Lighting Technology Light Fittings for Fluorescent Lamp BAY1-Q Series Explosion-proof Light Fittings for Fluorescent Lamp Explosion protection to -CENELEC -IEC -NEC Can be used in Zone 1 and Zone Zone 1 and Zone Class I, Zone 1 and Zone Class I, Division, Groups A, B, C, D Two enclosure types: 18W, 36W. Enclosure in glass fibre reinforced polyester, diffuser in polycarbonate, corrosion-proof. Ex e enclosure with explosion-proof components inside. Safety interlock between enclosure and diffuser switches off on opening. Electronic ballast, power factor.9. Emergency unit with protections against over charge and over discharge. End of lamp life (EOL) rectification effect protection. Catalogue number logic BAY1-Q x J: Emergency lighting (optional) L: pole type X: ceiling type Mounting B: wall type D: pendant chain type G: pendant pole type Lamp number Lamp power (W) Explosion-proof light fittings for fluorescent lamp Zones 1&; 1& / General Catalogue 1.1.13
Light Fittings for Fluorescent Lamp BAY1-Q Series Explosion-proof Light Fittings for Fluorescent Lamp Technical data Explosion-proof light fittings for fluorescent lamp BAY1-Q x Explosion protection Gas explosion protection Dust explosion protection Certificates Conformity to standards Material Enclosure Diffuser Ballast Exposed fastener Interlock Lamp Lamp brand Lamp power (W) II G Ex deq IIC T4 Gb II D Ex t IIIC T8 Db IP66 LCIE 1 ATEX 34X; IECEx CQM 7.7 BR977 (Brazil); S-XPL/447 (South Africa); FM (USA); GOST.R (Russia) EN 679-:9, EN 679-1:7, EN 679-:7, EN 679-7:7 EN 679-31:9 IEC 679-:7, IEC 679-1:7, IEC 679-:7, IEC 679-7:6 IEC 679-31:8 GRP, stands 7J impact, corrosion-proof Polycarbonate, 9% light transmission, stands 7J impact Explosion-proof electronic ballast, power factor.9, with protection against short circuit, overload, lamp aging, lamp damage and dissymmetry power of lamp tube. Certificate No.: LCIE 6 ATEX 3U; IECEx CQM 7.U; BR976-U (Brazil). Stainless steel BZX-6 explosion-proof distance switch, switching off on opening. Certificate No.: LCIE 6 ATEX U, IECEx CQM 7.6U PHILIPS T8 (supplied with the light fittings) 36W x 18W x 36W x 1 18W x 1 Rated voltage Protection class Degree of protection Ambient temperature Terminal Cable entries Available cable outer diameter 96~4V AC /6Hz II (Protection against electric shock) IP66 - ~+ 3 x 1.~4mm (L+N+PE) 4 x Φ6: x M x 1. cable gland (DQM-I Ex e, plastic), x M x 1. plug. Φ9~Φ16 (mm) Selection table Type/Ordering code Lamp power(w) Weight(kg) Type/Ordering code Lamp power(w) Weight(kg) BAY1-QL 11.4 BAY1-Q36 x L 36 x 11.6 BAY1-QX 11.3 BAY1-Q36 x X 36 x 11.4 BAY1-QB 1.3 BAY1-Q36 x B 36 x 1. BAY1-QD 1.6 BAY1-Q36 x D 36 x 1.7 BAY1-QG 1. BAY1-Q36 x G 36 x 1.4 BAY1-QL 6.8 BAY1-Q18 x L 18 x 7. BAY1-QX 6.7 BAY1-Q18 x X 18 x 6.9 BAY1-QB 7.8 BAY1-Q18 x B 18 x 7.9 BAY1-QD 8.1 BAY1-Q18 x D 18 x 8. BAY1-QG 7.7 BAY1-Q18 x G 18 x 7.8 Note: Products above include all the mounting accessories listed in Mounting Accessories & Spare Parts Table (see P/6~7). General Catalogue 1.1.13 /3
Light Fittings for Fluorescent Lamp BAY1-Q Series Explosion-proof Light Fittings for Fluorescent Lamp Technical data Explosion-proof emergency light fittings for fluorescent lamp BAY1-Q x J Explosion protection Gas explosion protection Dust explosion protection Certificates Conformity to standards Material Enclosure Diffuser Emergency unit Emergency controller Exposed fastener Lamp Lamp brand Lamp power(w) Emergency power(w) Emergency start time Charge time Emergency lighting time Rated voltage Protection class Degree of protection Ambient temperature Terminal Cable entries Available cable outer diameter II G Ex deq IIC T4 Gb II D Ex tb IIIC T8 Db IP66 LCIE 1 ATEX 39; IECEx CQM 1.X; BVC 1.3 (Brazil); FM (USA) GOST.R (Russia) EN 679-: 9, EN 679-1: 7, EN 679-: 7, EN 679-7: 7 EN 679-31: 9 IEC 679-: 11, IEC 679-1: 7, IEC 679-: 7, IEC 679-7: 6 IEC 679-31: 8 GRP, stands 7J impact, corrosion-proof Polycarbonate, 9% light transmission, stands 7J impact Special emergency controller and NI-MH battery pile, with protection against over charge and over discharge BY- explosion-proof emergency controller. Certificate No.: LCIE 1 ATEX 31U, IECEx CQM 11.41U Stainless steel PHILIPS T8 (supplied with the light fittings) 36W x 36W x 1 36W x 1, 18W x 1.3s 4h 1min (18min is optional) 96~4V AC /6Hz II (Protection against electric shock) IP66 - ~+ 3 x 1.