VEHICLE CONTROLS Vehicle Controls Learn about the various controls necessary for operating and driving the vehicle. Using the Key or Remote Transmitter* Lock or unlock the doors and trunk. Lock button: Press to lock the doors. Press again for audible verification. Unlock button: Press once to unlock the driver s door. Press again to unlock all doors. Trunk button: Press and hold to unlock and open the trunk. Engine button*: Remotely start the engine. Panic button: Press to sound the alarm for 30 seconds. Press again to cancel. Built-in key: Slide the release knob on the back of the transmitter and pull out the built-in key. Release knob Built-in key NOTICE Leaving the key or remote transmitter in the vehicle can result in theft or accidental movement of the vehicle. Always take it with you whenever you leave the vehicle unattended.
Door Operation Use several methods to lock or unlock the doors. Using the Lock Tab To unlock: Pull the lock tab rearward. When you unlock the door using the lock tab on the driver s door, only the driver s door unlocks. To lock: Push the lock tab forward. When you lock the door using the lock tab on the driver s door, all the other doors lock at the same time. Using the Front Door Inner Handle When you pull either front door inner handle, the door unlocks and opens. Unlocking and opening the driver s door from the inner handle unlocks all other doors. To lock To unlock Lock tab Using the Master Door Lock Switch To unlock: Press the unlock side of the switch to unlock all doors. To lock: Press the lock side of the switch to lock all doors. Master door lock switch To unlock To lock Childproof Door Locks The childproof door locks prevent the rear doors from being opened from the inside regardless of the position of the lock tab. Slide the lever in the rear door to the lock position, and close the door. Open the door using the outer door handle. Lock Unlock Using the Trunk Opener Press the trunk opener on the driver s door to open the trunk. Trunk release button
Customizing Door Lock Settings Vehicle Controls Customize the auto door-lock setting to your preference. Begin with the vehicle off. Models with information display 1. Apply the parking brake 2. Position the driver's door To enable auto door lock: close the driver's door To disable auto door lock: open the driver's door 3. Set your preference Models with key ignition Models with Smart Entry a. Set the ignition switch to ON b. Press the lock side of the master door lock switch until you hear a click (~ 5 sec.) c. Set the ignition switch to ACC Models with driver information interface See Customized Features. a. Push ENGINE START/STOP twice (do not press the brake pedal) b. Press the lock side of the master door lock switch until you hear a click (~ 5 sec.) c. Push ENGINE START/STOP twice (do not press the brake pedal)
Smart Entry System* When you carry the remote transmitter (for example, in a pocket or purse) and it is outside the vehicle and within range (about 32 inches or 80 cm), you can lock or unlock the doors and trunk without handling the transmitter. Unlocking/Locking the Doors To unlock: Grab the driver s door handle when the vehicle is off to unlock the driver s door. Grab the front passenger s door handle to unlock all doors. To lock: Press the door lock button on the front door handle when the vehicle is off. If the remote transmitter is inside the vehicle, the doors will not lock. Door lock button Unlocking the Trunk Press the trunk release button to unlock and open the trunk. Trunk release button
Walk Away Auto Lock* When you walk away from the vehicle while carrying the remote transmitter, the doors can automatically lock if the following conditions are met: The remote transmitter is within a range of 5 feet (1.5 m). All doors and the hood are closed. There is not an additional remote transmitter inside the vehicle. Follow these steps (see diagram): 1. Exit the vehicle, close the door and stay near it. Listen for a beep. The system is activated. 2. Walk at least 5 feet (1.5 m) away. 3. Listen for a beep and look for the lights to flash. The doors lock. To turn on this feature, follow the steps below. The vehicle must be in Park (P). 1. From the HOME screen, select Settings. 2. Select Vehicle. 3. Select Door/Window Setup. 4. Select Walk Away Auto Lock. 5. Select On. 6. Select BACK to exit the menus. u v w