You re never left in the dark. Handcrank Power Supply Always prepared for any outage Merrimack, New Hampshire USA 03054 800-846-3000 Brookstone.com
Table of contents Warnings and Cautions.................................................... 2 Location of Parts and Controls............................................. 3 Location of Parts and Controls (Charging Panels)............................ 4 LCD Icons (LCD Display)................................................... 5 Charging the Emergency Power Supply..................................... 6 Setting the Time and Temperature Mode.................................... 7 Using the LED Flashlight.................................................. 7 Using the AC Function..................................................... 8 Using the USB Connection................................................ 8 Using the 12V Power Outlet............................................... 9 Using the Jump Starter.................................................... 9 Care and Maintenance....................................................10 Power Information when Fully Charged..................................... 11 Specifications............................................................12 Warranty.................................................................13 1
Warning! High Voltage! Do not try to remove the internal battery or try to repair this product. This product has an internal inverter and jump-starter technology that raises the voltage and output to a much higher level than the internal battery. Opening the product can cause serious injuries! IMPORTANT This unit contains a lead acid battery that should be delivered to a battery collection point for recycling at the end of its life. Read the instructions carefully before usage, and follow all the instructions. Connect the cables correctly and only use normal sockets and USB connectors. Do not put any other object in the USB or AC output port. High voltage circuitry is used inside the body. Do not open the case at any time. Do not block the vent. Keep the AC socket dry to prevent electric shock. Do not operate in temperatures less than 14 degrees Fahrenheit. The unit should not be placed on sand or dirt as the fan for the heat reduction at the bottom may blow or suck debris into the unit. To prevent the leakage of electrolyte in the lead acid battery, the unit should be set upright on the ground. Always use the crank consistently. Rotating too slowly may reduce the current and prolong charging time required. Rotating too fast will damage the internal gear. Do not place the device in very high temperatures or very humid environments. Use only the charging cables included. Charge the product at least once per month to prolong the life of the internal battery. Do not shine LED lights directly in eyes under any circumstances. When the unit is used for the first time, or not used for over 120 days, the internal battery needs to be powered by DC charging for 14 hours. 2
Location of parts and controls 1. On/Off LED Light Switch 7. Handle 2. LED Light 3. LCD Display 4. Control Panel 5. Charging Panel 1 Door 8. Crank 9. Charging Panel 2 Door 10. AC Adapter (not shown) 11. 12V Car Adapter (not shown) 6. Cable Access Door 1 7 2 3 4 8 5 6 9 3
Location of parts and controls (charging Panels) 1. Charging Panel 1 Cover 2. DC In 3. Solar In 4. 120V AC Power Outlet 5. 5V USB Outlet 6. Charging Panel 2 Cover 7. 30A Fuse 8. 12V DC Power Outlet 1 2 3 6 7 8 5 4 4
LCD Icons (LCD Display) 1. AC/USB/Light Indicators 2. High Temperature Indicator and Fan Icon 3. Inside/Outside Temperature 4. Charging Percentage 5. Set Button 6. USB Button 7. AC Button 8. Time 9. Overload Indicator 10. Voltage 1 2 10 3 5 9 8 4 7 5 Charging Indicator 6 5
Charging the emergency power supply Turn the crank 1. Pull the crank arm out of the holder and put it in its rotating position. 2. Rotate with a steady turning speed of 90-120 rotations per minute. Please note: Turning the crank at a speed above 120 rotations per minute may cause the gear to overheat and severe internal damage may occur. 3. During charging, the power level will blink on the LCD display. 4. Stop charging when the display shows a battery status of 100%. Charging with AC adapter (AC Adapter Included) 1. Connect the AC Adapter to an electrical outlet. 2. Connect the other end of the AC Adapter to DC-in of the unit. 3. During charging, the power level will blink on the LCD display. 4. Stop charging when the display shows a battery status of 100%. Charging with 12V Car Adapter (12V car adapter included) 1. Connect the 12V Car Adapter to the car s cigarette lighter or power outlet. 2. Connect the other end of the 12V Adapter to DC-in of the unit. 3. During charging, the power level will blink on the LCD display. 4. Stop charging when the display shows a battery status of 100%. IMPORTANT: During charging, the internal fan may operate to cool off the inside temperature. This is a normal product function. 6
