Manual and Installation Guide

Similar documents
Manual and Installation Guide

Manual and Installation Guide

User Manual. Solar Charge Controller 3KW

User Manual Solar Charge Controller 3KW

3500W Solar Battery Charger Maximum Power Point Tracker

1700W Solar Battery Charger Maximum Power Point Tracker

INSTRUCTION MANUAL CAUTION

3400W Solar Battery Charger Maximum Power Point Tracker

PHOTO VOLTAIC CHARGE MODULE MULTI POINT TRACKING

OD10 10A Outdoor Solar Charge Controller

LS1024BP/ LS2024BP. Solar Charge Controller USER MANUAL

A2P Single Phase Automatic Industrial Battery Charger

LiFePO4 Instruction Manual. LFP12V50A LFP12V100A LFP12V200A 50Ah 100Ah 200Ah

BRAVO Inverter/Battery Charger. Table of Contents

MoJack Pro Assembly Instructions

TROJAN BATTERY COMPANY Renewable Energy Warranty Claim Form

AERL RACEMAX MAXIMIZER User's Manual

The Traveler Series: Wanderer

Sanitary Roof Hydrant Installation Instructions

Solar Controller / Battery Charger User s Manual

The Traveler Series: Wanderer

10 Year Limited Warranty

Ag Features. Multi-Stage Charging. Solar Panel or DC Input. Maximum Power Point Tracking (MPPT) Very Low Power Consumption

3400W Solar Battery Charger Maximum Power Point Tracker

Operating Manual

DURABLE DEPENDABLE PROVEN. IOTA Engineering tel:

Off-Grid Power Solutions EVOLUTION SERIES INVERTER/CHARGERS COMMERCIAL VEHICLES BACKUP POWER

3400W Solar Battery Charger Maximum Power Point Tracker

400W Solar Charger Maximum Power Point Tracker

Turbo M Series onboard charger

EZ Carrier 3. Owner s Manual. Keep instructions for future reference

Power. On Your Terms.

Installation Instructions

User s Manual. Complete Off-Grid Solar Kits (100 to 600 Watts) Complete Off-Grid Solar Kit Manual Revision 1.0

Single Leg AM/CM 20, 24 and 30

CONGRATULATIONS ON YOUR PURCHASE OF YOUR THUNDER BATTERY CHARGER! For your personal safety read, understand and follow the information provided in

Manual Installation & Operation

RUTLAND HRSi CHARGE REGULATOR

INSTRUCTIONS SPECIAL FEATURES

LS1024BP/ LS2024BP. Solar Charge Controller USER MANUAL

UGE-4K Off-Grid Controller OWNER S MANUAL

How To Set Up SimpliPhi Batteries Using OutBack Chargers

Airpax Dimensions, Inc.

6 hour run time. Crossover and Chest models:

Sanitary Yard Hydrant Installation Instructions

The Traveler Series: Adventurer

DC to AC Power Inverters

Matson Programmable Voltage Sensitive Relay MA98411

Battery Box. Let Thunder power your weekend escape! Watch us on. Scan code to see Thunder in action. facebook.com/thunderaccessories

Installation and Operating Instructions (for chargers shown below)

PROwatt 150 DC to AC Power Inverter. Owner s Guide

3400W Solar Battery Charger Maximum Power Point Tracker

INTRODUCTION. Specifications. Operating voltage range:

1700W Solar Battery Charger Maximum Power Point Tracker

Operating Instructions for Your Cobra 300 Watt POWER INVERTER M ODEL CPI 300. Nothing comes close to a Cobra

USER S MANUAL GPC SERIES LOW VOLTAGE DISCONNECT. Galley Power LLC.

RUTLAND HRDi CHARGE REGULATOR INSTALLATION AND OPERATION

Models DP10 & DP20 Series Low Voltage Disconnects User s Manual Rev. 1.1 October 31, 2007

INVERTER/CHARGERS Off-Grid Power Solutions

20kW PowerTech Ultimate Generator

OWNERS MANUAL JANUARY 2007 ISO

SBC / 2140 / Stage Battery Charger User Manual

The Traveler Series TM : Adventurer

1500W Solar Battery Charger Booster Maximum Power Point Tracker

Frequently asked questions

3400W Solar Battery Charger Maximum Power Point Tracker

Electrical District No. 3 SOLAR Q & A

WF-9500 Series Power Centers

BMS 12/200 for 12,8 Volt lithium iron phosphate batteries Especially designed for vehicles and boats

