UNIVERSITI TEKNIKAL MALAYSIA MELAKA Kurikulum Vitae Curriculum Vitae. I. Maklumat Peribadi: Personal Particulars Nama: Name: Dr. Jurifa Mat Lazi Jawatan Sekarang: Current Position: Gred Kumpulan: Gred position Senior Lecturer DS52 II. A. Kelulusan Akademik dan Profesional (Sila senaraikan semua kelulusan akademik bermula daripada Ijazah Sarjana Muda mengikut susunan kronologi) Academic and Professional Qualifications (Please list all academic qualifications, from your first degree in chronological order) Tahun Year 2001 Kelulusan Degree IJAZAH SARJANA MUDA Pengkhususan Discipline Universiti University Universiti Teknologi Malaysia 2003 SARJANA Universiti Teknologi Malaysia 2017 PHD (Machine Drives) Universiti Teknikal Malaysia Melaka B. Tajuk tesis pasca siswazah (Sila senaraikan semua tesis bermula daripada peringkat Sarjana mengikut susunan kronologi) Titles of postgraduate thesis written (Please list all thesis written, from your Master Degree in chronological order) 1. Sarjana : STUDY OF ARCHING FAULT IN UNDERGROUND DISTRIBUTION CABLE 2. PhD : SENSORLESS AND INDEPENDENT SPEED CONTROL OF DUAL-PMSM DRIVES USING FIVE- LEG INVERTER III. Bidang Penyelidikan Yang Utama (Sila senaraikan sehingga tiga sahaja) Main Areas of Research Interest (Please list a maximum of three) a. Power System b. Machine Drives c. Power Electronics 1
IV. Projek Penyelidikan Yang dilaksanakan (Sila tulis tajuk, tajaan dan nombor rujukan projek sejak 2005) Completed/On-going research project since 2005 (Please write the title, funder and reference number) Short Term Grant: 1. Computer Base Speed Drive Control System of Single-Phase Induction Motor (Leader) Funder: UteM Ref. Number : PJP/2005/FKE (7) S068 2. Design and Develop a Power Over Ethernet (Leader) Funder : UteM Ref. Number : PJP/2007/FKE (6) S291 3. Design of Micro-Hydro Power Generator From House Water Tank For Home Application (Member) Funder : UTeM Ref. Number : PJP/2007/FKE (1) S286 4. Optimal Harmonic Elimination Pulse-width Modulation Strategies for Voltage Source Inverter Ref. Number : PJP/2014/FKE(2A)/S01307 FRGS 5. Modeling and Analysis of Bearingless PMSM (member) Funder : KPT Ref. Number : FRGS/1/2011/FKE/TK02/1-F00113 6. A New Simplified Rules Selection Method of Fuzzy Logic Speed Control for Induction Motor Drive (member) Ref. Number : FRGS/1/2015/TK04/UTEM/02/14 7. A New Optimal Switching Strategy for Virtual Flux Direct Power Control of Front-End Multilevel AC-DC Converter under Distorted and Unbalanced Grid Voltages. (member) Ref. Number : FRGS/1/2016/TK04/UTEM/02/11 ERGS 8. Investigation on Modeling and Control of Parallel Connected Three-Phase Two Motor Drives for Industrial and Consumer Applications. (member) Funder: Ministry of Higher Education Ref. Number : ERGS/2011/FKE/TK02/1-E00001 V. Senarai Penyeliaan Pelajar (Sila senaraikan nama pelajar, tajuk dan peringkat pengajian semenjak 2005) Supervision 2005-2009 (Please list their names, project title and status) Final Year Project : 1. Andrian Tham Tuck Man (Starting and Speed Control of 2 phase Induction Motor-Split-Phase Induction Motor) - completed 2. Ismail bin Mohammad (Flexible Electric Power Converter) -completed 3. Mohd Jamal bin Abu (Harmonic Filter Design for Induction Motor) -completed 4. Khairul Abidin bin Mohd Yasim (Design an Inverter for Photovoltaic System) - completed 5. Mohd Hafiz bin Zainuddin (Computer Aided Education on Special Transformer) - completed 6. Zairusfaizery bin Jopeny (Computer Aided Education on Three Phase Transformer) completed 7. Junaidah Binti Arifin 2
(Kos Penggunaan Tenaga Elektrik) - completed 8. Zainal Arif bin Abd Rajat (E- Pembelajaran Harmonik dalam Sistem Kuasa) - completed 9. Noor Faezah Binti Hamidi (The Temperature Control System) - completed 10. Puvaneswaran A/L Perumal (Multi Purpose Rostrum) - completed 11. Mohd Razif Bin Ismail (Building-up the DC Configuration, 2-stages for High Voltage Testing) - completed 12. Mohd Ashmawi bin Baharuddin (Building-up the AC Configuration, 1-stage for High Voltage Testing) - completed 13. Rahman bin Hassan (Building-up the Impulse Configuration, 2-stage for High Voltage Testing) - completed 14. Mohd Faqruddin bin Che Ishak (An Interactive Learning on Load Flow Analysis) - completed 15. Mohd Hafiz Fahmi Bin MD Fadzah (An Interactive Learning on Power System Control) - completed 16. Megat Izzudin bin Megat AB Manap (Smart Automated Home) - completed 17. Muhammad Saiful bin Ibrahim (Design and Develop a Power Over Ethernet) - completed 18. Khairol Helmi bin Roslan (Motor Drive for Induction Motor) - completed 19. Mohammad Faizul bin Shahbudin (Breakdown Characteristic for various type of Rubber) - completed 20. Mohd Faiz bin Kamarudin (Power Over Ethernet) - completed 21. NorAtikah bt Mohamad Rosli (E-learning for Power System) completed 22. Norhalila bt Shamsol (Basic Power System Fun Learning) completed 23. Mohd azizan bin Rahim (Back EMF Sensorless