Charging by solar cell (solar cell not included) 1. To charge by solar cell, only use the solar input on the unit. 2. You may need an adapter tip to change the size of cable tip of a solar cell to fit the unit. Setting the time and temperature mode 1. In Standby mode, press the SET button for 3 seconds. 2. The LCD display will show the time and the hour digit will blink. 3. Press the AC (+) or USB (-) buttons to adjust the hour. 4. Press SET to save the hour chosen. The minute digits will blink. 5. Press the AC (+) or USB (-) buttons to adjust the minute. 6. Press SET to save the minutes chosen. The 12/24 hour setting will blink. 7. Press the AC (+) or USB (-) buttons to choose between the 12 or 24 hour display setting. 8. Press SET to save the 12/24 hour setting chosen. The C/F setting will blink. 9. Press the AC (+) or USB (-) buttons to choose between the C/F display setting. Press SET to save. Using the LED Flashlight 1. Press the Light Switch on top of the unit to activate the LED flashlight. 2. Press again to activate the flashing red emergency light. 3. Press again to turn off. 7
Using the AC Function 1. Press and hold the AC on/off button for three seconds to activate. 2. The AC power function will show on the LCD display. The power bank is now ready to power any 120 Volt appliance with maximum power of 100 Watts. 3. Connect the plug of your 120 Volt device into the AC output. Note: During use of the AC power function the internal inverter will get warm. This is normal. The internal temperature is shown on the display. To cool down the internal temperature, the integrated fan will automatically be activated when required. 4. The wattage that is used by the connected AC device is shown in the display. 5. To deactivate the AC power function, disconnect your 120 Volt device and press the AC on/off button for three seconds. The indication AC OUTPUT will disappear from the display. Using the USB connection 1. Press and hold the USB on/off button for 3 seconds to activate the USB function. 2. The USB power function will be displayed on the LCD display. Connect the USB 2.0 connection of your mobile device to the USB charging port from the unit. 3. The USB port can charge any mobile device with charging voltage of 5V and output current of 1A. 4. To deactivate the USB output function, press and hold the USB button for 3 seconds. The indicator USB OUTPUT will disappear from the display. 8
Using the 12V Power outlet 1. Open the Charging Panel 2 Cover. 2. Plug the 12V Car Adapter into the 12V Power Outlet. 3. Connect to device to be powered (up to 200W). Replacing the Fuse: If the 12V Output isn t operational, check the fuse and, if fuse is blown (burned out), replace it with a 30A Fuse. IMPORTANT: Only a 30A Fuse should be used. Using the jump Starter 1. Open the CABLE DOOR. 2. Take out the RED and BLACK clamps. 3. Unscrew the BLACK nut from the negative terminal. 4. Connect the ring on the BLACK wire to the negative terminal. 5. Screw the BLACK nut back on the negative terminal to secure wire. 6. Unscrew the RED nut from the positive terminal. 7. Connect the ring on the RED wire to the positive terminal. 8. Screw the RED nut back on the positive terminal to secure wire. 9. Clamp the BLACK clamp to the negative pole of the car battery first followed by the RED clamp to the positive pole of the car battery. This unit is able to output a current of 200A. WARNING! Fire or explosion may be caused because of a short circuit or wrong connections of the poles. 9
IMPORTANT!: To prevent a short circuit, metallic parts should be kept away from both the positive and negative clamps. Avoid any contact between the negative and positive clamps. Carefully check if the poles are connected correctly before connecting to any external battery. For Best Performance Charging Car Batteries (for cars under 2.4L): Hand crank the unit until it s charged to 12.0 Volts (readable on LCD display) and use as a 12V output. The unit is suitable to power a 12V device directly by connecting the positive wire of the 12V device to the red (positive) nut and the negative wire to the black (negative) nut. Make sure, before connecting the positive wire, you integrated a suitable fuse in the wire to protect your 12V device from short circuit and overcharge. Care and Maintenance Cleaning Clean the Emergency Power Supply with a soft, dry clean cloth. Do not use any harsh abrasives or chemicals to clean the Emergency Power Supply. Storage The suitable storage temperatures are: -4 degrees Fahrenheit to 140 degrees Fahrenheit. 10
Power information when fully charged Product: run Time (approximate): 2W Night Light................................. 40 Hours 15W CD Player................................. 6 Hours 18W Desk Lamp................................ 5 Hours 40W 14" TV.................................... 4 Hours 55W Fan....................................... 2 Hours 70W Notebook................................. 85 Minutes 100 Watt Lamp................................. 55 Minutes Mobile Phone DC 4.2V 1000mAh................ 20 cycles Digital Camera DC 3.7V 1100mAh............... 20 cycles 11