SAVE THESE INSTRUCTIONS

BMS16 v cell Lithium Battery Management System

OPERATION AND INSTRUCTION MANUAL. EP Series. Battery Chargers and Power Supplies

10A / 15A / 20A Solar Charge Controller. PU1024 / PU1524 / PU2024 series INSTRUCTION MANUAL

Table of Contents. Introduction. How Your Cobra Power Inverter Works. Rechargeable Appliances 1. Quick Checkout 2-3. Operation 4

Automatic Battery Charger Switching mode with Micro-controlled Input: Vac / Output: 12Volt DC

User Manual HomeGrid 5000 HD

AFTER SALES SUPPORT MODEL NUMBER: 45682

FUM-24xxCBP Series 3 Stage Battery Charger User Manual

KiloVault - HLX Series Lithium Iron Phosphate (LiFePO4) Deep Cycle Solar Batteries. Installation and Users Manual. Rev

AL-KO ESC USER MANUAL

GVB-8 (Boost) Manual

AUTO CHARGE 3 STEP AUTOMATIC BATTERY CHARGER

Sól Dual Voltage Buck Boost Solar Charge Controller Connection & Operation V1.00

AC CONVERTER / BATTERY CHARGER

Single Leg AM / CM 20, 24 and 30. Installation

KiloVault - HLX Series Lithium Iron Phosphate (LiFePO4) Deep Cycle Solar Batteries. Installation and Users Manual. Rev

DC to AC Power Inverters

UPPER TRAILING ARM REMOVAL

Power Meter with Balancing INSTRUCTION MANUAL

Power InverterTM Watt. Continuous. User's Manual. WAGAN Corp. Limited Warranty Registration Form. Item no

Operating Manual / / REV F

Charging with AC (wall) Charger

INSTRUCTIONS TUBULAR CONTROL ARMS & COIL-OVER CONVERSION FOR AMC MUSCLE CARS: 1970 AMX JAVELIN SPIRIT, HORNET, GREMLIN, CONCORD

Enginer Brand Po Box 185 Birmingham, Michigan

FLEXnet DC Programming & Guidelines

AC/DC Powered Peak Detection Fast Charger for 4- to 8-Cell Ni-Cd & Ni-MH Batteries

TECHNICAL SPECIFICATIONS OF 2 KVA POWER CONDITIONING UNIT

Automatic taper of charge rate for superior battery life through good equalization of cells and low water use rate.

Silvertel. Ag Features. Multi-Stage Charging. Battery Reversal Protection. Reduced Power Consumption. Wide DC or AC Input Voltage Range

40kW (and under) Solar/Inverter Installations Generation Interconnection Application to Minnesota Power

Transcription:

Manual and Installation Guide BB10012, BB5012

Table of contents Charging parameters BMS functions Installation Storage and maintenance Warranty Returns Contact us

Congratulations you have purchased one of the top 12v batteries on the market At Battle Born Batteries we do everything we can to make our batteries compatible with all the existing products on the market, unfortunately there are a few that slip through the cracks. This manual will serve as a guideline to check and see if your current charger will work with your new Battle Born Battery. Published on our website (battlebornbatteries.com) is also a list of chargers we have found to be compatible with our batteries. Bulk/Absorption For your Bulk/Absorption stage, the ideal voltage is between 14.2v-14.6v. This range will allow the battery to fully charge any higher then this and the built in BMS will send the battery into a protect mode. Float Our batteries do not need to float so setting your Float voltage to 13.6v or lower will essentially turn it off. Equalization Equalization is not recommended for our batteries. Most chargers will allow you to shut this feature off or use a setting that does not use equalization. If you cannot turn off this mode then you will need to adjust the voltage to below 14.6v Temperature Compensation Temperature compensation is not needed with our batteries and in some cases, may trigger the built in BMS to go into protect mode. For this reason, we recommend that temperature compensation be shut off or set to 0.