~4mm (L+N+PE) 4 x Φ6: x M x 1. cable gland (DQM-I Ex e, plastic), x M x 1. plug. Φ9~Φ16 (mm) 18W x 18W x 1 Selection table Type/Ordering code Lamp power(w) Weight(kg) Type/Ordering code Lamp power(w) Weight(kg) BAY1-QLJ 13. BAY1-Q36 x LJ 36 x 13. BAY1-QXJ 1.9 BAY1-Q36 x XJ 36 x 13.1 BAY1-QBJ 14. BAY1-Q36 x BJ 36 x 14.1 BAY1-QDJ 14.3 BAY1-Q36 x DJ 36 x 14.4 BAY1-QGJ 13.9 BAY1-Q36 x GJ 36 x 14. BAY1-QLJ 8.6 BAY1-Q18 x LJ 18 x 8.8 BAY1-QXJ 8. BAY1-Q18 x XJ 18 x 8.7 BAY1-QBJ 9.6 BAY1-Q18 x BJ 18 x 9.7 BAY1-QDJ 9.9 BAY1-Q18 x DJ 18 x 1. BAY1-QGJ 9. BAY1-Q18 x GJ 18 x 9.6 Note: Products above include all the mounting accessories listed in Mounting Accessories & Spare Parts Table (see P/6~7). /4 General Catalogue 1.1.13
Light Fittings for Fluorescent Lamp BAY1-Q Series Explosion-proof Light Fittings for Fluorescent Lamp Photometric data 18W x photometric data Rated luminous flux:1lm; The data from PHILIPS lamp; Luminous intensity distribution cd/1lm 36W x photometric data Rated luminous flux:lm; The data from PHILIPS lamp; Luminous intensity distribution cd/1lm 4 8 1 16 3 9 6 1 1 3 3 4 4 349 348 34 33 34 39 9 7 48 6 6 7 7 8 8 9 193 16 13 98 66 38 18 4 8 1 16 3 9 6 1 1 3 3 4 4 783 78 779 776 77 77 777 776 77 76 6 6 7 7 8 8 9 78 731 7 66 61 36 18W x 1 fluorescent lamp*. 36W x 1 fluorescent lamp*. We can provide lighting design and data by professional lighting software DIALUX based upon simulated site situation on request. Schematic diagram (BAY1-Q x J) 1 1 Note: Tube for lamp shall be default for single tube fittings. Dimension drawings (all dimensions in mm) - subject to alteration BAY1-Q36 x BAY1-Q18 x General Catalogue 1.1.13 /
Light Fittings for Fluorescent Lamp BAY1-Q Series Explosion-proof Light Fittings for Fluorescent Lamp Mounting type (all dimensions in mm) - subject to alteration Installation reference D: pendant chain type G: pendant pole type 6-Φ1. -Φ84 4-Φ1 1 3 4 L: pole type (the pole is provided by user) Φ4 7 8 Φ4 7 6 Φ4 7 6 Φ48 4-Φ14 Φ48 Φ48 Suitable for ground pole type Suitable for fence pole type Suitable for wall pole type X: ceiling type B: wall type 4-Φ1 9 1 4-Φ11 Mounting accessories and spare parts table Supplied according to the mounting type Mounting Accessories Ordering Weight type Name Qty Illustration code (kg) 3-Φ1. 1.Sucker 13617.1 D: pendant chain type Φ84.Chain Length: 4mm 13616.8.Mounting bracket Same as pendant pole type 1363.7 3.Mounting bracket Φ8. 1S1G1.4 -Φ1 G: pendant pole type 4.M8 Screw Length: 3mm 1S1G.1.Mounting bracket Φ9 1363.7 -Φ1 Note: Accessories not in the table shall be supplied by user. /6 General Catalogue 1.1.13
Light Fittings for Fluorescent Lamp BAY1-Q Series Explosion-proof Light Fittings for Fluorescent Lamp Mounting accessories and spare parts table Supplied according to the mounting type Mounting Accessories type Name Qty Illustration Ordering code Weight (kg) 6.Mounting bracket 1361.4 -Φ7 L: pole type 7.G1 1/4 Pipe clamp 13614.4.Mounting bracket Same as pendant pole type 1363.7 X: ceiling type 9.Mounting bracket 1361. B: wall type 1.Wall bracket Welded sheet steel 136B.6 Note: Accessories not in the table shall be supplied by user. Accessories Picture Name Ordering code Weight (kg) Explosion-proof distance switch 1363.4 Spanner 1364. Lamp holder (with wires) 136. 36W Explosion-proof electronic ballast 13611 1.3 18W Explosion-proof electronic ballast 1184 1.3 36W Explosion-proof emergency controller (with battery) 13619 1.7 18W Explosion-proof emergency controller (with battery) 118 1.7 General Catalogue 1.1.13 /7