not store or carry the battery where metal objects could contact the exposed metal end of the battery. Do not place the battery in aprons, pockets, drawers, etc. with loose nails, screws, keys etc. The battery could short circuit causing a fire, personal injury or damage to the battery. Do not attempt to open the battery for any reason. If the housing of the battery breaks or cracks, immediately discontinue use and do not recharge. Do not charge the battery if it is wet or shows any evidence of corrosion. A small leakage from the battery may occur under extreme usage, charging or temperature conditions. This does not indicate a failure. However, if the outer seal is broken and this leakage gets on your skin, follow these steps: 1. Wash immediately with soap and water. 2. Neutralize with a mild acid such as lemon juice or vinegar. 3. If liquid gets into your eyes, flush immediately with clean water for a minimum of 10 minutes and seek medical attention. NOTE: The battery liquid is slightly acidic. Do not incinerate the battery; it can explode in a fire. Do not use an extension cord; plug the charger cord directly into an electrical outlet. Do not allow the cord to hang over the edge of a table or counter or touch hot surfaces. The charger should be placed away from sinks and hot surfaces. Do not use the charger to charge any batteries other than the cordless drill batteries. Other batteries may explode. Do not operate charger if the cord or plug is damaged. Replace the damaged cord and plug immediately. Do not operate the charger if it has received a sharp blow, been dropped or otherwise damaged in any way. Have a qualified technician examine the charger and repair it if necessary. Do not disassemble the charger. Do NOT charge the batteries when the work area or the battery temperature is at or below 0 C (32 F) or above 45 C (113 F). Unplug the charger when not in use and before cleaning or maintenance. BATTERY PACK RECYCLING To preserve our natural resources, please recycle or dispose of batteries properly. The batteries charged by this charger may contain chemicals and metals that are harmful to the environment. Never dispose of rechargeable batteries in your normal household garbage or in landfill sites as they will add to the pollution of the environment. Please call 1-800-822-8837 for the location of your nearest RBRC battery recycling location. Use the charger only in a standard 120V, 60Hz electrical outlet. NOTE: Square wave output inverters may damage this charger and the battery. Do not use the charger in wet or damp conditions. It is intended for indoor use only. Do not use the charger near sinks or tubs. Do not immerse the charger in water. 2
SYMBOLS! WARNING: Some of the following symbols may appear on the charger. Study these symbols and learn their meaning. Proper interpretation of these symbols will allow for more efficient and safer operation of this tool. V A Hz W kw L kg H N/cm 2 Pa OPM Min S or a.c. Volts Amperes Hertz Watts Kilowatts Microfarads Litres Kilograms Hours Newtons per square centimeter Pascals Oscillations per minute Minutes Seconds Alternating current Three-phase alternating current Three-phase alternating current with neutral Direct current No load speed Alternating or direct current Class II construction Splash-proof construction Watertight construction Protective grounding at grounding terminal, Class I tools Revolutions or reciprocations per minute Diameter Off position Arrow Warning symbol Wear your safety glasses 3042597 DG0724 This symbol designates that this tool is listed with Canadian requirements by ETL Testing Laboratories, Inc. Conforms to UL STD. 1310. Certified to CAN/CSA C22.2 No. 223-M91. 3
CHARGING THE BATTERY PACK ASSEMBLY AND OPERATING 1. Place the battery charger (1) in a dry location near a 110 120V 60Hz electrical outlet (Fig. 1). NOTE: Square wave output inverters may damage this charger and the battery. 2. Turn the battery (2) upside down and slide it onto the charger. NOTE: Make sure the grooves (3) in the sides of the battery slide over the matching tabs on the charger (4) until the battery latch "clicks" into place. 3. Plug the battery charger into the 110 120V 60Hz wall receptacle. NOTES: a) When the charger is plugged into the wall receptacle and NO battery is on the charger, the green indicator light (5) will turn ON indicating the charger is live. b) When a discharged battery is installed on the charger, the green indicator light will turn OFF and the red indicator light (6) will FLASH. The flashing red indicator light indicates the battery is being charged. c) If the red indicator light does not come ON, check to make sure that the battery pack is slid fully onto the charger and the electrical outlet is working properly. d) See Fig. 2 at right for other indicator light functions. e) A new battery pack or one that is completely run down should be charged for 2 hours before use. After normal use, a battery pack should be fully charged in about one hour. f) It is normal for the battery charger to hum and be warm to the touch during operation. g) If the battery pack does not charge properly, check to make sure the electrical outlet is live. h) Do NOT charge batteries when the work area or the battery temperature is at or below 0 C (32 F) or above 45 C (113 F). Green Light Red Light Fig. 1 Battery Inserted Into Charger ON OFF NO OFF Flashing YES ON OFF YES OFF ON YES ON ON YES Fig. 2 Charging Status Charger connected to power supply Battery being charged Battery fully charged Battery defective or bad contact Battery too hot or too cold to be charged 4
2-Year Limited Warranty This Mastercraft product is guaranteed for a period of 2 years from the date of original retail purchase against defects in workmanship and materials. Subject to the conditions and limitations described below, this product, if returned to us with proof of purchase within the stated warranty period and if covered under this warranty, will be repaired or replaced (with the same model, or one of equal value or specification), at our option. We will bear the cost of any repair or replacement and any costs of labour relating thereto. These warranties are subject to the following conditions and limitations: a) a bill of sale verifying the purchase and purchase date must be provided; b) this warranty will not apply to any product or part thereof which is worn or broken or which has become inoperative due to abuse, misuse, accidental damage, neglect or lack of proper installation, operation or maintenance (as outlined in the applicable owner s manual or operating instructions) or which is being used for industrial, professional, commercial or rental purposes; c) this warranty will not apply to normal wear and tear or to expendable parts or accessories that may be supplied with the product that are expected to become inoperative or unusable after a seasonable period of use; d) this warranty will not apply where damage is caused by repairs made or attempted by others (i.e. persons not authorized by the manufacturer); e) this warranty will not apply to any product that was sold to the original purchaser as a reconditioned or refurbished product (unless otherwise specified in writing); f) this warranty will not apply to any product or part thereof if any part from another manufacturer is installed therein or any repairs or alterations have been made or attempted by unauthorized persons; g) this warranty will not apply to normal deterioration of the exterior finish, such as, but not limited to, scratches, dents, paint chips, or to any corrosion or discolouring by heat, abrasive and chemical cleaners; and h) this warranty will not apply to component parts sold by and identified as the product of another company, which shall be covered under the product manufacturer s warranty, if any. Page 1 of 2 5
! 2-Year Limited Warranty cont d Additional Limitations This warranty applies only to the original purchaser and may not be transferred. Neither the retailer nor the manufacturer shall be liable for any other expense, loss or damage, including, without limitation, any indirect, incidental, consequential or exemplary damages arising in connection with the sale, use or inability to use this product. Notice to Consumer This warranty gives you specific legal rights, and you may have other rights, which may vary from province to province. The provisions contained in this warranty are not intended to limit, modify, take away from, disclaim or exclude any statutory warranties set forth in any applicable provincial or federal legislation. Mastercraft is a superior line of products selected for their workmanship and materials. These products are designed to meet rigorous quality and performance standards and are approved by our Quality Assurance laboratory. TOLL-FREE HELPLINE: 1-800-689-9928 Page 2 of 2 Rev 1.6 03/08/2012 6