A WBENC and ISO 9001:2008 Certified Company Mohawk Ltd. is pleased to provide the following specifications for a 30 Mobile Command Trailer: Please keep in mind these specifications are based on a particular customers requirements and can be customized to fit your needs as desired. Rollingstar RS830GS80 30'x102 Custom Enclosed Trailer: 14,000 lb. GVWR, tandem 8,000 lb. torsion electric brake axle suspension, FRP fiberglass wall system, structural steel trailer frame, plywood subfloor, one-piece aluminum roof, DOT compliant trailer lighting Bright white gel coat both sides Insulated FRP composite walls, 1" R-7 urethane foam insulation. 1/4 panels, 1-1/2 total wall thickness 2-5/16" ball for gooseneck trailers (2) "bump" rollers heavy duty, mounted under rear trailer frame (2) 32" x 80" RV style door w/ knob and dead bolt style locksets (2) heavy duty pull-out steps below personnel door (2) grab handles at entrance door locations (6) windows, 30"x15" tinted, Hehr 5900 Series Mini blinds for above windows, RV style Awning, 20' Dometic "Imperial 8500" Aluminum "Alcoa" wheels, 8-lug, set of (4) Spare tire w/mount 235/85 (standard on white mod rim) HWH 300 Series Touch Panel-Controlled Hydraulic Leveling System w/(4) corner jacks, hydraulic pump/control unit and 12V deep cycle battery, touch pad to be mounted exterior of trailer w/aluminum access door (2) stabilizing jacks, 5,000 lb. removable crank down jacks w/holders Deluxe ceiling package includes 6" insulation and poly-board ceiling liner PVC commercial flooring, coin pattern Heavy duty walk-on roof, 1/2" plywood under one-piece aluminum roofing over roof bows Roof platform, 12' x 8-1/2'W, aluminum construction w/tread plate floor, 6" high permanent rail around perimeter w/fixed rear access ladder Partition w/pocket door, built up w/poly-board white paneling (2) generator or storage compartment access door, 36"x60" heavy duty WTB locking, powder-coat finish to match trailer body Electrical 12v Polar vent (thermostatically controlled/rain sensor/automatic or manually controlled) w/"maxair" roof vent cover (8) 12 volt dome light (white lens) w/(2) three way wall switches (2) timer switch, 12 volt w/manual override (for 12 volt dome lights in generator and overbunk storage compartments) 12V master switch to disconnect battery power from 12V system (2) 12V porch type light at entry door locations, individually switched LED flashing light system, (6) exterior flush-mount BLUE LED lightheads Green strobe light on riser mounted on roof of trailer 12 volt power system: Magnetek 7455 12 volt converter and (2) group 27 deep cycle batteries Magnetek Model 100D 220V/110V/12V 50 amp entrance/distribution panel 30-amp 120 volt shore power w/50' shore cord and exterior power receptacle 10 kw Onan Quiet Diesel Generator (83A) mounted in overbunk area with 50 gallon frame mounted fuel tank, battery, auto transfer switch and remote start /stop switch 50 gallon diesel fuel tank in lieu of 26 gallon standard Fuel gauge & sending unit for certified fuel tank mounted inside trailer Rapid-fill fuel filler w/locking access door (5) 48" fluorescent ceiling light, T-8 type w/electronic ballasts, flush mount 2-bulb, 110 volt w/(2) 3- wqy wall switches (5) 48" fluorescent strip-light, single bulb, undercabinet light, 110 volt 800-225-6642 PO Box 340 One Newell Lane Chadwicks, NY 13319 Fax: 315-737-7347 www.mohawkltd.com info@mohawkltd.com
A WBENC A and ISO 9001:2008 9001:2000 Certified Company (2) 110V duplex interior power receptacles, stand alone (4) 110v GFCI protected outlets, exterior w/weatherproof cover Wiremold 5400 Series two-piece multi-channel nonmetallic raceway (2 compartment configuration), raceway will incorporate 110-volt plugs, 110V wiring, 12V wiring, telephone wiring and coax communications cables. (6) 12volt accessory power receptacle (12) 110V duplex power outlets for "WireMold" installation (5) 500W 110 volt flush mount quartz scene lights (4.2A), switched sides and rear Telephone wiring center, ETCON DD1C Phone Wiring Center & Cover (8) telephone jacks and wiring, "WireMold" installation Exterior telephone inlet w/weatherproof cover and wiring (8) data jacks and CAT5 wiring, "Wiremold" installation (6) radio coax jack, "WireMold" installation, includes 50 ohm (RG58AU or equivalent) coax cable connected to (1) roof mounted screw-on antenna base. Antenna platform, 24"Wx96"L roof mounted, aluminum Communications terminal compartment, 10" deep compartment w/18"x18" WTB exterior access door (powdercoat finish), locking paddle latch (2) TV/Monitor Station Setup includes outlet, ABC switch, splitter, (2) duplex power outlets and associated cable and accessories Retractable TV antenna, Winegard "Sensar RV 3090", crank-up w/ cable-ready hookup 7-pin XLR connectors, wiring and installation: male and female chassis mount located in front "Negotiations" area wired to opposite XLR connectors in "Communications" compartment Audio/video distribution amplifier and cabling to (2) television/monitor locations (accepts base band composite audio/video signal via RCA type cables from many source, amplifies and distributes signal to up to (7) different receivers without signal loss) Heating and Air Conditioning (2) 13,500 BTU roof mount air conditioner w/5600 btu heat strip, ducted (vents with shutoffs), vent locations to be determined (2) 1500 watt forced air wall heater w/fan and wall mounted thermostat (12.5A) (4) 110V 48 electric baseboard heater w/integral thermostat (4.2A) (2) KIDDE Proline PRO5TCM 3-A: 40-B: C or equivalent 5 lb. fire extinguishers Combination CO/smoke detector alarm, 9v battery powered Cabinets and Work Surfaces Storage cabinets and work surfaces are located per attached drawing. Cabinets feature locking T handles and 1-5 shelves (depending on cabinet height). Cabinet casework and doors feature plastic laminate construction over plywood cores with radius corners and impact resistant edge reinforcement. Work surfaces are NevaMar abrasion resistant plastic laminate over plywood core construction. Front edge of work surfaces is radiused impact resistant edge banding. Front "Negotiations" Area Upper cabinets 12"Dx32"H along curbside and streetside walls w/dry erase laminate door fronts Countertop/work surface, 24 D along curbside and streetside walls w/support brackets (4) pencil drawers under "Negotiations" area countertops Front Overbunk cabinet cluster w/tv cabinet 38"Hx20"D built-in cabinets, dry erase laminate on doors 24-3/8"Wx38"Hx20"D TV and storage cabinet "Command Control" Area Countertop w/supports along streetside wall, 24" wide Upper cabinets per print, approx 32" high x 12" deep with (2) shelves, locking "T" handles, dry erase laminate doors Dry-erase marker board, 60"x60" Angled TV/VCR Cabinet, 89-1/2"Hx33"Wx21"D w/doors top & bottom, shelves in center 800-225-6642 PO Box 340 One Newell Lane Chadwicks, NY 13319 Fax: 315-737-7347 www.mohawkltd.com info@mohawkltd.com