Specifications AC-Charger:.................................... Input 100-240 Volt Output 17 Volt Amp 1.5 A Output Capacity:................................ AC 120/240 Volt/0.5/0.4 Amp Charging Time Fully Charged by AC:.............. 13 Hours Charging Time Fully Charged by Crank:........... 6 Hours Crank Output:................................... 18 Volt, 40 Watt Fuse........................................... 30A Operating Temperature:.......................... -10 ~ 40 Degrees Celsius Storage Temperature:............................ -20 ~ 60 Degrees Celsius Battery (Lead Acid):............................. 12 Volt, 12 Ah, 7 Kg Jump Starter:................................... Voltage 12 Volt Starting Power:................................. 200 Amp Maximum Power:................................ 140 Watt Standby Time:.................................. 180 Days Overcharge Protection:.......................... Yes Maximum Solar Input:........................... 17 Volts 12
One (1) Year Limited Warranty Brookstone warrants this product against defects in materials and/or workmanship under normal use for a period of ONE (1) YEAR from the date of purchase by the original purchaser ( Warranty Period ). If a defect arises and a valid claim is received within the Warranty Period, at its option, Brookstone will either 1) repair the defect at no charge, using new or refurbished replacement parts, or 2) replace the product with a new product that is at least functionally equivalent to the original product, or 3) provide a store credit in the amount of the purchase price of the original product. A replacement product or part, including a user-installable part installed in accordance with instructions provided by Brookstone, assumes the remaining warranty of the original product. When a product or part is exchanged, any replacement item becomes your property and the replaced item becomes Brookstone s property. When a store credit is given, the original product must be returned to Brookstone and becomes Brookstone s property. Obtaining Service: To obtain warranty service, call Brookstone Limited Warranty Service at 1-800-292-9819. Please be prepared to describe the product that needs service and the nature of the problem. A purchase receipt is required. All repairs and replacements must be authorized in advance. Service options, parts availability and response times will vary. You are responsible for delivery and the cost of delivery of the product or any parts to the authorized service center for replacement, per our instructions. Limits and Exclusions: Coverage under this Limited Warranty is limited to the United States of America, including the District of Columbia and the U.S. Territories of Guam, Puerto Rico, and the U.S. Virgin Islands. This Limited Warranty applies only to products manufactured for Brookstone that can be identified by the Brookstone trademark, trade name, or logo affixed to them or their packaging. The Limited Warranty does not apply to any non-brookstone products. Manufacturers or 13
suppliers other than Brookstone may provide their own warranties to the purchaser, but Brookstone, in so far as permitted by law, provides these products as is. This warranty does not apply to: a) damage caused by failure to follow instructions relating to product s use or the installation of components; b) damage caused by accident, abuse, misuse, fire, floods, earthquake or other external causes; c) damage caused by service performed by anyone who is not a representative of Brookstone; d) accessories used in conjunction with a covered product; e) a product or part that has been modified to alter functionality or capability; f) items intended to be periodically replaced by the purchaser during the normal life of the product including, without limitation, batteries or light bulbs; g) any product sold as is including, without limitation, floor demonstration models and refurbished items; or h) a product that is used commercially or for a commercial purpose. Brookstone SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT, OR ARISING OUT OF ANY BREACH OF THIS WARRANTY. TO THE EXTENT PERMITTED BY APPLICABLE LAW, BROOKSTONE DISCLAIMS ANY AND ALL STATUTORY OR IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND WARRANTIES AGAINST HIDDEN OR LATENT DEFECTS. IF BROOKSTONE CANNOT LAWFULLY DISCLAIM STATUTORY OR IMPLIED WARRANTIES, THEN TO THE EXTENT PERMITTED BY LAW, ALL SUCH WARRANTIES SHALL BE LIMITED IN DURATION TO THE DURATION OF THIS EXPRESS WARRANTY. Some states disallow the exclusion or limitation of incidental or consequential damages or how long an implied warranty lasts, so the above exclusions or limitations may not apply to you. This warranty gives you specific legal rights and you may also have other rights, which vary from state to state. 14
Find thousands more great ideas online 754219 Merrimack, New Hampshire USA 03054 800-846-3000 Brookstone.com