Instruction No Version Part. No. 8637033 1.0 5 TV NTSC/PAL Page 1 / 17
Page 2 / 17
INTRODUCTION Read through all of the instructions before starting installation. Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation. Ensure that all tools stated in the instructions are available before starting installation. Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps. In the event of any problems with the instructions or the accessory, contact your local Volvo dealer. Note! Applies only to Europe: A new rear windshield must be installed if the present windshield does not have an integrated antenna. Note! This accessory is connected to the car's electrical system. It requires software unique to the car. Interior preparations Page 3 / 17
1 Interior preparations Turn the ignition key to position O Cars with manual gearboxes: Remove the ignition key Disconnect the battery negative lead. Note! Wait at least five minutes before disassembling the connectors or removing other electrical equipment. A8800136 2 Remove the seat cushion (1). First pull the front edge of the seat cushion up. Pull the cushion forwards. Then lift the seat cushion out. D8503390 Page 4 / 17
3 Fold both the rear backrests forward Remove the seat belts from the guides (1). M8503545 4 Remove the clip (1) at the side of the left-hand side cushion Pull the top edge of the left front cargo compartment panel out to access the upper lock for the side cushion Repeat the operation on the right-hand side. M8503511 Page 5 / 17
5 Remove the left-hand side cushion. First press in the catches (1) at the top edge of the reverse of the side cushion. Pull the cushion out slightly Grasp the cushion using both hands. Twist counter-clockwise until the catches on the inside release Remove the side cushion. First pull out the upper edge of the side cushion. Then pull upwards Repeat the operation on the other side. M8503546 6 Remove the cover and the screw for the left-hand C-post panel Repeat the operation on the other side. M8503596 Page 6 / 17
7 Remove the rubber strip at the rear edge on the left-hand rear door frame Grasp the top edge of the C post panel. Pull (A) the panel inwards until the three clips (1) release Then pull (B) the panel straight up. Place the panel to one side Repeat the operation on the other side. M8503597 8 Carefully lift the front edge of the parcel shelf panel until the clips (1) release Lift up the panel further until the locating pins (2) release from their holes Pull out the parcel shelf. Lay the parcel shelf on the folded backrests. M8503598 Cargo compartment preparations Page 7 / 17
9 Cargo compartment preparations Remove the cargo compartment carpet at the rear edge. First turn the two handles (1) 90. M8503480 10 Pull up the front of the cargo compartment carpet. Fold the front half back over the rear half of the cargo compartment carpet. M8503481 Page 8 / 17
11 Slide the entire cargo compartment carpet forward slightly. Twist slightly to remove the cargo compartment carpet through the tailgate opening Remove the cargo compartment carpet. M8503482 12 Press the centres of the clips at the lower edge of the foldable side panel on the left-hand side until a click is heard Remove the two clips Remove the plastic nut at the front lower edge of the side panel. M8902133 Page 9 / 17
13 Remove: the clips (1) in the left front side panel in the cargo compartment the panel. Place the panel to one side. M8503515 14 Remove the cable (1) between the GPS antenna on the parcel shelf and the foremost of the three upper sockets in the upper sockets in the RTI control module Place the cable to one side. The amplifier will not be reused. A new cable harness is in the kit. M3702459 Page 10 / 17
15 Route the new cable harness (1) in the same way as the old harness Position the connectors for the cable harness at the C-posts and at the rear edge of the wheel house. See the illustration Press the cable harness into place in the parcel shelf with the existing clips Connect the connector to the GPS antenna. M3702460 16 Applies to Japan Remove the ground lead for the rear windshield. First remove the screw (1). Remove the connector (2) from the rear windshield at the right-hand C-post Place the ground lead and the screw to one side. They will not be reused. Applies to Europe Remove the screw (1). Remove the ground lead from the C-post. A new screw is included in the kit. M3702461 Page 11 / 17
17 Remove the cables (1, 2) for the existing antenna amplifier on the left C-post Remove the screw (3) and remove the antenna amplifier Place the antenna amplifier to one side. The amplifier will not be reused. M3702462 18 Connect the new TV antenna amplifier (blue) to the new AM/FM antenna amplifier (blue) from the kit. Applies to Japan Carry out the same operation with the green antenna amplifiers. Applies to Europe For the EU only use the small green TV antenna amplifier. M3903366 Page 12 / 17
19A Applies to Japan Install the new AM/MPX and TV antenna amplifiers (green) on the right C-post. Ensure that the antenna amplifier guide lugs engage in the two rectangular holes and in the small round holes Tighten the amplifiers Repeat the operation for the left-hand AM/FM and TV antenna amplifier (blue). Applies to Europe 19B M3903367 Install the small green TV antenna amplifier for the right hand C post in the rear position with the ground lead cable terminal on top. Tighten the antenna amplifier Ensure that the amplifier guide lugs are in their relevant holes Repeat the operation for the left-hand AM/FM and TV antenna amplifier (blue). M3702548 20 Reinstall the cables (1) (that were removed earlier) in the front antenna amplifier on the left C-post Connect the two single cables (2) (that were routed earlier) to the rear antenna amplifier on the left C-post Connect the cables (3, 4, 5) to the connectors on the rear windshield as illustrated. M3903368 Page 13 / 17
21A Applies to Japan Connect the two single cables (1) (that were routed earlier) to the rearmost of the two amplifiers on the right C-post Connect the cables (2, 3, 4) to the connectors on the rear windshield as illustrated. Applies to Europe Connect the single cable (1) (previously routed) to the front terminal in the TV antenna amplifier on the right C-post as illustrated Connect the cables (2) to the connectors on the rear windshield as illustrated. 21B M3702463 M3702547 Page 14 / 17
22 Clamp the cables on the parcel shelf, at the C-post and at the lead-in to the cargo compartment. See the arrows in the illustration. M3903369 23 Remove the three screws (1) holding the CD ROM changer and bracket at the body Lift up the unit and place it on the left rear side member. M3903370 Page 15 / 17
24 Take the TV tuner (1) and the three screws (2) from the kit. Tighten the TV tuner on the reverse of the bracket for the CD ROM changer Connect the cable harness (3) with the green connector and the new DIN cable (4) to the TV tuner Reinstall the CD ROM changer and the TV tuner. M3903371 25 Connect the two cables (1) from the TV tuner to the RTI control module Connect the two cables (2) routed from the parcel shelf to the TV tuner Connect the cable (3) from the parcel shelf to the RTI control module Clamp the cables with a tie strap (4) from the kit. M3903372 26 Reinstall: the parcel shelf panel the C-post panels the side cushions the backrests the seat cushion the panels in the cargo compartment. Page 16 / 17
27 Turn the ignition key to position II Reconnect the battery negative lead Re-position the cargo compartment carpet Program the software according to the service information in VIDA. A8800137 Page 17 / 17