BMS Basic Features All Battle Born Batteries come with a built-in battery management system (BMS). Our BMS allows us to create one of the safest LiFeP04 batteries on the planet. To help us keep our promise that our batteries will last for 3-5000 cycles, our BMS will put the battery into a protect mode in the event the battery falls outside of one of the following parameters. High voltage: 14.7v-15.0v Will not allow any more current into the battery. Low voltage: 9.0v-10.5v Will not allow a discharge from the battery. (Note: many chargers must detect a voltage over 10v to send a charge to the battery). High temperature: 135F Will not allow a charge or discharge. Low temperature: 25F Will not allow a charge High Current The current exceeds 100 (+/- 5%) Amps for 30s or 200 (+/- 10%) Amps for 0.5s (this is interpreted as a short circuit) Allowable output The BMS constantly monitors the batteries output. We have set the following parameters to ensure our batteries maintain a high level of safety. BB10012 Surge: 200a for 30 seconds Continuous: 100a BB5012 Surge: 100a for 30 seconds Continuous: 60a Note: Higher current capabilities for ½ second. In all Cases the battery recovers automatically Cell Balancing At Battle Born Batteries we pride ourselves on making the highest quality product that we can. We have found the best way for us to do this is to capacity match the entire way, from the 120 cells to the 4 modules to however many batteries are in your bank just know that they have been specifically selected to give you the best performance. A concern that some customers have is cell balancing. We built passive cell balancing into OUR BMS so that you never have to worry about your battery becoming unbalanced.

Installation Our batteries are rather straight forward to install, simply connect your positive cables to the positive terminals and your negative cables to the negative terminal. Our batteries work great in either parallel or series configurations (up to 48v). Our batteries come standard with a flag style terminal post. These terminals include a 3/8 hole that allows for most ring terminals to work well with our batteries. For the best connection, we recommend either copper or brass ring terminals. Parallel Multiple BB10012 may be mounted in parallel in order to increase the current capacity of the system. When batteries are mounted in parallel, the voltage of the system does not change, but the current limits are additive. For example, two BB10012 batteries mounted in parallel can deliver 200A continuously and 400A for 30 seconds. Three BB10012 batteries mounted in parallel can deliver 300A continuously and 600A for 30 seconds. Therefore, all cables and connections MUST be able to accommodate the high currents that can be delivered by the battery. Appropriate fuses and circuit breakers are also highly recommended to protect downstream components from current spikes and short circuits. Series Two BB10012 may be mounted in series to increase the voltage of the system up to a 24V system. When batteries are mounted in series, current capacities remain the same, but the system voltage is additive. Two BB10012 batteries mounted in series to form a nominally 24V system should be charged using a bulk and absorption voltage of 28.8V, and a float voltage below 27.2V.

Storage and maintenance Storage Storage could not be easier simply charge the batteries fully and disconnect from any charge or discharge. Maintenance Battle Born Batteries require very little maintenance if any at all. If your batteries are in series and not being charged by a multi-bank charger it is recommended that you fully charge the batteries individually once a year. This will balance out the entire battery bank to ensure the batteries will reach its expected life span. If your batteries are in parallel this is not necessary. Our BMS has a built in passive balancing system that will take care of this for you.

Warranty Policy In the unlikely event, you are having an issue with one of our batteries we have developed a straight forward warranty policy to help answer any questions you may have. Battle Born Batteries offers a 3 year manufacturers defect warranty from the date of purchase. This warranty does not cover negligence or misuse of the battery. If it is deemed that battery was used improperly, you will be subject to a $150 an hour repair charge plus parts and shipping. We also warrant all other complimentary products (inverters, converters, chargers etc) we sell are free from defect for 30 days from the date of purchase. After that time it is the responsibility of our manufacturing partners and a standard manufacturer s warranty applies (1 year from date of purchase, unless otherwise stated by the manufacturer).

Return & Refund Policy Thanks for shopping at Battle Born Batteries. If you are not entirely satisfied with your purchase, we're here to help. Returns You have 45 calendar days to return an item from the date the item shipped. To be eligible for a return, your item must be in the same condition that you received it in. Your item must be in the original packaging. Your item needs to have the receipt or proof of purchase. Refunds Once we receive your item, we will inspect it and notify you that we have received your returned item. We will immediately notify you on the status of your refund after inspecting the item. If your return is approved, we will initiate a refund to your credit card (or original method of payment). You will receive the credit within a certain amount of days, depending on your card issuer's policies. Shipping You will be responsible for paying for your own shipping costs for returning your item. Shipping costs are nonrefundable. If you receive a refund, the cost of return shipping will be deducted from your refund. If you have any questions on how to return your item to us, please contact us.

Contact Us If you have any further questions, or need help with anything regarding your battery please do not hesitate to contact us. Battle Born Batteries Address 4814 Longley Ln Reno, NV 89502 Email info@battlebornbatteries.com Toll Free 855-292-2831