Control for Dynamic Performance of PMSM Drives) completed 24.Mohammed hafiz bin Abdul Hamid (Fuzzy Logic Speed Controller with Reduced based for PMSM Drives) completed 25.Mohammad Faiz bin Mohd salim (Fuzzy Logic Speed Controller With Reduced Rule Base for PMSM Drives) completed 26. Muhammad Azrin bin hashim (Interior Permanent Magnet Synchronous (IPMSM) Motor Drives) completed 27. Fatin Shaheerah Bt Mat Sukeri (Brushless DC Motor Drives) completed 28. Nabil Salem Yahya Farah (Cascaded H-bridge Multilevel Inverter with photovoltaic system (PV) ) completed 29. Siti Zaharah binti Anuar (Modelling and Analysis of Sensorless Permanent Magnet Synchronous Fundamental excitation) completed Machine (PMSM) by using 30. Fatin Shahieda binti Che Ali (Development and Analysis of Low Power and portable 12Vdc to 220Vac Inverter) completed 3
VI. SENARAI UTAMA PENERBITAN (penerbitan sejak 2005 hingga kini atau pada maksima 15 penerbitan) List of Major Publication (Please list a maximum of 15 publications since 2005) 1. Speed Drive based on Torque-Slip Characteristic of the Single-Phase Induction Motor. (The Sixth International Conferrence On Power Electronics & Drive Systems (PEDs), Renaissance Hotel, Kuala Lumpur ) 28 Nov 1 Dec. 2005, 2. Development of High DC Voltage Generator HVDC Testing of Vulcanized Rubber The 2nd International Power Engineering and Optimization Conference (PEOCO 2008), 4-5 Jun 2008, Shah Alam Selangor. 3. Experience in HVDC Testing of Vulcanized Rubber in UTeM s High Voltage Laboratory 2 nd IEEE International Conference on Power and Energy (PECon 08), December 1-3, 2008, Johor Baharu Malaysia. 4. Development of Power Over Ethernet FEIIC Symposium on Engineering and Technology, Kucing, Sarawak, Malaysia, 15-16 December 2008 5. "Dual Motor Drives for PMSM using Average Phase Current Technique" - PEcon'2010 - International Conference on Power and Energy 2010. 6. Sensorless Adaptive Speed Control for PMSM Drives - The 4 th International Power Engineering and Optimization Conference (PEOCO), 2010 7. "Performance Comparison of SVPWM and Hysteresis Current Control for Dual Motor Drives" - IAPEC 2011 - Applied Power Electronics Colloquium 2011 8. "Fuzzy Logic Speed Controller with Reduced Rule Base for Dual PMSM Drives" Journal WASET 2011 - World Academy of Science Engineering and Technology (International Conference on Computer, Electrical, and Systems Sciences, and Engineering) 9. Simulation single phase shunt active filter based on p-q technique using MATLAB/Simulink development tools environment IAPEC 2011 (Applied Power Electronics Colloquium 2011) 10. Comparative Analysis of Simplified and Standard Fuzzy Logic Controller in Vector Controlled PMSM Drive, 2011 IEEE Symposium on Industrial Electronics and Applications (ISIEA2011), September 25-28, 2011, Langkawi, Malaysia. 11. Mean and Differential Torque Control using Hysteresis Current Controller for Dual PMSM Drives, Journal of Theoretical and Applied Information Technology, (E-ISSN 1817-3195 / ISSN 1992-8645). 15 th November 2011 12. Sensorless Speed Control of Independent Dual-PMSM Drives fed by a Five-Leg Inverter, Australian Journal of Basic and Applied Sciences, 6(6):99-110,2012, ISSN 1991-8178 13. Independent Speed Sensorless Control of Dual Parallel PMSM based on Five-Leg Inverter, 9 th International Conference on Signal, System and Device 2012, SSD D 12, Chemnitz, German 14. Performance Investigation for Independent Speed Sensorless Control of Dual-PMSM Drives, 9 th International Conference on Signal, System and Device 2012, SSD D 12, Chemnitz, German 15. Sensorless Speed Control of PMSM Drives using dspace DS1103 Board, IEEE International Conference on Power and Energy 2012, PECON 2012, Kota Kinabalu, Malaysia 16. Speed and Position Estimator for sensorless PMSM Drives using Adaptive Controller, Wulfenia Journal, (ISSN 1561-882X)vol 21, No.3, March 2014 17. Independent control for dual-pmsm drives using Five-Leg Inverter, 2015 IEEE Conference on Energy Conversion (CENCON), Johor Baharu, Malaysia 18. HEPWM using differential evolution technique for three phase voltage source inverter, 2015 IEEE Conference on Energy Conversion (CENCON), Johor Baharu, Malaysia 19. Fuzzy Logic Controller of PMSM Drives for sensorless Drives, 2016 IEEE Conference on Energy and Power (PECON 2016), Melaka, Malaysia. 20. HEPWM using Differential Evolution Technique of odd and even switching pattern for three phase VSI, 2016 IEEE Conference on Energy and Power (PECON 2016), Melaka, Malaysia. 21. Simplified Self-Tuning Fuzzy Logic Speed Controller for Induction Motor Drive, 2016 IEEE Conference on Energy and Power (PECON 2016), Melaka, Malaysia. 4
VII. Penilai Jurnal dan Persidangan Reviewer for Journals and Conferences Paper Reviewer for 6 th International Power Engineering and Optimization Conference (PEOCO 2016) Paper Reviewer for International Conference for Energy and Power (PECON 2016) 5