PB000 series SPECIFICATION MODEL OUTPUT INPUT PROTECTION FUNCTION ENVIRONMENT SAFETY & EMC (Note ) OTHERS NOTE BOOST CHARGE VOLTAGE FLOAT CHARGE VOLTAGE OUTPUT CURRENT RECOMMENDED BATTERY 00 ~ 600Ah CAPACITY(AMP HOURS)(Note 3) BATTERY TYPE LEAKAGE CURRENT FROM BATTERY (Typ.) VOLTAGE RANGE FREQUENCY RANGE EFFICIENCY (Typ.) AC CURRENT (Typ.) INRUSH CURRENT (Typ.) LEAKAGE CURRENT OVER VOLTAGE OVER TEMPERATURE SHORT CIRCUIT REVERSE POLARITY REMOTE CONTROL BATTER BANKS FAST CHARGE CHARGER OK WORKING TEMP. WORKING HUMIDITY STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE ISOLATION RESISTANCE EMC EMISSION PB000 PB0004 PB00048 4.4V 8.8V 57.6V 3.8V Open & Sealed Lead Acid <ma 0 ~ 64VAC 7 ~ 370VDC 47 ~ 63Hz 7.6V 55.V 34.7A 7.4A 0 ~ 350Ah 60 ~ 75Ah 85% 88% 8% A/5VAC 5A/5VAC <3.5mA / 40VAC 5.A/30VAC 50A/30VAC 6 ~ 8V 3 ~ 35V 64.5 ~ 6.5V Protection type : Shut down o/p voltage, repower on to recov er 80 ± 5 (V), 85 ± 5 (4V,48V) (TSW: detect on heatsink of power transistor) 85 ± 5 (V),75 ± 5 (4V,48V) (TSW : detect on heatsink of o/p diode) Protection type : Shut down o/p voltage, recovers automatically after temperature goes down YES, protected by internal circuit YES, protected by internal circuit OUTPUT OK Relay contact rating(max.): 30V/A resistive ; "Short" when the battery is full, "Open" when the battery is still charging TEMPERATURE COMPENSATION By NTC, compensate both banks at the same time 0 ~ 60 (Refer to "Derating Curve") 0 ~ 0% RH noncondensing 40 ~ 85, 0 ~ 5% RH ± 0.05%/ (0 ~ 50 ) 0 ~ 500Hz, G 0min./cycle, 60min. each along X, Y, Z axes UL6050, TUV EN6050 approved I/PO/P:3KVAC I/PFG:KVAC O/PFG:0.5KVAC I/PO/P, I/PFG, O/P FG:00M Ohms / 500VDC / 5 / 70% RH Compliance to EN550 (CISPR), EN60003,3 Compliance to EN60004,3,4,5,6,8,, EN5504, light industry level, criteria A MTBF 7.4K hrs min. MILHDBK7F (5 ) DIMENSION 300*84*70mm(L*W*H) PACKING 60A POWER FACTOR (Typ.) 0.5/30VAC 0.8/5VAC at full load EMC IMMUNITY Open: Normal work banks (A & B) / 3 / 8 stage selectable 3.5Kg; 4pcs/5Kg/.83CUFT Short: Stop Relay contact rating(max.): 30V/A resistive ; "Short" when the unit is working properly, "Open"when the unit is failure or the protection function is activating File Name:PB000SPEC 030805
PB000 series Mechanical Specification Case No. 804B Unit:mm 300 70 55 7.6 A 7 Air flow direction 4 8 6.5 A Control Pin No. Assignment() : HRS DF0DPDS or equivalent Pin No. Assignment Pin No., RY3 8 3,4 5,6 7 0 RY3 : Bank A OK : Bank B OK : Charger OK Assignment NTC(5K Ω) RC RC Mating Housing NTC / : Temperature sense RC / RC: Remote ON/OFF Terminal HRS DF0DS HRS DF**SC or equivalent or equivalent Curve Stage 3 Stage Start Charge Voltage Vboost Start Cha rge Voltage Vboost Vfloat 00% 00% Charge Current Constant Current Constant Voltage 0% Cha rge Current Constant Current Constant Voltage Flo at 0% stage stage Battery Full stage stage stage 3 Color of LED Color of LED File Name:PB000SPEC 030805
