NANO HERCULES 3.5 CHANNEL IR HELICOPTER INSTRUCTION MANUAL AGES 8+ ITEM NO. 35939
REMOTE CONTROL TRANSMITTER LIGHT BUTTON INFRARED EMITTER TURBO BUTTON CHANNEL SELECTOR THROTTLE FORWARD/BACKWARD/ LEFT TURN/RIGHT TURN TRIM KNOB POWER SWITCH BATTERY INSTALLATION Unscrew cover and install 6x AA Batteries as shown. Please note polarity and orientation of batteries. PREFLIGHT CONDITIONS Be sure that Helicopter Battery is fully charged and Remote Control Batteries are fresh. Helicopter will fly best in low wind conditions. Fly Helicopter in a wide open area with no people, pets, and other objects in the way. Do not fly in strong winds. This will make operation difficult and crash the Helicopter. 1: Parental Guidance is suggested for children operating Helicopter. 2: Multiple Helicopters operating simultaneously must be on different Frequency Bands.
HELICOPTER TAKEOFF 1: Place Helicopter on a flat surface. Turn on the Transmitter and the Helicopter 2: Check surroundings to be sure that it is clear of people, animals, and obstructions. 3: Slowly push the Throttle Stick up to increase blade speed for lift. 4: Adjust throttle input to maintain a steady hover. FLIGHT CONTROLS The Left and Right Sticks will move the helicopter as follows: UP DOWN FORWARD BACKWARD TURN LEFT TURN RIGHT
ADJUSTMENTS If the Helicopter spins to the left or right in flight without your input, you will need to adjust the trim. Helicopter spins to the left. Slowly twist the trim knob to the right until the helicopter stops spinning. Helicopter spins to the right. Slowly twist the trim knob to the left until the helicopter stops spinning. Switch between High & Low Speed Modes LIGHT BUTTON CHARGING 1: Helicopter can be charged from: USB, Controller, or AC Charger 2: Move the Helicopter Power Switch to the OFF position 3: Connect Charging Adapter to Helicopter Charge Port. 4: Once charging is complete, disconnect Charging Plug from Helicopter. 5: Helicopter is ready for flight. TROUBLESHOOTING USB CONTROLLER The Transmitter indicator LED does not work Batteries installed with the wrong polarity. Batteries are drained. Check the polarity of the batteries and install them Correctly. Install new batteries. No control of the helicopter Helicopter is not IR receiving signal from transmitter. Windy Conditions. Point Transmitter at Helicopter or operate in conditions with less sunlight. Fly helicopter in calm conditions. Helicopter is not flying high enough Helicopter is not receiving signal from transmitter correctly. Rotor speed is too slow. Batteries are drained. Test the control functions of the helicopter in a hover by applying light throttle and testing left and right controls. Push Left Control Stick up for more rotor speed. Fully charge helicopter before use.
ATTENTION READ THESE INSTRUCTIONS BEFORE OPERATING THE HELICOPTER - Install only new batteries of the same type in your product. - Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten the life of the batteries or cause batteries to leak. - Do not mix old and new batteries. - Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries. - Do not dispose of batteries in fire. - Batteries should be recycled or disposed of as per state and local guidelines. Website: www.worldtechtoys.com Email: customerserv@worldtechtoys.com Phone: (877) 498-8697 Monday - Friday / 9:00AM - 5:00PM / Pacific Time SPECIFICATIONS, COLORS AND CONTENT MAY VARY FROM ILLUSTRATIONS MADE IN CHINA WWW.WORLDTECHTOYS.COM This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions. 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation.