A70000 MEP COORDINATION NOTES: TYPICAL MDF DESIGN REQUIREMENTS : ALL ROOM RECEPTACLES SHALL BE FED FROM DEDICATED IT PANEL, AND TIED INTO EMERGENCY SYSTEM. RECEPTACLES (CONVENIENCE): () 0 AMP DUPLEX RECEPTACLE ON NORMAL CENTERED ON EACH WALL, AND () 0 AMP DUPLEX RECEPTACLE PER WALL MOUNTED. RECEPTACLES (RACK MOUNTED): WHERE EMERGENCY IS AVAILIABLE: () DEDICATED, NEMA 5-0R 0A/0V RECEPTACLES AT EACH SIDE OF CENTER RACK WITHIN BACKSIDE OF VERTICAL WIRE MANAGER. WHERE EMERGENCY IS NOT AVAILABLE: () DEDICATED, NEMA 5-0R 0A/0V QUAD RECEPTACLE AT EACH SIDE OF CENTER RACK WITHIN BACKSIDE OF VERTICAL WIRE MOUNT RECEPTACLES AT 6" AFF TO BOTTOM OF JUNCTION BOX. HVAC: PROVIDE 0,000 BTU/HR SENSIBLE COOLING PER RACK. LIGHTING: FIXTURES SHALL BE PLACED RUNNING PARALLEL WITH RACKS. PROVIDE MIN. 50 FC AT '-0" AFF. PROVIDE MIN. LAMP ON EMERGENCY. - --- 0' - 0" CLEAR RADIUSED CORNER BRACKETS, TYP. TGB @ 7'-0" A.F.F. ' - 0" CLEAR WALL MOUNTED FIELD TERMINATION KIT S0A(X)-00FT D-RINGS FOR CABLE MANAGEMENT WALL MOUNTED RECESSED DEDICATED PANEL - T40 FRONT 6" X 48" CLEAR AREA AT PANEL RACK # RACK # RACK # RECEPTACLE(S) FACING REAR, INSIDE V.W.M. TYPICAL ACTIVE RACK MOUNTED T40 RECEPTACLE(S) FACING REAR, INSIDE V.W.M. 96" DUAL POST RACK TYP. OF 0" V.W.M. TYP. OF SLEEVES TO STACKED ROOMS DISTRIBUTION SYSTEM AT 7'-" A.F.F. (ABOVE DOOR FRAME) RESERVED SPACE FOR WALL MOUNTED RECEPTACLE AT WALL MOUNTED TYP. CONDUIT SLEEVES ABOVE FOR HORIZONTAL CABLING CONDUIT SLEEVES ABOVE FOR HORIZONTAL CABLING TYPICAL IC ROOM - EMERG./STANDBY /" = '-0"
RACK RACK 4404-4404- 4404-4404- 4404-4404-4 4404-5 RACK 4406-4406- 4406-4406- 4 5 6 7 8 9 0 4 5 6 7 8 9 0 4 A70000 TR RACK ELEVATION PATCH PANEL PORT S: 440- OUTLET LOCATION/ROOM # FACEPLATE#: NUMERIC SEQUENCE CLOCKWISE WITHIN ROOM OR SPACE EXAMPLE SHOWS ROOM 440, FACEPLATE (DIFFERENT PORTS WITHIN THE SAME FACEPLATE WILL HAVE THE SAME ) 4 T40 A APPLY PATCH PANEL (A -Z FROM TOP DOWN) CONTRACTOR APPLIED PORT S SIEMON SNAP ON HOLDER FOR ICONS TYPICAL 4-PORT U PATCH PANEL DETAIL " = '-0" RACK FED FROM ABOVE LB TYPE CONDUIT FITTING EXTEND CONDUIT PAST FRONT OF 0' - " 7' - " SYSTEM W/ " STANDOFF TO RAISE ABOVE DOOR FRAME CONDUIT INSIDE REAR OF WIRE MANAGER AT EACH SIDE OF MIDDLE RACK. T50 T50 RECEPTACLE(S) AT REAR, TYP. SEE T50 RACK # RACK # RACK # (DISTRIBUTION) RMU 4 PORT ANALOG PATCH PANEL (MIDDLE RACK ONLY) RACK # RACK # RACK # 4U FIBER LIU 4 RMU (ATS) 0" x 84" DOUBLE SIDED VERTICAL WIRE MANAGER (V.W.M.) WITH HINGED COVERS TYP. OF 4 APPLY RACK S AT TOP HORIZONTAL BRACE OF EACH RACK. RMU OWNER NETWORK / SWITCHES WITH RMU SPACE BETWEEN TYPICAL ATS DEVICE BY OWNER WHEN EMERGENCY /STAND-BY IS AVAILABLE (DISTRIBUTION) RMU HORIZONTAL WIRE MANAGER AT TOP, TYP. PER RACK 4 