PB000 series 8 Stage Pulse Soft Start Constant Current Constant Voltage Analysis Recondition Float Maintain Charge Voltage Charge Current stage stage stage 3 stage 4 stage 5 stage 6 stage 7 stage 8 Color of LED Block Diagram PFC : 5KHz PWM fosc : 60KHz I/P EMI FILTER ACTIVE INRUSH CURRENT LIMITING RECTIFIER & PFC POWER SWITCHING RECTIFIER & FILTER BANKA (V) BANK B (V) PFC CONTROL AUX POWER PWM CONTROL FAN OTP CURRENT DETECTION MCU RE VERSE DETECTION /8 STAGE SELECT REMOTE CONTROL RC Bank A OK RY3 Bank B OK Charger OK Derating Curve The Function of LEDs 00 Status Col or Red Steady Fail Flashing 80 60 Full 40 0 0 0 0 0 30 40 50 60 70 (HORIZONTAL) AMBIENT TEMPERATURE ( ) File Name:PB000SPEC 030805
PB000 series Function Description of Pin No. Function Description, 3,4 5,6 RY3 Relay contact rating(max.) : 30V/A resistive. ; "Short" when the battery A is full, "Open" when the battery A is still charging. Relay contact rating(max.) : 30V/A resistive. ; "Short" when the battery B is full, "Open" when the battery B is still charging. Relay contact rating(max.) : 30V/A resistive. ; "Short" when the unit is working properly, "Open" when the unit is failure or the protection function is activating. 7,8,0 Temperature sensor comes along with the charger can be connected to the unit to allow temperature compensation of the / charging voltage. If the temperature sensor is not used, the charger still works normally. Turn the output on and off by electrical or dry contact between pin 0 (RC) and pin (RC), "Open" : Normal work, RC / RC "Short" : Stop charging Function Manual.Remote Control The charger can be turned ON/OFF by using the "Remote Control" function. Between RC(pin0) and RC(pin) Charger SW Open ON SW Short OFF RY3 RY3 RC 0 RC SW.Two anks The charger may be hooked up two battery banks (A and/or B). Connect the battery bank(s) as below. If you are connecting battery banks in the same time, keep in mind that they must share a common ground. Stage 8/3 / File Name:PB000SPEC 030805
PB000 series 3.,3, or 8 stage Select () The charger features user selectable,3, or 8 stage charging. The charging profile is selected by moving the slide switch on the back panel. Switch mode RY3 RY3 Right stage charging Middle 3 stage charging Stage 8 /3/ Left 8 stage charging () Please choose the "3 stage" selection when the charger is used to charge the batteries and power the loads in the same time. RC RC 0 4.Charger OK Relay() Charger Between pin5 and pin6() RY3 RY3 Normal work Failure or the protection function is activating ON (Short) OFF (Open) Stage 8 /3/ RC RC 0 5.Output OK Relay(RY3 & ).Bank A OK (RY3) Bank A Between pin and pin(ry3) Color of LED A RY3 RY3 Full ON (Short) OFF (Open).Bank B OK () Bank B Between pin3 and pin4() Color of LED B Full ON (Short) RC RC 0 OFF (Open) RY3 6.Temperature Compensation Temperature sensor comes along with the charger can be connec ted to the unit to allow temperature compensation of the charging voltage. If the temperature sensor is not used, the charger still works normally. RY3 RY3 RC RC 0 NTC The temperature sensor can either be attached to the battery or placed in its surrounding environment. File Name:PB000SPEC 030805
Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Mean Well: PB00048 PB0004 PB000