Cargo Handling Sheet Caradol SC 56-16
Product Details: Product Name: Shipping Name: Chemical Family: Product Code: MSDS: Caradol SC56-16 Glycerol Propoxylated and Ethoxylated Polyols U311D http://www.euapps.shell.com/msds/gotomsds?loc=shellchemicals Physical Properties: Density: 1,017 kg.m3 @ 20 deg C. Specific Gravity: Dynamic Viscosity: 650 (mpas) @ 20 deg C. Vapor Pressure: <10 (hpa) Boiling Point: >285 deg C. Melting Point: t available Flash Point: 200 deg C. tes: Transshipments are not permitted unless the responsible Shell Chemical charterer has been consulted and the operation approved by the Regional Marine Technical Advisor. Marpol Details: Marpol Annex: II IMO Ship Type: 3 Shell Chemicals requires a ship type 2 IMO Pollution Category: Oil Like: High Viscosity: Solidifying: USCG: Z N/A N/A USCG Group 40 not compatible with group 12 Isocyanates 2
Cargo Handling Requirements: Prepurging of Vessel s Tanks: Blanket Required: Percent Oxygen in Nitrogen Blanket: Vapor Space Purge: Yes <5% See also Regional Requirements notes Loading Temperature Range: Ambient 40 deg C. Transit Temperature Range: 25 40 deg C. Discharge Temperature Range: See regional requirements Maximum Heating Coil Temperature: 100 deg C. Adjacent Maximum Cargo Temperature: 50 deg C. Regional Requirements: Discharge temperatures:- Singapore/Far East 42 49 deg C. tes: If Nitrogen blanket is in place and Carrier chooses to transship, carrier must reapply nitrogen blanket on the cargo, both on the discharging and receiving ship, at their time, risk, and expense. Tank Acceptance Requirements: All shore and ship cargo lines and tanks are to be presented clean (residual free), dry, odor free, and rust free, with good gaskets and pressure tested heating coils. Stainless Steel or Coated Tanks: Wall Wash Required: Coated, carrier to verify suitability of coating for product. See also Regional requirements notes. Yes for International. rmally loaded in Singapore Wash Specifications: Water Misc. pass Chlorides Max 5ppm Odor residual Permanganate >30 minutes Color max 5 Acidity 0.05 mgkoh/g max. Appearance Clear Or to local requirements. 3
Cargo Sampling, Testing & Sample Retain Requirements International Voyages. Unless alternative written instructions have been provided by Shell locally, the requirements described here should be met. For each sample which will be tested, a duplicate sample should be taken, retained and sealed in surveyor custody, in a temperature controlled environment. All samples should be stored in clear glass bottles with airtight closures. Samples at loading: Samples at loading which must be on a 180 day minimum retain by surveyor: Shore tanks Shore manifold Ship manifold Ship first foot Ship tank final Samples on discharge Shore tank before discharge Ship tanks Ship manifold Shore manifold Shore line at shore tank Shore tank after discharge. Sample testing and Product Release Loading: Shore tank approved by location based on local process. Manifold samples tested in the field for appearance only. Product release based on location process. Discharge: Product acceptance based on location process. Manifold samples tested in the field for appearance only. 4
Safety Information and Incident Reporting. Safety Information: For more detailed information, refer to the MSDS or e-sds for reportable spill/release quantities whether in the water, air or ground. Incident Reporting: If an incident occurs outside the territorial limits of the USA, call Shell International Trading and Shipping in London on (44) 207-934-7777. If the spill/release marine incident occurs within the territorial limits of the USA, call the Shell 24 hr. incident number at 713-241-2532. The USA National response center telephone number is 1-800-424-8802 For additional marine cargo handling advice or information, contact Captain Eddie Trotter at (+1 713 241 3535) Shell Chemical LP PO Box 4407 Houston Texas 77210 USA Tel +1 866 897 4355 Internet http://www.shell.com/chemicals Disclaimer The information contained in this publication is, to the best of our knowledge, true and accurate, but any recommendations or suggestions that may be made are without guarantee, since the conditions of use are beyond our control. Furthermore, nothing contained herein shall be construed as a recommendation to use any product in conflict with existing patents covering any material or its use. Shell Chemicals The expression Shell Chemicals refers to the companies of the Shell Group of companies that are engaged in the chemical businesses. Each of the companies that make up the Shell Group of companies is an independent entity and has its own separate identity. 5