T40 RMU 4 PORT FLAT PATCH PANELS SIEMON #Z6A-PNL-4K TYPICAL RMU HORIZONTAL WIRE MANAGER TYP. MIN. '-0" CLR. SYSTEM. DOUBLE-SIDED VERTICAL WIRE MANAGER CONDUIT INSIDE VERTICAL WIRE MANAGER CENTERLINE OF RACK POSTS REAR REAR FACING RECEPTACLE(S) ON DOUBLE GANG BACKBOX - SEE T50 RACK ELEVATION - FRONT OF RACKS SECTION THRU WIRE MGR /4" = '-0" /4" = '-0" FLOOR T50 FRONT Bard, Rao + Consulting E 0 Guest St., 4t Boston, MA 0 tel 67.54.00 www.brplusa.co DUKE UNIVERSITY OIT ROOM REQUIREMENTS PROJECT: JOB NO.: CHECKED: DRAWN: DATE: SCALE: SKETCH: REV. DWG: T4
A70000 TR RACK RECEPTACLE OPTIONS NEMA 5-0R 0A/0V TO NORMAL T40 U TRANSFER SWITCH EATON STS 400 BY OWNER (6) 5-5 INPUTS () NORMAL OUT () EMERG. OUT T40 EMERG./STANDBY (RED) ' - 0" 0' - 6" RACK NEMA 5-0R 0A/0V TO NORMAL NEMA 5-0R 0A/0V EMERG./STANDBY (RED) RACK QUAD RECEPTACLE NEMA 5-0R 0A/0V TO NORMAL VERTICAL WIRE MANAGER RECEPTACLES REAR OF RACKS - EMERGENCY AVAILABLE " = '-0" RECEPTACLES REAR OF RACKS - EMERGENCY NOT AVAILABLE " = '-0"
A70000 USE SNAP IN ING KIT TO WITH ORIGINATION MDF ROOM# TR VOICE RISER MDF -00 Siemon S0A(X)-00FT Labeling at IDF 6" = '-0" USE SNAP IN ING KIT TO WITH ORIGINATION MDF ROOM# MDF -00 IDF -000 Siemon S0A(X)-00FT Labeling at IDF 6" = '-0" USE SNAP IN ING KIT TO WITH DESTINATION IDF ROOM# IDF 000 Bard, Rao + Ath Consulting Engine 0 Guest St., 4th Floo Boston, MA 05 tel 67.54.006 fa www.brplusa.com USE SNAP IN ING KIT TO WITH DESTINATION IDF ROOM# IDF -000 IDF -000 IDF -000 T50 0 IDF 000 0 IDF 000 0 4 PORT RACK RACK RACK 4 PORT RACK RACK RACK 4 PORT RACK RACK RACK IDF -000 IDF -000 Siemon S0AA-00FT Labeling at MDF MDF 00 6" = '-0" 0. T50 SIEMON #S0A(X)-00FT 00 PAIR FIELD TERMINATION KIT 5 PAIR x 50 FT. TIE CABLE WITH 90 DEGREE FEMALE AMP CONNECTOR (TYP. IN EACH IDF) 50 PAIR TIE CABLE FROM MDF TO EACH IDF SUPERIOR ESSEX #8-789- (RISER) SIEMON #S0AA-00FT 00 PAIR FIELD TERMINATION KIT DUKE UNIVERSITY OIT ROOM REQUIREMENTS PROJECT: JOB NO.: CHECKED: DRAWN: DATE: SCALE: T50 DESCRIPTION: Siemon S0AA-00FT Labeling at MDF 6" = '-0" Typical Copper Riser Diagram - Duke University 6" = '-0" SKETCH: T50 REV. DWG:
A70000 TR OUTLET ING PULL CORD CATEGORY UTP CABLE CABLE AREA CONDUIT BY E.C. 4404 - OUTLET LOCATION : IDF ROOM : ROOM# FACEPLATE # 4404 - TR606 IDF ROOM# PATCH PANEL PORT : PATCH PANEL LETTER A # (4) 8P8C MODULAR JACK SIEMON Z6A-0 FACEPLATES WITHIN EACH ROOM TO BE ED NUMERICALLY STARTING AT POINT "" AND THEN CLOCKWISE PORTS WITHIN FACEPLATE TO BE ED WITH PATCH PANEL PORT # ROOM# PATCH PANEL PORT # A A DESIGNER MOUNTING FRAME (WHITE) SIEMON MX-D4Z-0 SINGLE GANG HUBBEL DECORATOR FACEPLATE 4 /6" X 4 /6" SQUARE x " DEEP (MIN.) BACKBOX TYPICAL OUTLET ING DETAIL TYPICAL FACEPLATE ING N.T.S. " = '-0"